Vacu-CellTM System Temperature Controller Model TC-30 The Model TC-30 temperature controller is designed to precisely control the temperature of a Vacu-Cell incubation chamber or a Vacu-Cell microscope stage holder. The heater provides a heavily filtered DC output at a maximum power of 30 Watts for noise-free temperature control. A highly visible digital temperature readout indicates either the set-point temperature of the controller or the measured temperature of the sensor probe. The TC-30 is equipped with an adjustable gain control. The gain control is used to adjust the feedback system and the dynamic temperature response of the Vacu-Cell. Although the controller is essentially noise-free, a TTL-controlled inhibit input is also provided. This input control can be used temporarily block power output to the heater element to permit high-sensitivity measurements. A visual "stair case" display is also provided to indicate output power. Included with the Model TC-30 is one cable, to connect the controller to the Vacu-Cell, and one temperature sensor probe (not shown). C&L Instruments, Inc. www.fluorescence.com P OWE R ON (1) 30 OF F (0) 25 MONIT OR A C T UA L OUT P UT S Y S T E M G A IN NOR MA L P OWE R SET 35 40 45 37.0 A NA L OG MONITOR 10mV / C C L OW R UN HIG H INHIB IT 20 C 50 Model TC-30 Temperature Controller S T A NDB Y (T T L HIG H IN) Part Numbers TC-30 Temperature Controller 110-120 or 220-240 VAC (specify on order) C&L Instruments, Inc. www.fluorescence.com 717-564-9491 ...