User manual EPSON LX-810 - SUPPORT BULLETIN

Product Support Bulletin Subject: Power Specifications PSB No: P-0060 Originator: RFB Date: 2/7/90 Page: 1 of 2 The following information is a list of the power requirements for the Epson 9 and 24 pin printers and laser printers. 504 VA maximum PSB No: P-0060 Page: 2 of 2 Max. Current 1 Voltage 1 Consumption 1 Power Consumption 1 BTU/HR 1 120V 120V 120V .7 Amp 1.0 Amp .7 Amp 84 VA maximum 120 VA maximum 84 VA maximum I 286.69 409.56 286.69 Product LX810 T750 T1OOO If the power requirements of a particular Epson printer is not listed please refer to the appropriate User's Manual for the electrical specifications. In the event that the User's Manual is not available, locate the silver label on the back of the Epson printer. This is a reliable source for the electrical requirements. The following formula is used to calculate the electrical power requirements: VOLTAMPS VOLTAMPS AMPS BTU/HR Example: 120V * 1A = 120VA 120VA/120V = 1A 120VA is equivalent to 120W 120W * 3.413 = 409.56 BTU/HR Heat output is rated in BTU/HR. is equivalent to WATTS = Volts * Amps = Voltamps/Volts = Watts * 3.413 EPSON 8?801 AYLRICA, INC. 8.rvl.0 0lvl.1.r PRODUCT SUPPORT BULLETIN DATE: 04/24/87 SUBJECT: FX-86e/286e PAPER DETECTION The following information should clarify how the FX-86e/286e paper detection and auto load system operate. The key to paper detection is that the paper empty light and the beeper will not activate unless there is an attempt to transmit data to the printer. See examples below. * If there is a FF which ejects a single sheet of paper or the last sheet of a continuous form, the paper out indicator will not turn on and the beeper will not beep until there is an attempt to transmit data to the printer. * If the FF was sent by software, the printer will remain on line until there is an attempt to transmit data to the printer. The key to the auto load system is that the printer must be off line to operate. * To use the auto load feature under the above circumstance, the printer must first be manually taken off line, then the paper bail lever should be pulled to load the sheet, then press ON LINE to continue printing. NUMBER: P-0004