THANK YOU FOR SELECTING A HUSKY FLOOR LINER FROM WINFIELD CONSUMER PRODUCTS CARE AND USE INSTRUCTIONS Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor liner. However, do not remove the factory-installed carpeting. Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick. INSTALLATION INSTRUCTIONS FOR YOUR FORD F-150 SUPER CREW TRUCK SECOND SEAT FLOOR LINER AREA 1 LEFT OR DRIVER'S SIDE RIGHT OR PASSENGER'S SIDE AREA 2 ON VEHICLES EQUIPPED WITHOUT A FACTORY CENTER CONSOLE, IT WILL BE NECESSARY TO TRIM AWAY A PORTION OF THE LINER. TRIM BY REMOVING THE RECESSED AREA OF THE LINER ALONG THE FRONT EDGE AS SHOWN ABOVE (SEE AREA 1). A UTILITY KNIFE OR SCISSORS WORK WELL FOR TRIMMING. USE OFFSET "STEP" AS TRIMMING GUIDE. SEE BACK OF PAGE FOR TRIMMING PHOTOS. ON VEHICLES EQUIPPED WITH A FACTORY SUBWOOFER (UNDER DRIVER'S SIDE REAR SEAT), TRIM LINER AS SHOWN ABOVE (AREA 2). USE THE RAISED GROOVE AS A TRIM GUIDE, TRIMMING ALONG THE BACK EDGE (LEAVING RAISED AREA). CONTINUE TRIM OVER HUMP FOLLOWING OFFSET STEP IN PART AS A GUIDE. TRIMMING PHOTOS ARE INCLUDED ON BACK OF THIS PAGE. 6368 Front_Back.doc 01/22/2004 6368 PART UNTRIMMED. USE UNTRIMMED PART IN VEHICLE WITH FACTORY CENTER CONSOLE BETWEEN FRONT SEATS. 6368 PART SHOWN TRIMMED. USE TRIMMED PART IN VEHICLE WITHOUT FACTORY CENTER CONSOLE BETWEEN FRONT SEATS. PART #6368 SHOWN TRIMMED FOR USE WITH FACTORY SUBWOOFER (LARGE PHOTO) AND ALSO SHOWN IN VEHICLE WITH FACTORY CONSOLE AND REAR SEAT SUBWOOFER (INSET). IT IS POSSIBLE TO INSTALL YOU HUSKY LINER SO THAT IT WILL TUCK UNDER THE SUBWOOFER BOX. YOU WILL NEED TO REMOVE TWO OF THE ATTACHMENT BOLTS AND LOOSEN THE THIRD WHICH WILL ALLOW THE SUBWOOFER BOX TO BE RAISED ENOUGH TO SLIDE YOUR LINER UNDERNEATH IT. 6368 Front_Back.doc 01/22/2004 ...