Turbo Compact For all customer enquiries or for replacement parts, contact:- 01325 300303 www.flymo.com eop.customer.services@electrolux.co.uk Carton Contents start/stop levers upper handle cable clip lower handle washer bolt retaining clip nuts pin electric cable with moulded plug grassbox washer bolt retaining clip cutting height spacers (1 fitted to lawnmower & 2 in loose parts pack spanner/scraper tool handle knobs switchbox grassbox lid pin instruction manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Electrolux Outdoor Products Customer Service Department direct Telephone : 01325 300303 Fax : 01325 318193 Safety If not used properly this lawnmower can be dangerous! This lawnmower can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this lawnmower. The operator is responsible for following the warning and safety instructions in this manual and on the lawnmower. Never use the mower unless the grassbox or guards provided by the manufacturer are in the correct position. Explanation of Symbols on the Turbo Compact Warning Beware of severing toes or hands. Do not put hands or feet near a rotating blade. Read the user instructions carefully to make sure you understand all the controls and what they do. Always keep the lawnmower on the ground when mowing. Tilting or lifting the lawnmower may cause stones to be thrown out Keep bystanders away. Do not mow whilst people especially children or pets are in the mowing area Switch off! Remove plug from mains before adjusting, cleaning or if cable is entangled or damaged. Keep the cable away from the blade. General 1. Never allow children or people unfamiliar with these instructions to use the mower. Local regulations may restrict the age of the operator. 2. Only use the lawnmower in the manner and for the functions described in these instructions. 3. Never operate the lawnmower when you are tired, ill or under the influence of alcohol, drugs or medicine. 4. The operator or user is responsible for accidents or hazards occurring to other people or their property. STOP Blade continues to rotate after the machine is switched off. Wait until all machine components have completely stopped before touching them. Do not mow in the rain or leave the lawnmower outdoors while raining Electrical 1. The British Standards Institute recommend the use of a Residual Current Device (R.C.D.) with a tripping current of not more than 30mA. Even with a R.C.D. installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Check your R.C.D. every time you use it. 2. Before use, examine cable for damage, replace it if there are signs of damage or ageing. 3. Do not use the lawnmower if the electric cables are damaged or worn 4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your mower. 6. Keep cable away from lawnmower, always work away from the power point mowing up and down, never in circles. 7. Do not pull cable around sharp objects. 8. Always switch off at the mains before disconnecting any plug, cable connector or extension cable. 9. Switch off, remove plug from mains and examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only Flymo replacement cable. 10.Always wind cable carefully, avoiding kinking. 11. Never carry the product by the cable. 12.Never pull on the cable to disconnect any of the plugs. 13.Use only on AC mains supply voltage shown on the product rating label. 14.Our products are double insulated to EN60335. Under no circumstance should an earth be connected to any part of the product. Preparation 1. While using your product, always wear substantial footwear and long trousers. 2. Make sure the lawn is clear of sticks, stones, bones, wire and debris; they could be thrown by the blade. 3. Before using the machine and after any impact, check for signs of wear or damage and repair as necessary. 4. Replace worn or damaged blades together with their fixings in sets to preserve balance. Use 1. Use the lawnmower only in daylight or good artificial light. 2. Avoid operating your lawnmower in wet grass, where feasible. 3. Take care in wet grass, you may lose your footing. 4. On slopes, be extra careful of your footing and wear non-slip footwear. 5. Mow across the face of slopes, never up and down. 6. Exercise extreme caution when changing direction on slopes. Walk never run. 7. Mowing on banks and slopes can be dangerous. Do not mow on banks or steep slopes. 8. Do not walk backwards when mowing, you could trip. 9. Never cut grass by pulling the mower towards you. 10.Switch off before pushing the mower over surfaces other than grass. 11. Never operate the lawnmower with damaged guards or without guards in place. 12.Keep hands and feet away from the cutting means at all times and especially when switching on the motor. 13.Do not tilt lawnmower when the motor is running, except when starting and stopping. In this case, do not tilt more than absolutely necessary and lift only the part which is away from the operator. Always ensure that both hands are in the operating position before returning the appliance to the ground. 14.Never pick up or carry a mower when it is operating or still connected to the mains supply. 15.Remove the plug from the mains : - before leaving the mower unattended for any period; - before clearing a blockage; - before checking, cleaning or working on the appliance; - if you hit an object. Do not use your lawnmower until you are sure that the entire lawnmower is in a safe operating condition; - if the lawnmower starts to vibrate abnormally. Check immediately. Excessive vibration can cause injury. Maintenance and storage 1. Keep all nuts, bolts and screws tight to be sure the lawnmower is in safe working condition. 2. Check the grassbox/grassbag frequently for wear or deterioration. 3. Replace worn or damaged parts for safety. 4. Only use the replacement blade, blade bolt, spacer and impeller specified for this product. 5. Be careful during adjustment of the lawnmower to prevent entrapment of the fingers between moving blades and fixed parts of the machine. Cables CABLES IMPORTANT · Use only 1.00mm2 size cable up to 40 metres length maximum. Maximum rating : 1.00mm2 size cable, 10 amps 250 volts AC. · THE TURBO COMPACT IS SUPPLIED WITH AN ELECTRIC MAINS CABLE FITTED WITH A FEMALE CONNECTOR 1. Flymo Mains Cables and Extension Cables are available from your local Electrolux Outdoor Products Approved Service Centre. 2. Do not wire an extension cable directly to your product yourself. Please contact your local Electrolux Outdoor Products Approved Service Centre for further information on the connectors and kits available. 3. Only use extension cables specifically designed for outdoor use. CONNECTORS IMPORTANT · Flymo connectors are suitable for use with 2 core cable only. Under no circumstances should these connectors be used for earthed products. · All Flymo connectors and cables are of splashproof construction. They are not waterproof and must not be left outside permanently nor should they be submerged or immersed in water. Do not let cable lay or trail through pools of water or splashed with water from hose pipes. MAINS PLUG REPLACEMENT IMPORTANT · If the plug supplied is cut off it should be destroyed. There is an electric shock hazard if a cut off plug is inserted into a 13 amp socket. 1. No earth required. Flymo products are double insulated to EN60335 and under no circumstances should an earth be connected to any part of the product. 2. Ensure the mains voltage suits your product 3. IMPORTANT! The wires in the mains lead are coloured in accordance with the following code: BLUE NEUTRAL BROWN LIVE The wire which is coloured BLUE must be connected to the Terminal which is marked with the letter 'N' or coloured BLACK. The wire which is coloured BROWN must be connected to the Terminal which is marked with the letter 'L' or coloured RED. 4. It is important that the outer sheath is clamped correctly into the 3-pin plug. 5. If in doubt consult your local Service Repairer or qualified electrician before the machine is used. 6. A 13 Amp fuse must be fitted to the Mains Plug. 7. The normal plug fuse and household fuse only protect the electrical equipment and are not a safeguard against electrocution. If your product is hard wired i.e. non-detachable mains electric cable, a conversion kit and extension cable is available from all Electrolux Outdoor Products Approved Service Centres which can be found in your local Yellow Pages. Assembly Instructions A B Handle slot C Grassbox lid assembly (A) 1. Fit one side of the grassbox lid as illustrated in Fig. A. Repeat for the other side. Lower handle assembly (B) 1. Insert the lower handle into the handle slots, ensuring that the holes are aligned. 2. Insert the pins and secure with the retaining clips. Upper handle assembly (C) 1. Insert the nut into the handle knob. (C1) 2. Align the holes in the upper and lower handles and secure with the bolt, washer and wing knob.(C2) 3. Fit the cable to the handle with the clip provided. (C3) Make sure the cable is not trapped between the upper and lower handles. 1 2 3 Starting and Stopping D E F G H 1 J To Start your Lawnmower The Flymo Turbo Compact uses an advanced belt drive system, between the motor and the blade which improves cutting power and flotation in all conditions. Due to the high turning force (T orque) which this motor develops a light squeak may be heard when the machine is started, this is quite normal and will not effect the performance of the product 1. Connect female extension cable connector to the back of the switchbox. (D) 2. Form loop in mains cable and push the loop through the slot as illustrated in picture (E) 3. To secure, position loop over the hook and pull the cable back through the slot as illustrated in picture (F). 4. Connect plug to mains and switch on. 5. To prevent a ring being cut in your lawn and to clear any residual grass in the collection chute, tilt your lawnmower slightly (G). The switchbox is provided with a lock-off button (H1) to prevent accidental starting. 6. Press and hold the lock-off button (H) on the switchbox, then squeeze one of the Start/Stop levers towards the upper handle (J). 7. Continue to squeeze the start/stop lever towards the upper handle and release the lock-off button. 8. When the lawnmower has reached full speed gently lower it onto the lawn. NOTE: There are two start/stop levers fitted. Either one can be used for starting the lawnmower. IMPORTANT: Do not use the start/stop levers intermittently To Stop your Lawnmower 1. To prevent a ring being cut in your lawn and to clear any residual grass in the collection chute, tilt your lawnmower slightly (G). 2. Release the pressure on the Start/Stop lever. How to Mow 1. Start mowing the edge of the lawn nearest to the power point so the cable is laid out on the lawn you have already cut. 2. Mow twice a week during the growing season, your lawn will suffer if more than a third of its length is cut at one time and this may also result in poor collection. Do Not Overload Your Mower Mowing long thick grass may cause the motor speed to drop, you will hear a change in the motor sound. If the motor speed drops you may overload your lawnmower which may cause damage. When mowing in long thick grass a first cut with the cutting height set higher will help reduce the load. See Adjusting the Cutting Height. REMEMBER: For best grass collection always mow in a straight line, do not swing the lawnmower from side to side. Adjusting the Cutting Height K Always handle the blade with care - sharp edges could cause injury. USE GLOVES. Never use more than 3 Cutting Height Spacers. Spacers must only be fitted between the blade and the fan and NEVER between the blade and the bolt. 1. Remove the blade bolt, and blade as described in Removing the Blade and Fan. 2. For a Lower Cut - Add spacers to a maximum of 3. 3. For a Higher Cut - Take spacers away. 4. Refit the blade as described in Fitting the Blade and Fan. Removing and fitting the Blade and Fan L blade bolt Removing the Blade and Fan 1. To remove the blade bolt, hold the fan firmly and with the spanner provided loosen the blade bolt by turning it anti-clockwise (K). 2. Remove the blade bolt, blade, spacers and fan. (L) 3. Inspect for damage and clean as necessary. · Renew your metal blade after 50 hours mowing or 2 years wh ...