Indoor/Outdoor 1A2, 3A2, 3T, 8A2 Congratulations on your purchase of Jamo Indoor/Outdoor speakers. Package content. Speaker (2) Curved bracket "a" (2) Wall bracket "b" (2) Wall bracket cover "c" (2) Thumb screw "k" (4) 1" Allen bolt "d" (4) ½" Allen bolt "e" (4) Allen wrench (1) Port plug "i" (4) Screw plug "g" (8) Manual (1) Assembly of bracket. Place the curved bracket (a) between the wall bracket (b) and wall bracket cover (c) as shown in fig. 1. Insert two 1" allen bolts (d) through wall bracket into wall bracket cover and tighten with the supplied allen wrench. Insert two ½" allen bolts (e) into each side of wall bracket and tighten towards curved bracket. a e f d d b e c Fig. 1 Mounting of bracket. The bracket can be mounted for horizontal or vertical placement of the speaker. Mount the bracket with four screws (not included) appropriate for the surface the bracket is mounted to (wood, brick, concrete or other). Take into account the weight of the speaker (specifications on back). A hole (f) in the middle of the bracket allows for running the speaker wire through the bracket if so desired. Cover the screws with four screw plugs (g) fig. 2. Mounting of port plugs. If the front of the speaker is exposed to rain directly entering the bass reflex ports (under the grill), the ports should be closed to avoid filling the speaker with water. High moisture is not a problem. Remove the grill (h) from the speaker and insert two port plugs (i) into the bass ports. Re-install the grill. The speaker will reproduce less bass with the ports closed. Connecting speaker wires. Loosen speaker terminals by turning counter clockwise. Strip ½"/12 mm insulation off each wire. Twist strands on each wire to form "solid" wire. Insert one wire into each terminal and tighten terminal by turning clockwise. Make sure positive (+) is to red terminal and negative (-) to black terminal for correct phasing. Adjustment of I/O 3T. This model is for 70V or 100V line installation. This is mainly used in commercial installations with many speakers and requires an amplifier with matching transformer outputs. A switch located next to the terminals allows for adjustments of the level of the speaker in 10W, 5W, 2.5W and 1.25W settings. Adjust the switch to the desired level on each speaker. Mounting of speaker. Remove two covers (j) from the speaker. Place the speaker inside the curved bracket as shown in fig. 2 and insert thumb screws (k) through each end of the curved bracket into the speaker. Adjust the speaker to the desired angle and tighten the thumb screws. Re-install the covers. The curved bracket can be adjusted in the wall bracket by loosening the two ½" allen bolts and re-tighten them after adjustment. j k l i i h k j g g Fig. 2 Painting. The speaker and bracket can be painted. Spray painting is recommended. Paint all parts before assembling. Remove the grill from the speaker before painting and cover the front baffle (l) of the speaker. Apply many thin coats instead of a few thick coats to avoid the paint running or clogging the grill holes. Re-install grill after painting. Specifications Model System Woofer (in/mm) Tweeter (in/mm) Power (W long/short term) Sensitivity (dB/2.83V/1m) Frequency range (Hz) Impedance (Ohm) Weight (lb/kg) Dimensions HxWxD (in/mm) I/O 1A2 2 way ported 4½/114 ½/13 Dome 20/40 86 77-20,000 6 5.1/2.3 9.1x6.3x6.6 232x160x168 I/O 3A2 2 way ported 5¼/133 1/25 Dome 40/80 88 64-20,000 8 6.9/3.2 11.4x7.9x8.2 290x200x209 I/O 3T 2 way ported 5¼/133 1/25 Dome 40/80 88 64-20,000 70/100V line 7.3/3.3 11.4x7.9x8.2 290x200x209 I/O 8A2 2 way ported 8/203 1/25 Dome 80/125 88 50-20,000 8 10.1x4.6 13.5x9.3x9.8 344x237x248 Limited Warranty Jamo loudspeakers and accessories are covered by a limited warranty in respect to manufacturing and equipment defects. Other claims are not covered. This warranty is a national warranty in accordance with relevant legislation. Period of the warranty is as stated below and is in effect from the date of purchase. Customer sales slip with date of purchase is the only document needed for warranty claims. Jamo warranty on all loudspeakers and accessories is seven (7) years. In-wall and in-ceiling loudspeakers carries Limited Lifetime Warranty in the US only. Electronics (receivers, amplifiers, screens, distribution systems, sub-woofer amplifier etc.) carries a two (2) year warranty. www.jamo.com ...