Trouble shooting guide Problem No liquid flowing from the tank Handle sliding up & down Liquid leaking at the head No spring action in trigger Solution Make sure the handle is fully extended and the collar is locked in position. This will allow the control valve to operate correctly Ensure the collar at the bottom of the handle is securely tightened. Unlock the handle, slide the handle to its original position, then fully extend the handle and re-lock. You should now be able to feel a spring pressure on the trigger. Make sure the handle is fully extended (to engage the trigger) and the collar is locked in position. You should now feel a spring loaded action when operating the trigger Carpet Shampooer Model 250 Spares and Consumables 500ml bottle of Carpet Shampoo ­ Order pt no 0021000 Replacement rollers ­ Order pt no 7025500 Other products in the Ewbank range 575 Multisweep floor sweeper with 4 height settings 555 Deepsweep floor sweeper 950- 3 in 1 cordless vacuum with large & small power brush Visit www.earlex.com This product is guaranteed for a period of 12 months against faulty materials and workmanship. While every possible care is taken by Earlex to ensure that our products leave the factory in good working order, Earlex cannot under any circumstances accept liability for problems or damage caused by their subsequent use. It is the responsibility of the user to ensure the surfaces to be treated or cleaned are suitable. This guarantee does not affect your statutory rights. This guarantee excludes the use for rental. In the event of a fault occurring please contact our helpline before returning the unit to our Service Department at the address on the front of this manual together with a copy of your purchase receipt. All repairs will be dealt with speedily. Some States do not allow limitations on how long an implied warranty lasts and some States do not allow the exclusion or limitation of incidental or consequential damages, so part or all of the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from State to State. Care and Use Instructions Thank you for buying the Ewbank 250 carpet shampoo applicator. This versatile system can be used all around the home, car, or mobile home. We are confident that you will be highly satisfied with your purchase and if you have any questions please do not hesitate to contact us on 888-783 2612 Ewbank products are distributed by Earlex Inc, 8261 Hyw 73, Ste F, Stanley, NC 28164, USA. Tel 704 827 7889 Fax 704 827 7849 email enquiries@earlex.com www.earlex.com To order spares and accessories please contact: 800 252 1288 For technical questions please contact: 888-783 2612 Instruction Leaflet for the Carpet Shampooer Making The Carpet Shampooer Ready for Use · · Make sure the collar at the bottom of the handle section is loose, see fig 1A. Fully extend the handle (to engage the trigger). Securely tighten the collar to lock the handle in position and operate the trigger, see fig 1B. You should feel a spring loaded action. This spring operates the release valve. Your shampooer is now ready for use. NOTE: If the collar is not securely tightened the handle may move causing the trigger to disengage. · Preparing the carpet · · Vacuum the carpet to remove surface debris before applying the foam shampoo. It is advisable to test the carpet for color fastness prior to use. To do this, mix a little of the foam shampoo liquid to the specified dilution, apply to a clean cloth and then clean a small area of carpet, ideally one which is normally hidden from view. Shampooing · Mix the foam shampoo liquid to the specified dilution. We recommend the use of Ewbank Carpet Shampoo pt no 021000 for best results. Remove the filler plug, pour in the solution and then replace the filler plug, see fig 2. Pulling the trigger will release the solution onto the foam roller. Use the trigger sparingly and DO NOT OVER WET the carpet, see fig 3. Clean the carpet using short overlapping strokes. After use, allow the carpet to dry thoroughly then vacuum to remove the deposits lifted by the foam shampoo. · · · Cleaning the Carpet Shampooer · After use, pour out any unused solution and clean by rinsing out the tank with a small amount clean water. Pull the trigger a number of times to run the clean water through the system. Clean the head by rinsing the roller and brushes under running water. The shampooer must be thoroughly clean and dry before storing. If necessary you can remove the roller and brush head assembly for cleaning. Do this by inserting a screw driver between the main moulding and brush rocker arm and gently lifting out, see fig 4 For directions to reassemble the roller and brush head assembly, see fig 5. · · ...