OWNER'S MANUAL AVN2227P In-Car Audio Visual Navigation We appreciate your purchase of this receiver. Please read through this manual for correct operation. We suggest that after reading it you keep this manual in a safe place for future reference. For your safety when using the AVN2227P Warnings and caution notices, illustrated below, are posted throughout this manual as well as on the AVN2227P. They show the safe and correct ways to handle the product so as to prevent personal injury to you and others, and to avoid property damage. Before reading through the manual, take the time to read through this section and familiarise yourself with the important information it contains. Warning Caution This notice indicates a situation in which incorrect handling or failure to observe the notice might result in death or serious personal injury. This notice indicates a situation in which incorrect handling or failure to observe the notice might result in personal injury or may result solely in damage to property. Please read all material, such as manuals and warranties, that has come with the product. Eclipse will not be liable for unsatisfactory product performance due to failure to follow these instructions. Do not modify this system for any use other than that specified herein. Also, do not deviate from the installation procedures described herein; Eclipse will not be held liable for damage including, but not limited to, serious injury, death or property damage resulting from installations that enable unintended operation. This main unit requires 12V DC and should only be installed in a vehicle with a 12V negative ground electrical system. Any other installation may cause a fire or other severe damage to the main unit and the vehicle. Never install this main unit where it will interfere with the safe operation of the vehicle. Never block the drivers' view. Do not install the main unit where it may interfere with the operation of the brakes, the steering or any safety unit, including seat belts and air bags. Before drilling holes in a vehicle for installation, you must confirm the locations of pipes, tanks, electrical wiring, and other vehicle systems and components to ensure that there will be no interference or contact. You must also implement rust prevention and leak prevention measures in the drilling area. Otherwise, fire or electric shock could occur. When installing the main unit do not remove or alter the existing vehicle fasteners, including nuts, bolts, screws, clips, and fittings. Never detach, move or alter existing vehicle wiring, including electrical grounds and straps. Alteration of existing vehicle components may make the vehicle unsafe to operate. Before installation, remove the negative (-) battery terminal to prevent shocks, electrical arcing, fires, and damage to vehicle wiring and the main unit you are installing. Secure wiring with tape or plastic ties so that wires do not interfere with vehicle operation, including the brake pedal, gear lever and steering. Position wires so that they will not be rubbed, abraded, or damaged by moving vehicle components, including power seats. To avoid main unit and vehicle damage, including fire, never supply power to an installed main unit in a way that will overload the capacity of an existing vehicle circuit. Never leave a power supply wire or connection uninsulated. Always install supplied fuses, circuit breakers, and relays. Air bags are vital safety devices. Never install a main unit in a way that will alter air bag wiring or interfere with air bag deployment. Air bags must function properly in the event of an accident. When installation is complete, test all vehicle electrical systems for proper operation, including the lights, horn, brake lights, and emergency flashers. For your protection, never use a power drill without safety glasses or goggles. Debris or broken drill bits may cause severe eye injuries, including blindness. Use electrical tape to insulate the ends of all wires, even if they are not used. Proper insulation prevents arcs, electric shocks and fires. Some main units use batteries. Never install main units where young children can get access to batteries. If a battery is swallowed, seek medical attention immediately. When the vehicle is moving, never take your eyes off the road to make adjustments to the main unit. You must pay attention to the road to avoid accidents. Do not let the operation or adjustment of the main unit distract you from proper vehicle operation. The driver should not look at the screen while driving. Accidents may result if you are not paying attention to the road ahead. WARNING Do not put foreign objects in the disc loading slot or USB input terminal. Fires or electric shocks may result. Do not disassemble or alter this main unit. Accidents, fires or shocks may result. Do not let water or foreign objects enter the internal parts of this main unit. Smoke generation, fires or electric shocks may result. Do not use the main unit when it is broken (the screen is not lit or no sound comes out). Accidents, fires or electric shocks may result. Always replace fuses with fuses of identical capacity and characteristics. Never use a fuse of a higher capacity than the original. Using the wrong type of fuse may cause a fire or severe damage. If a foreign object or water enters the main unit, smoke comes out, or there is a strange odour, stop using it immediately, and contact your dealer. Accidents, fires, or electric shocks may result if you continue to use it in these conditions. The driver should not change the CD or USB memory while driving, as accidents may result if you are not paying attention to the road ahead. First stop the car at a safe location and then proceed. Plastic bags and wrappings may cause suffocation and death. Keep away from babies and children. Never put bag over your head or mouth. WARNING Wiring and installing this main unit requires expertise and experience. Professional installation is recommended. Consult your dealer or a professional installer. Incorrect wiring may damage the main unit or interfere with safe vehicle operation. Use only the accessory parts specified. Using other parts may cause damage to the main unit or cause parts to fall or fly off the main unit. Do not install the main unit in places where it may get dew condensation on it (around the air conditioning hose, etc.), come into contact with water, or in conditions of high moisture, dust or oily smoke. If water, moisture, dust or oily smoke enters this main unit, smoke generation, fires or malfunctions may result. Avoid installing the main unit in places where it cannot be fastened securely or where there are strong vibrations. Also, if you are going to install the main unit with double-sided tape, first wipe away dirt and wax from the installation area. Otherwise, the main unit may come loose due to vibration while driving, interfering with driving and resulting in traffic accidents or injuries. Do not install the main unit in places exposed to direct sunlight or where it will be hit directly by hot air from the heater. This may increase the temperature of the interior of the main unit, resulting in fires and malfunctions. Do not block the fan, heat sink or vents of this main unit. When a fan, heat sink or vent is blocked, the interior overheats, and fires may result. Connect the main unit as specified in the installation manual. If it is not connected normally, fires or accidents may result. When installing in vehicles equipped with air bags, check the manufacturer's cautions regarding operation before starting operation. Otherwise the airbags may not operate properly. Carry out the wiring such that cables are not pinched by movable parts such as seat rails, and screw parts of the vehicle body. Accidents, fires and electric shocks may result from disconnection and electrical shorts. Carry out the wiring such that the cables do not make contact with metal parts. The cables may be damaged by contact with metal parts, resulting in fire and electric shocks. Avoid hot surfaces when wiring the main unit. High temperatures may damage wiring, causing shorts, arcing and fires. When changing the installation location for this main unit, please consult the dealer where you bought it for safety reasons. Expertise is necessary for removal and installation. Keep the volume to a reasonable level so that you can hear sounds from outside the vehicle, including warning sounds, voices, and sirens. Failure to do so may cause an accident. Take care that your hands and fingers are not pinched when adjusting the tilting angle or closing the display. Injuries may result. Do not put your hands or fingers into the disc loading slot or USB input terminal. Injuries may result. CAUTION Do not touch the heat dissipating part of the amplifier. Burns may result from the heat of this part. If alkaline solution from alkaline dry batteries makes contact with your skin or clothes, flush clean with water. If any of the solution gets in your eyes, also flush clean with water and then seek medical attention. When disposing of lithium dry batteries, affix insulating tape to the positive and negative terminals, and after they are insulated, dispose of them according to the local municipal ordinances. Shorts, fires and ruptures may result from disposal if the terminals come into contact with other electrically conductive objects such as metal parts, etc. Do not short, disassemble or heat the batteries, or place them in fire or water. Fire and injuries may result from battery rupture and leakage. Do not use this main unit except for in-vehicle use. Electric shocks or injuries may result. Be careful about the position of the volume control when turning the power source ON. Hearing damage may result if a very loud noise is emitted when the power is turned ON. Do not operate under abnormal conditions such as when the sound is broken or distorted. Fires may result. This main unit uses invisible laser light. Do not disassemble or alter this main unit. If trouble occurs, contact the dealer where you bought the main unit. Altering this main unit may cause exposure to laser emissions (impairing eyesight), or result in accidents, fires or electric shocks. If the main unit is dropped or the cosmetics appear broken, turn off the power to the main unit and contact your dealer. If it is used in this condition, fires or electric shocks may result. Using the vehicle speed pulse signal, you can use the route guidance function even in locations where usually no guidance is given (for example: in a tunnel). However, the accuracy of the guidance is not guaranteed since the guidance is based on information about the road surface condition and vehicle speed. Precautions for PND Operation Do not remove the SD card while operating the PND. Turn off the power to the PND, and wait at least 3 seconds after the display goes off, before removing the SD card. Failure to do so may cause data in the SD card to be lost or damaged. A CLASS 1 LASER PRODUCT label is affixed to the top of this unit. CAUTION In accordance with the European Directive 2002/96/EC (for Waste Electric and Electronic Equipment=WEEE), this product, which is labeled with a crossed-out wheeled bin, may not be disposed of with household waste in member states of the EU. WEEE : Waste Electrical and Electronic Equipment When disposing of this product in an EU member state, dispose of it properly in accordance with the laws of that state, for example by returning it to the distributor. WEEE has potential effects on the environment and human health as a result of the presence of hazardous substances. You can help to eliminate these effects and to enhance reuse/recycling/ other forms of recovery by your cooperation. Operating Precautions Notes on Operation · For your safety, play only at moderate volumes so that you can still hear exterior sounds. · Discs with the logo shown to the left can be played. · You can play music CDs (CD-R/CD-RW) on this player. Be sure to use discs that have been properly processed. Depending on the editing format and software used, some discs may not play properly. TEXT · Do not insert anything other than a CD into the main unit. Do not insert any foreign objects, such as coins or credit cards, into the disc slot. · Avoid severe mechanical shock. When the player is subjected to severe vibration while traveling over a rough surface, playback may be intermittent. When a situation like this occurs, resume playback after returning to a smoother road. · About dew condensation. In cold or rainy weather, just as the interior glass surface gets fogged, dew (water condensation) may also settle on the main unit. When this happens, disc playback may become intermittent or impossible. Dehumidify t ...