QUICK START  009-0290-01 (English) QUICK START Dont Look Into The Lens! Be extremely careful not to look directly into the lens when the projector is on. The bright light can harm your eyes. Be especially careful to keep children from looking into the lens. SAFETY SUMMARY : Please read these instructions before Dont Disassemble using your LitePro. Failure to Do not open the projector's case! Doing so exposes you to an electric shock hazard. Except for the projection lamp, there are no user-serviceable parts. All service must be performed by an In Focus Authorized Service Provider. Avoid Hot Surfaces comply could result in fire, electrical shock, personal injury or equipment damage. The inside of the projector lamp housing can be very hot. Allow the projector to cool for at least 2 minutes before opening the lamp door to replace the lamp. Use extreme care. Avoid touching the hot surfaces inside. Use Only The 720/730 P ower Cord Definition of Safety Icons on Product Labels Always use the power cord that came with the projector. Although other cords might look the same, they have not been safety-tested with the 720 or 730. Never use the power cord if it's damaged or frayed. When you disconnect the projector, always remove the power cord from the electrical outlet first, then from the projector. Dont Defeat The Purpose Of The Grounding Plug Refer to the User s Guide for more information. The projector is grounded through the grounding conductor on the power cord. To avoid electric shock, plug the power cord into a properly wired receptacle. Avoid Liquid Spills Don't set drinks on top of the projector. Spilled liquids can flow inside causing damage. Dont Block V entilation Avoid hot surfaces. Openings in the case provide ventilation to protect the projector from overheating. Keep loose papers and other objects away from the grills. Don't place the projector on top of or close to a computer or other heat-producing equipment. ...