User manual EARLEX CORDLESS VACUUM 950

Important battery information A rechargeable battery is fitted to this appliance. Under normal usage the excepted battery life is 12 months. It is very important that you follow the recharging instructions or this could seriously reduce the life of the battery. When the operation time of your Ewbank 123 begins to reduce and the appliance sounds `laboured' it is probably time to replace the battery Recharging · Firmly position the charger plug into the recharging jack on the handheld unit. The Ewbank 123 can be recharged with the handheld unit in or out of the base unit. The on/off switch should be in the `off' position while charging the unit. It is very important to always fully charge the battery after every use so that it will be ready and fully charged for your next cleaning. Note: The product can remain on charge indefinitely. This will in no way affect the power or the life of the battery. While charging, the charger will become warm however, this is no cause for concern. The red charging indicator light will illuminate when the battery is on charge and will remain `'on' while the charging unit is plugged-in. If the red light does not illuminate, please check that the charger is firmly positioned into both the jack and wall socket. Note: It is recommended to fully recharge the battery after every use. Leaving the battery discharged for long periods may result in damage. · · · Removing and replacing the battery · · · · · There are two latches in the battery door on the underside of the handheld unit. To remove the battery, slide both latches backwards and lift up the battery door. Remove the battery from the motor housing. Hold the plastic cover of the connector by the narrow end, pull out the connector. Plug the connectors into the new battery making sure that the RED wire is connected to the battery pole marked RED. When replacing the battery in the motor housing, the wires must be inserted first and the battery fitted with the connectors positioned towards the end of the unit. Cordless vacuum Model 950 This product is guaranteed for a period of 12 months against faulty materials and workmanship. While every possible care is taken by Earlex to ensure that our products leave the factory in good working order, Earlex cannot under any circumstances accept liability for problems or damage caused by their subsequent use. It is the responsibility of the user to ensure the surfaces to be treated or cleaned are suitable. This guarantee does not affect your statutory rights. This guarantee excludes the use for rental. In the event of a fault occurring please contact our helpline before returning the unit to our Service Department at the address on the front of this manual together with a copy of your purchase receipt. All repairs will be dealt with speedily. Some States do not allow limitations on how long an implied warranty lasts and some States do not allow the exclusion or limitation of incidental or consequential damages, so part or all of the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from State to State. Care and Use Instructions Thank you for buying the Ewbank 123 cordless vacuum. This versatile 3-1 vacuum system can be used all around the home, car, or mobile home. We are confident that you will be highly satisfied with your purchase and if you have any questions please do not hesitate to contact us on 888-783 2612 Ewbank products are distributed by Earlex Inc, 8261 Hyw 73, Ste F, Stanley, NC 28164, USA. Tel 704 827 7889 Fax 704 827 7849 email enquiries@earlex.com www.earlex.com To order spares and accessories please contact: 800 252 1288 For technical questions please contact: 888-783 2612 05/05 · · for a minimum of 16 hours to ensure the battery is fully charged. Ensure the switch is in the `off' position during charging Upright mode for cleaning floors and carpets The Ewbank 123 features a 3 position switch. The upper position turns the unit off, the central position vacuums only hard surfaces and the lowest position activates the powerbrush heads for carpet cleaning. Remove the charger plug from the vacuum cleaner. To extend the handle twist at the top and pull out to a suitable length, then turn the handle until it is locked in position. (fig 1) · · Cleaning the filter and the dust compartment · · · · · · Always switch off before opening the dust compartment. Press the release button and detach the dust compartment (fig 2). Remove the filter from the dust compartment and empty the contents (figs 3). A damp cloth can be used to clean the inside of the dust compartment. Brush away any dirt from the filter. The filter can be washed in warm soapy water. Important: The filter must be dry before replacing it into the dust compartment. Ensure the filter is correctly fitted before further use. Maximum dust collection will only be obtained with a clean filter and empty dust compartment. Safety precautions · · · · · · · · · Read all instructions carefully before using the appliance. Never use the appliance without the filter fitted. Only use the charger provided. For best performance, keep the appliance and the filter clean and replace the filter if damaged. Do not use to vacuum flammable or corrosive liquids. Do not use in areas where such liquids or gasses might occur. Do not vacuum solvent based products. Cleaning the brush and belt · · Always switch off before cleaning the rotating brush. Regularly inspect and remove hair and fibres from the brush. To clean the brush and belt more thoroughly, follow the steps below:- The large powerbrush · · · · · · · · Detach the large powerbrush from the base unit, slide back the side catches, and lift off the brush cover (fig 4). Remove the brush from the belt. After cleaning, reverse these steps to reassemble. Detach the small powerbrush from the hand held unit. Remove the four screws on the bottom with a Philips screwdriver (fig 5) and remove the base. Lift out the brush together with the bearings. After cleaning, reverse these steps to reassemble. The motor is not fixed with a screw and must be replaced in the correct position during reassembly. Operation To install large powerbrush, simply insert the pipe into the inlet socket at the bottom of the base unit making sure the button `clicks' into the retaining hole. To remove, press the lock button and pull off the unit (fig a). The Ewbank 123 is supplied with a crevice tool (fig b) which makes cleaning in narrow and hard to reach places more convenient. After use this accessory can be stored in a separate compartment in the base unit. The small powerbrush may be attached to the nose of the base unit (fig c) giving greater cleaning efficiency in the handheld mode. The small powerbrush · Getting started · 05/05 Before using the Ewbank 123 for the first time, it will need charging