Apollo NMC 2001/2101 Approach Checklist Location Enroute Within 30 nm of Destination Load Approach Enable Approach & enter altimeter setting (Approach annunciator turns ON) (CDI goes to 1 nm full-scale sensitivity) Verify Approach annunciator is ON Set OBS/HLD: ON for Procedure Turn or Hold OFF to sequence Verify green Approach-Active annunciator is ON Verify altimeter setting is entered Set OBS/HLD: OFF to sequence to MAP Verify Approach-Active annunciator is ON (CDI goes to 0.3 nm full-scale sensitivity) If NOT landing: Press OBS/HLD to cancel Approach-Active (Green ApproachActive annunciator turns OFF) (Approach Annunciator remains ON) (CDI goes to 1.0 nm full-scale sensitivity) Verify OBS/HLD is ON Action IAF Active Waypoint FAF Active Waypoint At FAF (MAP Becomes Active) At MAP (TO/FROM Transition) MAHP Active Waypoint Apollo NMC 2001/2101 DME-Arc Checklist Location At Arc Intercept Action 1. Verify/Set OBS/HLD ON 2. Manually select Flight Plan leg to intercept 3. USE DME-Arc Page in NAV mode 4. Verify or select DME-Arc Reference Waypoint 5. Verify/Set autopilot in Heading mode or disengaged 1. Use DME-Arc page in NAV mode and aircraft heading to navigate 2. Use CDI/HSI to identify inbound leg intercept 1. Set/Verify OBS/HLD OFF 2. Use CDI/HSI to navigate 3. Press NAV twice to use standard NMC NAV mode page 4. Use autopilot as desired On Arc Inbound Leg Intercept II MORROW V I S I O N A R Y T H I N K I N G T O D A Y P/N 561-1039-00 April 1996 http://www.iim.ups.com 2345 Turner Rd., S.E. Salem, OR 97302 USA Toll-Free 800.742.0077 ...