Instructions for use WASHER-DRYER Contents GB English Installation, 14-15 GB Unpacking and levelling, 14 Electric and water connections, 14-15 The first wash cycle, 15 Technical details, 15 Washer-dryer description, 16-17 Control panel, 16 Leds, 17 Starting and Programmes, 18 Briefly: how to start a programme, 18 Programme table, 18 Personalisations, 21 WIDL 86 Setting the temperature, 21 Setting the drying cycle, 21 Functions, 21 Detergent dispenser, 22 Preparing your laundry, 22 Special items, 22 Detergents and laundry, 22 Precautions and advice, 23 General safety, 23 Disposal, 23 Saving energy and respecting the environment, 23 Care and maintenance, 24 Cutting off the water or electricity supply, 24 Cleaning your appliance, 24 Cleaning the detergent dispenser, 24 Caring for your appliance door and drum, 24 Cleaning the pump, 24 Checking the water inlet hose, 24 Troubleshooting, 25 Service, 26 Before calling for Assistance, 26 13 Installation GB Keep this instruction manual in a safe place for future reference. Should the appliance be sold, transferred or moved, make sure the instruction manual accompanies the Washer-dryer to inform the new owner as to its operation and features. Read these instructions carefully: they contain vital information on installation, use and safety. Levelling your appliance correctly will provide it with stability and avoid any vibrations, noise and shifting during operation. If it is placed on a fitted or loose carpet, adjust the feet in such a way as to allow enough room for ventilation beneath the Washerdryer. Unpacking and levelling Unpacking Electric and water connections Connecting the water inlet hose 1. Unpack the Washer-dryer. 2. Check whether the Washer-dryer has been damaged during transport. If this is the case, do not install it and contact your retailer. 3. Remove the four protective screws and the rubber washer with the respective spacer, situated on the rear of the appliance (see figure). A 1. Insert seal A into the end of the inlet hose and screw the latter onto a cold water tap with a 3/4 gas threaded mouth (see figure). Before making the connection, allow the water to run freely until it is perfectly clear. 2. Connect the other end of the water inlet hose to the Washer-dryer, screwing it onto the appliance's cold water inlet, situated on the top right-hand side on the rear of the appliance (see figure). 4. Seal the gaps using the plastic plugs provided. 5. Use the plug provided to seal the three holes where the plug was housed, situated on the lower right-hand side on the rear of your appliance. 6. Keep all the parts: you will need them again if the Washer-dryer needs to be moved to another location. 3. Make sure there are no kinks or bends in the hose. Packaging materials are not children's toys. Levelling The water pressure at the tap must be within the values indicated in the Technical details table (on the next page). 1. Install the Washer-dryer on a flat sturdy floor, without resting it up against walls, furniture cabinets or other. 2. If the floor is not perfectly level, compensate for any unevenness by tightening or loosening the adjustable front feet (see figure); the angle of inclination, measured according to the worktop, must not exceed 2°. If the water inlet hose is not long enough, contact a specialist store or an authorised serviceman. 14 Connecting the drain hose Do not use extensions or multiple sockets. Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor; GB Installation The power supply cable must never be bent or dangerously compressed. The power supply cable must only be replaced by an authorised serviceman. Warning! The company denies all liability if and when these norms are not respected. 65 - 100 cm Description The first wash cycle alternatively, place it over the edge of a basin, sink or tub, fastening the duct supplied to the tap (see figure). The free end of the hose should not be underwater. Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, setting the 90°C programme without a pre-wash cycle. Programmes case of absolute need, the extension must have the same diameter as the original hose and must not exceed 150 cm in length. Electric connection We advise against the use of hose extensions; in Technical details Model WIDL 86 59.5 cm wide 85 cm high 53.5 cm deep from 1 to 5 kg for the wash programme; from 1 to 4 kg for the drying programme voltage 220/230 Volts 50 Hz maximum absorbed power 1850 W maximum pressure 1 MPa (10 bar) minimum pressure 0.05 MPa (0.5 bar) drum capacity 46 litres Detergents Dimensions Capacity Electric connections Water connections Spin speed Precautions Before plugging the appliance into the mains socket, make sure that: the socket is earthed and in compliance with the applicable law; the socket is able to sustain the appliance's maximum power load indicated in the Technical details table (on the right); the supply voltage is included within the values i ndicated on the Technical details table (on the right); the socket is compatible with the washing machine's plug. If this is not the case, replace the socket or the plug. outdoor environment, not even when the area is sheltered, because it may be very dangerous to leave it exposed to rain and thunderstorms. Care up to 800 rpm Wash: programme 2; temperature 60°C; run with a load of 5 kg. Drying: first drying cycle performed with a 1 kg load, by selecting a drying time of 40 min; Second drying cycle performed with a 4 kg load and the DRYING knob on the setting. This appliance is compliant with the following European Community Directives: - 73/23/CEE of 19/02/73 (Low Voltage) and subsequent amendments - 89/336/CEE of 03/05/89 (Electromagnetic Compatibility) and subsequent amendments Control programmes according to IEC456 directive Troubleshooting The washing machine should not be installed in an Service When the washing machine is installed, the mains socket must be within easy reach. 15 Washer-dryer description GB Control panel Leds Buttons FUNCTION ON-OFF/ DOOR ON-OFF LOCK Button Led Detergent dispenser PROGRAMME Knob Button START/RESET DRYING Knob TEMPERATURE Knob Detergent dispenser: to add detergent and fabric softener (see page 20). LEDS: to find out which wash cycle phase is under way. If the Delay Timer function has been set, the time left until the programme starts will be indicated (see page 17). DRYING knob: to set the desired drying cycle (see page 19). FUNCTION buttons: to select the functions available. The button corresponding to the function selected will remain on. TEMPERATURE knob: to set the temperature or the cold wash cycle (see page 19). START/RESET button: to start the programmes or cancel any incorrect settings. ON-OFF/DOOR LOCK Led: to find out whether the Washer-dryer is on and if the appliance door can be opened (see page 17). ON/OFF button: to turn the Washer-dryer on and off. PROGRAMME knob: to select the wash programmes. The knob stays still during the cycle. 16 Leds The LEDS provide important information. This is what they can tell you: Delay set: If the Delay Timer function has been enabled (see page. 19), once you have started the programme, the LED corresponding to the delay set will begin to flash: Cycle phase under way: During the wash cycle, the LEDs gradually illuminate on to indicate the cycle phase under way: Prewash / Wash Rinse Spin cycle Drying Note: - during draining, the LED corresponding to the Spin cycle phase will be turned on. - when the drying cycle is complete, the indicator will flash, to indicate that light relative to phase the DRYING knob needs to be set back to the 0 setting. Function buttons The FUNCTION BUTTONS also act like LEDS. When a function is selected, the corresponding button is illuminated. If the function selected is incompatible with the programme set, the button will flash and the function will not be enabled. If you set a function that is incompatible with another function you selected previously, only the last one selected will be enabled. GB Installation Description Programmes As time passes, the remaining delay will be displayed, and the corresponding LED will flash: Detergents Once the set delay is complete, the flashing LED will turn off and the programme set will start. Precautions Care Troubleshooting ON-OFF/DOOR LOCK led: If this LED is on, the appliance door is locked to prevent it from being opened accidentally; to avoid any damages, wait for the LED to flash before you open the appliance door. Service The rapid flashing of the ON-OFF/DOOR LOCK Led together with the flashing of at least one other LED indicates there is an abnormality. Call for Technical Assistance. 17 Starting and Programmes Briefly: starting a programme GB 1. Switch the Washer-dryer on by pressing button . All the LEDS will light up for a few seconds and the ON-OFF/DOOR LOCK Led will begin to flash. 2. Load your laundry into the washing machine and shut the appliance door. 3. Set the PROGRAMME knob to the programme required. 4. Set the wash temperature (see page 19). 5. Set the drying cycle if necessary (see page 19). 6. Add the detergent and any fabric softener (see page 20). 7. Start he programme by pressing the START/RESET button. To cancel it, keep the START/RESET button pressed for at least 2 seconds. 8. When the programme is finished, the ON-OFF/ DOOR LOCK Led will flash to indicate that the appliance door can be opened. Take out your laundry and leave the appliance door ajar to allow the drum to dry thoroughly. Turn the Washer-dryer . off by pressing button D etergent prew ash w ash C ycle Fabric length D escription of wash cycle softener (m inutes) Programme table Type of fab ric and degree of soil P rogram m es Tem perature S tandard Extremely soiled whites (sheets, tablecloths, etc.) Extremely soiled whites (sheets, tablecloths, etc.) Heavily soiled whites and fast colours Heavily soiled whites and delicate colours Slightly soiled whites and delicate colours (shirts, jumpers, etc.) Heavily soiled fast colours (baby linen, etc.) Heavily soiled fast colours (baby linen, etc.) W ool Very delicate fabrics (curtains, silk, viscose, etc.) Drying cotton Drying delicates 1 2 2 2 3 4 4 5 6 7 8 90°C 90°C 60°C 40°C 40°C 60°C 135 125 110 105 70 75 60 50 45 40°C 40°C 30°C Pre-wash, wash cycle, rinse cycles, intermediate and final spin cycles Wash cycle, rinse cycles, intermediate and final spin cycles Wash cycle, rinse cycles, intermediate and final spin cycles Wash cycle, rinse cycles, intermediate and final spin cycles Wash cycle, rinse cycles, intermediate and final spin cycles Wash cycle, rinse cycles, anti-crease or delicate spin cycle Wash cycle, rinse cycles, anti-crease or delicate spin cycle Wash cycle, rinse cycles anti-crease or delicate spin cycle Wash cycle, rinse cycles, anti-crease or draining cycle Tim e 4 yo u Heavily soiled whites and fast colours Delicate colours (all types of slightly soiled garments) Delicate colours (all types of slightly soiled garments) 9 10 11 60°C 40°C 65 45 30°C 30 Wash cycle, rinse cycles, intermediate and final spin cycles Wash cycle, rinse cycles, delicate spin cycle Wash cycle, rinse cycles and delicate spin cycle Cold wash (without detergents), wash cycle, rinse cycles, and delicate spin cycle S port Sports shoes (MAX. 2 pairs) Fabrics for sportswear (Tracksuits, shorts, etc.) PAR TIAL PR OGR AM M ES Rinse Spin cycle Drain Rinse cycles and spin cycle Draining and spin cycle Drain 12 13 30°C 50 60 30°C Wash cycle, rinse cycles, intermediate and final spin cycles Notes -For programme 9, we advise against exceeding a wash load of 3.5 kg. -For programme 13 we advise against exceeding a wash load of 2 kg. -For the anti-crease function: see Easy iron, opposite page. The information contained in the table is purely indicative. Special programme Daily (programme 11 for Synthetics) is designed to wash lightly soiled garments in a short amount of time: it only lasts 30 minutes and allows you to save on both time and energy. By setting this programme (11 at 30°C), you can wash different fabrics together (except for woollen and silk items), with a maximum load of 3 kg. We recommend the use of liquid detergent. 18 Personalisations C Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 18). The temperature can be lowered, or even set to a cold wash ( ). Turn the DRYING knob to set the desired drying type. Two options are available: A - Based on time: From 40 minutes to 150. B - Based on the damp level of the dry clothes: : slightly damp clothes, easy to iron. Iron : dry clothes to put away. Hanger : very dry clothes, recommended for towelling Cupboard and bathrobes. A cooling stage is ...