9 562 brands
2 694 000 user's guides


Download your manual, it's FREE! Diplodocs allows you to download several types of document in order to best use your HOMELITE 18783A : user manual, user guide, instruction manual.
Search a brand
Advanced Search

Need help using a product?
Look at the reviews on HOMELITE 18783A

User manual HOMELITE 18783A

Diplodocs help download the user guide HOMELITE 18783A .

Download the complete user guide (29 Ko)



This product, although classified under the brand HOMELITE, may have been manufactured by JOHN DEERE after mergers, acquisitions, or a change in name.


Preview of the first 3 pages of manual

You either have JavaScript turned off or an old version of Adobe Flash Player
Get the latest Flash Player.
Manual abstract: user guide HOMELITE 18783A

Detailed instructions for use are in the User's Guide.

18783A 12-03 INSTALLATION INSTRUCTIONS BLOWER FAN KIT A-00503-A To lower vibration levels in HB100, HB180, HB180V and BP250 Blowers INSTALLATION ON "D" SHAPED SHAFTS 1. Remove starter rope from spark plug hole. 2. Install fan, fan adaptor and belleville washer (concave side towards fan) as shown in Figure 2. 3. Hold fan and install the fan retaining nut and torque the nut 150-200 in. lbs. (17,0-22,5 Nm). 4. Install outer volute and back pack frame (BP250). DISCONNECT SPARK PLUG BEFORE PERFORMING MAINTENANCE, ADJUSTMENT, LUBRICATION AND STORAGE. WARNING Improper fan installation will result in excessive unit vibration. INSTALLATION ON ROUND SHAFTS 1. Remove starter rope from spark plug hole. Position piston at top-dead-center. 2. Assemble new fan with molded scribe line on the fan in line with the spark plug (see Figure 1). 3. Install the fan adaptor and belleville washer (concave side towards fan) as shown in Figure 2.. 4. Hold the fan and install the fan retaining nut and torque the nut 150-200 in. lbs. (17,0-22,5 Nm). 5. R-check the fan alignment with a piston at top-dead-center. Adjust as necessary. 6. Install outer volute and back pack frame (BP250). NOTE Do not use an impact wrench to tighten the fan retaining nut. WARNING Blower will vibrate excessively if fan is improperly installed. FAN REMOVAL 1. Remove the blower from the back pack frame (BP250 only). 2. Remove seven hex screws and separate inner and outer volute housings. 3. Remove the spark plug and install a length of starter rope as a piston stop. 4. Remove the fan retaiing nut, belleville washer, outer fan washer and fan. Discard outer fan washer and fan. FAN INSTALLATION The Blower Fan Kit consists of a blower fan (part no. 04334) and 2 fan adaptors (part no. 04335 for "D" shaped shafts) and (part no. 04335-1 for round shafts). FIG. 1 FIG. 2 FAN WASHER FAN ADAPTOR SCRIBE LINE BELLEVILLE WASHER FAN BLOWER WITH ROUND SHAFT ONLY FAN RETAINING NUT ...
  Know our Partners   Frequently Asked Questions   Contact Diplodocs team   Last searches
Latest additions 		  Sitemap
Brands starting with A B C D E F G H I J K L M N O P Q R S T U V W X Y Z #
Copyright © 2005 - 2008 - Diplodocs - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.