Projector ED-A100/ED-A110/CP-A100W User's Manual (detailed) Operating Guide Thank you for purchasing this projector. WARNING WARNING CAUTION NOTE Trademark acknowledgment 1 Read this Safety Guide first. Projector User's Manual - Safety Guide Thank you for purchasing this projector. WARNING · Before using, read these user's manuals of this projector to ensure correct usage through understanding. After reading, store them in a safe place for future reference. Incorrect handling of this product could possibly result in personal injury or physical damage. The manufacturer assumes no responsibility for any damage caused by mishandling that is beyond normal usage defined in these manuals of this projector. NOTE · The information in this manual is subject to change without notice. · The manufacturer assumes no responsibility for any errors that may appear in this manual. · The reproduction, transmission or use of this document or contents is not permitted without express written authority. About The Symbols Various symbols are used in this manual, the user's manual and on the product itself to ensure correct usage, to prevent danger to the user and others, and to prevent property damage. The meanings of these symbols are described below. It is important that you read these descriptions thoroughly and fully understand the contents. WARNING CAUTION Typical Symbols This symbol indicates information that, if ignored, could possibly result in personal injury or even death due to incorrect handling. This symbol indicates information that, if ignored, could result possibly in personal injury or physical damage due to incorrect handling. This symbol indicates an additional warning (including cautions). An illustration is provided to clarify the contents. This symbol indicates a prohibited action. The contents will be clearly indicated in an illustration or nearby (the symbol to the left indicates that disassembly is prohibited). This symbol indicates a compulsory action. The contents will be clearly indicated in an illustration or nearby (the symbol to the left indicates that the power plug should be disconnected from the power outlet). SG1 Safety Precautions WARNING Never use the projector if a problem should occur. Abnormal operations such as smoke, strange odor, no image, no sound, excessive sound, damaged casing or elements or cables, penetration of liquids or foreign matter, etc. can cause a fire or electrical shock. In such case, immediately turn off the power switch and then disconnect the power plug from the power outlet. After making sure that the smoke or odor has stopped, contact your dealer. Never attempt to make repairs yourself because this could be dangerous. · The power outlet should be close to the projector and easily accessible. Disconnect the plug from the power outlet. Use special caution for children and pets. Incorrect handling could result in fire, electrical shock, injury, burn or vision problem. Use special caution in households where children and pets are present. Do not insert liquids or foreign object. Penetration of liquids or foreign objects could result in fire or electrical shock. Use special caution in households where children are present. If liquids or foreign object should enter the projector, immediately turn off the power switch, disconnect the power plug from the power outlet and contact your dealer. · Do not place the projector near water (ex. a bathroom, a beach, etc.). · Do not expose the projector to rain or moisture. Do not place the projector outdoors. · Do not place flower vases, pots, cups, cosmetics, liquids such as water, etc on or around the projector. · Do not place metals, combustibles, etc on or around the projector. · To avoid penetration of foreign objects, do not put the projector into a case or bag together with any thing except the accessories of the projector, signal cables and connectors. Never disassemble and modify. The projector contains high voltage components. Modification and/or disassembly of the projector or accessories could result in fire or electrical shock. · Never open the cabinet. · Ask your dealer to repair and clean insider. Do not disassemble. Do not give the projector any shock or impact. If the projector should be shocked and/or broken, it could result in an injury, and continued use could result in fire or electrical shock. If the projector is shocked, immediately turn off the power switch, disconnect the power plug from the power outlet and contact your dealer. Do not place the projector on an unstable surface. If the projector should be dropped and/or broken, it could result in an injury, and continued use could result in fire or electrical shock. · Do not place the projector on an unstable, slant or vibrant surface such as a wobbly or inclined stand. · Use the caster brakes placing the projector on a stand with casters. · Do not place the projector in the side up position, the lens up position or the lens down position. · In the case of a ceiling installation or the like, contact your dealer before installation. SG2 Safety Precautions (continued) WARNING Be cautious of High temperatures of the projector. High temperatures are generated when the lamp is lit. It could result in fire or burn. Use special caution in households where children are present. Do not touch about the lens, air fans and ventilation openings during use or immediately after use, to prevent a burn. Take care of ventilation. · Keep a space of 30 cm or more between the sides and other objects such as walls. · Do not place the projector on a metallic table or anything weak in heat. · Do not place anything about the lens, air fans and ventilation openings of the projector. · Never block the air fan and ventilation openings. · Do not cover the projector with a tablecloth, etc. · Do not place the projector on a carpet or bedding. Never look through the lens or openings when the lamp is on. The powerful light could adversely affect vision. Use special caution in households where children are present. Use only the correct power cord and the correct power outlet. Incorrect power supply could result in fire or electrical shock. · Use only the correct power outlet depending on the indication on the projector and the safety standard. · The enclosed power cord must be used depending on the power outlet to be used. Be cautious of the power cord connection. Incorrect connection of the power cord could result in fire or electrical shock. · Do not touch the power cord with a wet hand. · Check that the connecting portion of the power cord is clean (with no dust), before using. Use a soft and dry cloth to clean the power plug. · Insert the power plug into a power outlet firmly. Avoid using a loose, unsound outlet or contact failure. Be sure to connect with ground wire. Connect the ground terminal of AC inlet of this unit with the ground terminal provided at the building using the correct power cord; otherwise, fire or electric shock can result. · Don't take the core of power cord away. Surely connect the ground wire. SG3 Safety Precautions (continued) WARNING Be careful in handling the light source lamp. The projector uses a high-pressure mercury glass lamp made of glass. The lamp can break with a loud bang, or burn out. When the bulb bursts, it is possible for shards of glass to fly into the lamp housing, and for gas containing mercury to escape from the projector's vent holes. Please carefully read the section "Lamp". Be careful in handling the power cord and external connection cables. If you keep using a damaged the power cord or cables, it can cause a fire or electrical shock. Do not apply too much heat, pressure or tension to the power cord and cables. If the power cord or cables is damaged (exposed or broken core wires, etc.), contact your dealer. · Do not place the projector or heavy objects on the power cord and cables. Also, do not place a spread, cover, etc, over them because this could result in the inadvertent placing of heavy objects on the concealed power cord or cables. · Do not pull the power cord and cables. When connecting and disconnecting the power cord or cables, do it with your hand holding the plug or connector. · Do not place the cord near the heater. · Avoid bending the power cord sharply. · Do not attempt to work on the power cord. Be careful in handling the battery of the remote control. Incorrect handling of the battery could result in fire or personal injury. The battery may explode if not handled properly. · Keep the battery away from children and pets. If swallowed consult a physician immediately for emergency treatment. · Do not allow the battery in a fire or water. · Avoid fire or high-temperature environment. · Do not hold the battery with the metallic tweezers. · Keep the battery in a dark, cool and dry play. · Do not short circuit the battery. · Do not recharge, disassemble or solder the battery. · Do not give the battery a physical impact. · Use only the battery specified in the other manual of this projector. · Make sure the plus and minus terminals are correctly aligned when loading the battery. · If you observe a leakage of the battery, wipe out the flower and then replace the battery. If the flower adheres your body or clothes, rinse well with water. · Obey the local laws on disposing the battery. SG4 Safety Precautions (continued) CAUTION Be careful in moving the projector. Neglect could result in an injury or damage. · Do not move the projector during use. Before moving, disconnect the power cord and all external connections, and close the slide lens door or attach the lens cap. · Avoid any impact or shock to the projector. · Do not drag the projector. · For moving the projector, use the enclosed case or bag if provided. Do not put anything on top of the projector. Placing anything on the projector could result in loss of balance or falling, and cause an injury or damage. Use special caution in households where children are present. Do not attach anything other than specified things to the projector. Neglect could result in an injury or damage. · Some projector has a screw thread in a lens part. Do not attach anything other than specified options (such as conversion lens) to the screw thread. Avoid a smoky, humid or dusty place. Placing the projector in a smoke, a highly humid, dusty place, oily soot or corrosive gas could result in fire or electrical shock. · Do not place the projector near a smoky, humid or dusty place (ex. a smoking space, a kitchen, a beach, etc.). Do not place the projector outdoors. · Do not use a humidifier near the projector. Take care of the air filter to normal ventilate. The air filter should be cleaned periodically. If the air filter becomes clogged by dust or the like, internal temperature rises and could cause malfunction. The projector may display the message such as "CHECK THE AIR FLOW" or turn off the projector, to prevent the internal heat level rising. · When the indicators or a message prompts you to clean the air filter, clean the air filter as soon as possible. · If the soiling will not come off the air filter, or it becomes damaged, replace the air filter. · Use the air filter of the specified type only. Please order the air filter specified in the other manual of this projector to your dealer. · When you replace the lamp, replace also the air filter. The air filter may be attached when you buy a replacement lamp for this projector. · Do not turn on the projector without air filter. Avoid a high temperature environment. The heat could have adverse influence on the cabinet of the projector and other parts. Do not place the projector, the remote control and other parts in direct sunlight or near a hot object such as heater, etc. Avoid Magnetism. Manufacture strongly recommends to avoid any magnetic contact that is not shielded or protected on or near the projector itself. (ie.,. Magnetic Security Devices, or other projector accessory that contains magnetic material that has not been provided by the manufacture etc.) Magnetic objects may cause interruption of the projector's internal mechanical performance which may interfere with cooling fans speed or stopping, and may cause the projector to completely shut down. SG5 Safety Precautions (continued) CAUTION Remove the power cord for complete separation. · For safety purposes, disconnect the power cord if the projector is not to be used for prolonged periods of time. · Before cleaning, turn off and unplug the projector. Neglect could result in fire or electrical shock. Disconnect the plug from the power outlet. Ask your dealer to cleaning inside of the projector about every year. Accumulations of dust inside the projector cause result in fire or malfunction. Cleaning inside is more effective if performed before every humid periods such as rainy season. · Do not clean inside yourself because it is dangerou ...