Operation on the New 60 M Band The new 60 M amateur band became available for use on July 3, 2003. Operation on this band is allowed on 5 discrete frequencies and must adhere to the following: 2.8 kHz bandwidth, USB mode, and transmit a maximum of 50 watts ERP (Effective Radiated Power). I Operation It is the operator's responsibility to set all controls so that the transmission in the new band meets the stringent conditions under which we may use these frequencies. 703 Tuning Frequency 5.33050 5.34650 5.36650 5.37150 5.40350 MHz MHz MHz MHz MHz FCC Channel Center Frequency 5.33200 5.34800 5.36800 5.37300 5.40500 [MODE] [Y] MHz MHz MHz MHz MHz NOTE: We recommend that you store these frequencies into the memory channel for easy recall. "USB" appears LSB USB CW R RTTY AM WFM S1 PO 3 5 7 9 5 20 40 60dB 10 VFO A CH [Z] [LOCK] Main dial M1 SPL A/B XFC q Push [Y(BAND)] / [Z(BAND)] to select 5 MHz band. w Push [MODE] momentarily to select USB mode. · When LSB is selected, push for 1 sec. to select USB mode. e Rotate the main dial to set the frequency exactly as shown is table above. r Push [LOCK] momentarily to set the dial lock function ON, if desired. Then operate these frequencies. A-6241H-3EX Printed in Japan © 2003 Icom Inc. ...