User manual FENDER JAZZMASTER ULTRALIGHT 112 ENCLOSURE

FENDER ® JAZZMASTER TM ULTRALIGHT LOUDSPEAKER ENCLOSURE Your new JazzmasterTM Ultralight loudspeaker features a Jensen® 12" (30.5 cm) speaker with a neodymium magnet, handling up to 250 watts of power. Designed to complement the Fender® Jazzmaster Ultralight amplifier, the Ultralight speaker cabinet is constructed from quality Italian poplar plywood. Please read these instructions and your amplifier manual before making connections. SPECIFICATIONS PART NUMBER SPEAKER 2277700000 One 12" (30.5 cm) steel frame driver 2" (5.1 cm) voice coil Neodymium magnet 5/8" (1.6 cm) Italian Poplar plywood 98.5 dB, 1 Watt - 1 Meter 250 Watts 2 ohms 4-Pole Speakon® Connector using Pins 1+ and 1­ VB = 0.8 ft3 (38.7 L) 15 1/4 in 15 1/4 in 10 1/4 in 16 lb (7.3 kg) (38.7 cm) (38.7 cm) (26.0 cm) Ultralight Connections To connect the JazzmasterTM Ultralight speaker to an Ultralight amplifier, use the Speakon® cable included with the amplifier. Rotate the Speakon® connector to align it with the input slots, then fully insert the connector. Rotate the connector clockwise until it locks into place. CABINET SENSITIVITY POWER HANDLING IMPEDANCE CONNECTIONS ENCLOSURE VOLUME DIMENSIONS Height: Width: Depth: WEIGHT Disconnecting Slide the locking tab back on the connector while rotating the connector counter-clockwise. Pull the connector out from the input socket. Non-Speakon® Connections If your amplifier does not have a Speakon® speaker output, you will need the appropriate speaker cable or adapter to connect the JazzmasterTM Ultralight loudspeaker. Speaker cable should be 2-conductor, 16­gauge minimum with the Speakon® connector wired: 1+ pin = Positive 1­ pin = Negative Product specifications are subject to change without notice. A PRODUCT OF: FENDER MUSICAL INSTRUMENTS CORPORATION CORONA, CALIFORNIA USA Fender® and JazzmasterTM are trademarks of FMIC. Other trademarks are property of their respective owners. © 2005 FMIC. All rights reserved. P/N 069332 REV A