FMW42RC1 Radio Antenna Cover Kit Installation Guide Stylistic 3400 These instructions provide details on assembling and installing the Radio Antenna Cover Kit for the Stylistic 3400 pen tablet. The antenna cover should be installed when most types of antennae protrude from a radio PC Card. The cover provides a rigid cap over the antenna to prevent damage during everyday use. Note The antenna cover was specifically tested with Symbol®, ProximTM, BreezeComTM, and AiroNetTM radios; it is possible that certain other antennae will protrude too far from the system to fit within the antenna cover. FUJITSU PC CORPORATION 3. Insert the antenna cover tabs into the two tab slots on the pen tablet. 4. Insert the two black screws through the holes in the hood and secure them to the pen tablet. Hood Standoff Assembling the Radio Antenna Cover Kit The Radio Antenna Cover Kit consists of the following parts: · Plastic Hood · Plastic Base · Two black screws · One tapping screw 0 Positioning Tab (inside) Base Tapping Screw Figure 1. Assembling the Radio Antenna Cover Tab Slots To assemble the radio antenna cover, place the hood atop the base as illustrated in Figure 1. Make sure the positioning tab is on the inside of the hood. Secure the two pieces with the tapping screw by inserting it through the hole in the base into the standoff inside the hood. Installing the Radio Antenna Cover 0 To attach the radio antenna cover to the pen tablet, perform the following steps. 1. Position the antenna cover in relation to the back of the pen tablet as shown in Figure 2. 2. If caps are present over the mounting holes, remove them with a small screwdriver, or similar tool. Mounting Hole Tab PC Card Slot Figure 2. Installing the Radio Antenna Cover Symbol®, ProximTM, BreezeComTM, and AiroNetTM are trademarks or registered trademarks of their respective companies. Stylistic 3400 is a trademark of Fujitsu PC Corporation. © 2000 Fujitsu PC Corporation 3/00 58-0715-00A ...