OWNER'S MANUAL FOLD AND ROLL PLAYBACK TABLE TENNIS TABLE Patent No. 5816957 MODEL NOs. T8278 Thank you for buying our product. We try hard to ensure that our products are of high quality and free of problems, such as manufacturing defects or missing parts. However, if you have any problems with your new product, please DO NOT RETURN IT TO THE STORE!. DO NOT RETURN THIS PRODUCT TO THE STORE! Call us at: (THIS IS A CONSUMER ONLY NUMBER) Please have this Owner's Manual with you when you call. Or write us at: CUSTOMER SERVICE DEPT., P.O. Box 889, Evansville, IN 47706 Fax Number: (812) 467-1399. TOLL FREE 1-866-873-3528 Please provide model number and/or part number (not just the key number) of the product and/or part when you call or write. These numbers can be found on the product, packaging, and/or in this Owner's Manual. LIMITED 1 YEAR WARRANTY Manufacturer warrants to the original retail purchaser, this product to be free from defects in material and workmanship for a period of one (1) year from the date of purchase. Should this product become defective due to material or workmanship within the warranty period, contact our Customer Service Department for repair or replacement at our option. WARRANTY This warranty is not transferable and does not cover normal wear and tear, bowing of the table or damage caused by improper handling, installation or use of this product. This warranty is also void if product is in any way abused, damaged, or modified from its original state, or if used for other than residential use. This warranty gives you specific legal rights, and you may have other rights which vary from state to state. CAUTION Actual product may differ slightly from that shown in illustrations. THIS IS A GAME TABLE. DO NOT SIT, STAND, LEAN, WALK OR JUMP ON TABLE! FAILURE TO COMPLY WITH THIS CAUTION COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! This table must be kept indoors to prevent damage to the playing surface. Dampness and extreme temperature changes which occur on patios, garages or similar areas can cause wood to warp, swell, crack, or blister. UNLEVEL FLOORS If table does not seem level, it is probably because floor is not level. Move table several inches (set table in playing position) in different directions to find the best location for the table. If the floor is extremely unlevel, table may not play or operate properly. If table is high in the center, shim up under the outer legs. READ ASSEMBLY & OPERATING INSTRUCTIONS AND ALL SAFETY INFORMATION CAREFULLY! CARE AND MAINTENANCE You have purchased a quality product that will give you years of enjoyment. By following these simple maintenance steps you will add to the life of your new table. The top (playing surface) of your table is of a particle board construction. Like all products made of wood, it can be affected by atmospheric conditions, meaning both temperature and humidity. This may cause a slight sag or distortion as top expands or contracts. This is normal and should not cause concern as it does not detract from the play or utility value of the table. To help minimize this problem, store table in folded up position in a dry area when not in use. STORAGE OF YOUR TABLE This table must be stored indoors to prevent damage to the playing surface. Dampness and extreme temperature changes which occur on patios, garages or similar areas can cause the wood to warp, swell, crack, or blister. When your table is not in use, it should be folded up in a dry area. CLEANING YOUR TABLE To clean your table use a soft damp NOT WET cloth only. To prevent damage to your table's playing surface DO NOT use any chemicals, abrasive, or cleaning products on your table's playing surface. IMPORTANT: Periodically, lubricate all moving parts, including pivot points, to assure smooth opening and closing. A light lubricant such as WD-40 is recommended. © 2001 Escalade Sports 1 TABLE TENNIS WARRANTY CENTER, P.O. BOX 889, EVANSVILLE, IN 47706-889 2L-6666-00 READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO (2) ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER! 1. Attach wood bottom board (#2) to caster rails (#1) as shown in Figure 1. Turn caster rail as shown with pivot tubes toward inside, and attach board (#2) with four carriage bolts (#3) and four wing nuts (#4). Tighten wing nuts securely. Figure 1 Figure 2 PIVOT TUBES MUST FACE INWARD AND POINT STRAIGHT UP AS SHOWN! AT LEAST TWO (2) ADULTS ARE NEEDED TO COMPLETE THE REST OF THIS ASSEMBLY! WHEN ASSEMBLING TOPS TO BASE, HANDLE TOP ASSEMBLIES BY GRASPING ONLY THE TOPS THEMSELVES. DO NOT GRASP METAL LEGS, U-SUPPORT, LINKAGE, OR HINGES. THESE PARTS CAN MOVE AND COULD PINCH FINGERS OR HANDS CAUSING SERIOUS INJURY! ASSEMBLE AS SHOWN WITH LEGS FULLY CLOSED AND TOPS IN A VERTICAL POSITION. DO NOT OPEN LEGS AND TRY TO ASSEMBLE. TABLE TOPS ARE HEAVY - DO NOT ATTEMPT TO ASSEMBLE ALONE! 2. Attach table top (#5) to table base that you just assembled, as shown in Figure 2. With at least one adult on each side of table top (#5), lift top and align ends of "U"-support tube with top of pivot tubes on caster rails (#1). Slide tubes together. With two adults, put other table top onto other pivot tubes following instructions in step 2. 3. DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL BOTH TOPS ARE INSTALLED! DO NOT LEAVE TABLE STANDING UNATTENDED. IT COULD BE KNOCKED OVER CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE. 4. 2 Attach corner protectors (#31) to rails using tree plugs (#22). Simply push the plugs through the protector and into the rail until snug. OPENING AND CLOSING INSTRUCTIONS CAUTION: EXERCISE CAUTION IN OPENING/CLOSING TABLE. SMALL CHILDREN, OR CHILDREN NOT PROPERLY INSTRUCTED IN ITS USE, MUST NOT BE ALLOWED TO OPEN/CLOSE TABLE. IMPROPER HANDLING AND MISUSE CAN RESULT IN SERIOUS INJURY OR DAMAGE. DO NOT CLIMB, STAND, OR JUMP ON TABLE. MOISTURE AND CONDENSATION WILL DAMAGE PLAYING SURFACE OF THIS TABLE. STORE IN DRY, INDOOR PLACE. TO OPEN: 1. Open legs on one table half and lock both leg hinges. 2. Hold center of top edge. Gently pull outward to midway position. Continue to pull until disengaged from safety clips and legs rest on the floor. Do not leave table partially opened at midway position. See Figure 3. 6. Secure net posts to center of table and slide net down over posts. See Figure 5. Figure 5 TO CLOSE: 1. Remove net and net posts from table. 2. 3. Unlock all four hinges. Lift table half without net posts to midpoint until the safety clips are engaged. Then continue lifting until closed. Unlock leg hinges on this half and fold legs against top. Raise other table half in the same manner. Figure 3 3. 4. 5. Open legs of second table half and lock both hinges as with the first half. Lower second top as described in step 2. Lock all four center hinges. See Figure 4. 4. 5. Figure 6 Figure 4 3 Replacement Parts List for Model Numbers T8278 Key# T8207A Description Qty. Key# T8207A Description 2L-6666-00 Qty. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 4A-6343-00 8S-6421-01 2W-6215-02 1B-6468-00 2B-6082-00 2Q-6093-00 2B-6085-00 2S-6278-01 8S-6418-01 2S-6279-01 701-105 3M-6273-00 4A-6336-00 3B-6013-00 2B-6087-00 501-24 Caster Rail Assembly Caster Rail only Bottom Board 1/4-20 x 2-1/4" Carriage Bolt 1/4-20 Wing Nut 2" Double Wheel Caster 5/16 Palnut RH Pivot Bracket Pivot Tube LH Pivot Bracekt #8 x 9/16 SMS Plastic Clip Hinge / Bracket Assembly 1/4 x 1-3/8 Rivet Nylon Washer 1/4" Palnut 2 2 1 4 4 4 4 2 4 2 126 2 4 4 4 4 16 17 18 19 20 21 22 24 25 26 27 28 29 30 31 2S-6387-02 1A-6323-00 8S-6420-01 4A-6507-00 2S-6143-04 2S-6446-00 3M-6397-00 1A-6322-00 3M-6540-00 501-24 3B-6035-00 704-54 3M-6085-00 5A-6896-00 3M-6393-00 U Clip Leg Assembly - LH U Support Half Top End Rail Side Rail Tree Pulgs Leg Assembly - RH Leg Cap Push Nut 1/4" x 2-3/4 Rivet Spacer 1" Square Tube Plug Net & Post Kit Corner Protector 4 2 2 2 2 4 8 2 4 4 4 4 4 1 4 4 ...