Detailed instructions for use are in the User's Guide.
POWERSHRED P-48C
®
Please read these instructions before use. Do not discard: keep for future reference.
Quality Office Products Since 1917
ENGLISH
Model P-48C
A. B. C. F. G. H. I. J.
D.
KEY
A. Shredder head B. Handle C. Safety lock D. Window E. Bin F. Disconnect power switch G. Paper/card entry H. See safety instructions I. Sheet capacity guage J. Control switch and LEDs I 1. Auto-On (green) O 2. OFF R 3. Reverse 4. Overheat (red)
E.
C. Safety lock
1 5
To set lock, push down and slide
CAPABILITIES
Will shred: Paper, credit cards, paper clips and staples Will not shred: Continuous forms, CD/DVDs, adhesive labels, transparencies, newspaper, cardboard, laminatess, X-rays or plastic other than noted above Paper shred size: Cross-Cut ......................................................................5/32 in. x 2 in. (3.9mm x 50mm) Maximum: Sheets per pass ............................................................................................................. 8* Cards per pass ............................................................................................................... 1* Paper entry width.................................................................................8 3/4 in. (225mm) *8.5 in. x11 in., 20 lb., (75g) paper at 120V/60 Hz, 3.0Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended maximum daily usage rates: 10-20 paper passes; 10 cards. 8 sheets per pass.
IMPORTANT SAFETY INSTRUCTIONS -- Read Before Using!
· Keep away from children and pets. Keep hands away from paper entry.
Always set to off or unplug when not in use.
· This shredder has a Disconnect Power Switch (F) that must be in the ON (I) · Avoid touching exposed cutting blades under shredder head. · Do not put foreign objects in paper entry.
· Keep foreign objects  gloves, jewelry, clothing, hair, etc.  away
15
position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately.
from shredder openings. If object enters top opening, switch to Reverse (R) to back out object. products on or near shredder. Do not use canned air on shredder. not place near or over heat source or water.
15
· Never use aerosol products, petroleum based lubricants or other flammable · Do not use if damaged or defective. Do not disassemble shredder. Do
15
· Shreddermustbepluggedintoaproperlygroundedwalloutletorsocketof the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product.
1
BASIC SHREDDING OPERATION
Insert waste bag (Fellowes #36052) for easy disposal.
PAPER
1
2
3
4
5
15
Continuous operation: 3-5 minute maximum NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 3-5 minutes will trigger a 15-minute cool down period.
Set to Off (O) and plug in
CARD
Check paper amount
Set to Auto-On (I)
Feed into paper entry and release
Set to Off (O)
Safety Lock prevents accidental operation. To set, wait for shredding to stop, push black button down and slide towards front of shredder. To unlock push black button down and slide toward back of shredder. For greater safety, always unplug shredder after use.
1
2
3
4
5
Set to Off (O) and plug in
Set to Auto-On (I)
Hold card at edge
Feed into center of entry and release
Set to Off (O)
TROUBLESHOOTING
Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the below procedures.
1 2 3 4 5 6
Shredder doesn't start: Make sure head is on basket correctly Wait 15 minutes for motor to cool down Remove and empty basket
Set to Reverse (R) for 2-3 seconds
Alternate slowly back and forth
Set to Off (O) and unplug
Gently pull uncut paper from paper entry. Plug in.
Set to Reverse (R)
Make sure safety lock is in unlock position
BASIC PRODUCT MAINTENANCE OILING SHREDDER
All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
2
P-40
3
Set to Off (O)
*Apply oil across entry
Set to Reverse (R) for 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 1 year from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for 3 years from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. The user is responsible for any additional costs incurred by Fellowes in servicing the paper
15
shredder outside of the country where the shredder is initially sold. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.
2
POWERSHRED P-48C
®
Questions or Concerns?
www.fellowes.com
Troubleshooting Registration Manuals Australia Canada Europe Mexico United States
Customer Service & Support
Troubleshooting Replacement parts General questions +1-800-33-11-77 +1-800-665-4339 00-800-1810-1810 +1-800-234-1185 +1-800-955-0959
©2010 Fellowes, Inc. Part No. 405288
...