Detailed instructions for use are in the User's Guide.
Help Line
Australia Canada México United States + 1-800-33-11-77 + 1-800-665-4339 + 1-800-234-1185 + 1-800-955-0959
Fellowes
Australia Benelux Canada Deutschland France Italia Japan Korea Malaysia Polska Spain Singapore United Kingdom United States + 61-3-8336-9700 + 31-(0)-76-523-2090 + 1-905-475-6320 + 49-(0)-5131-49770 + 33-(0)-1-30-06-86-80 + 39-071-730041 + 81-(0)-3-5496-2401 + 82-(0)-2-3462-2884 + 60-(0)-35122-1231 + 48-(22)-771-47-40 + 34-91-748-05-01 + 65-6221-3811 + 44-(0)-1302-836836 + 1-630-893-1600
www.fellowes.com
© 2006 Fellowes, Inc. Part No. 401207-D
ENGLISH
Models P-40/P-45C
Paper/credit card entry See safety instructions below Sheet capacity gauge Unlocked (green) Locked (red) Waste opening Handle Control switch Bin
Auto-On (I) Off (O) Reverse (R)
OPERATION
Insert waste bag (Fellowes #36052) for easy disposal.
PAPER
Shredder head
Safety lock
Continuous operation: 5-7 minute maximum NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 5-7 minutes will trigger 20-minute cool down period. Set to Off (O) and plug in
Check paper amount
CARD
Set to Auto-On (I)
Feed into paper entry and release Set to Off (O) and unplug
Set to Auto-On (I)
Hold card at edge
Feed into center of entry and release
Pivoting head Safety flap (Cross-Cut models only)
Safety Lock prevents accidental operation. To set, wait for shredding to stop, push black button down and slide until you see red. To unlock push black button down and slide until you see green. For greater safety, always unplug shredder after use.
Easy emptying
To set lock, push down and slide
TROUBLESHOOTING
Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the below procedures. Shredder doesn't start:
Make sure head is on basket correctly Wait 20 minutes for motor to cool down
CAPABILITIES
Will shred: Paper, credit cards and staples Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, paper clips, laminates or plastic other than noted above Paper shred size: Strip-Cut ............................................................................ 1/4" (6.3mm) Confetti-Cut ..................................................... 5/32" x 2" (3.9 x 50mm) Maximum: Sheets per pass (Strip-Cut P-40)............................................................ 8* Sheets per pass (Confetti-Cut P-45C) ..................................................... 6* Cards per pass ........................................................................................1 Paper width .............................................................................9"/229mm Continuous operation ..............................................................5-7 minutes
* 20lb., 8.5"x11" paper at 120v, 60Hz, 2.0 Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Set to Reverse (R) for 2-3 seconds Alternate slowly back and forth Set to Off (O) and unplug Remove shredder head and cut hanging shreds. Replace shredder head. Plug in. Set to Reverse (R)
Remove and empty basket Make sure safety lock is in unlock (green) position
MAINTENANCE
Follow oiling procedure below and repeat twice.
Confetti-Cut and Strip-Cut: Run regularly in reverse for one minute
IMPORTANT SAFETY INSTRUCTIONS -- Read Before Using!
· Keep away from children and pets. Always unplug or set safety lock when not in use. · Keep foreign objects  gloves, jewelry, clothing, hair, etc. away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object.
· Never use aerosol, petroleum-based or other flammable products on or near shredder. Do not use canned air on shredder. · Do not use if damaged or defective. Do not open shredder head. Do not place near or over heat or water source. · 6 sheets per pass to avoid jams
Confetti-Cut only: Lubricate when bin is full, or immediately, if: · Capacity decreases · Motor sounds different, or Shredder stops running
Set to Off (O)
*Apply oil across entry
Set to Auto-On (I)
Shred one sheet
Set to Reverse (R) for 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container
WARRANTY
LIMITED WARRANTY Fellowes, Inc. ("Fellowes") warrants the cutting blades of the machine to be free from defects in material and workmanship for 3 years from the date of purchase by the original consumer. Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1 year from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.
· Avoid touching exposed blades under Confetti-Cut shredder head.
· The socket-outlet shall be installed near the quipment and shall be easily accessible.
2
3
...