User manual JBL CS1200T

subwoofer enclosures owner's manual INSTALLATION WARNINGS AND TIPS THANK YOU for choosing a JBL CS subwoofer enclosure. These products have been designed to deliver great bass performance from a compact, easily installed enclosure. To get the best performance from your enclosure, we strongly recommend that installation be entrusted to a qualified professional. Although these instructions explain how to install your product in a general sense, they do not show specific installation methods that may be required for your particular vehicle. If you do not have the necessary tools or experience, do not attempt the installation yourself. Instead, please ask your authorized JBL car audio dealer about professional installation. In order that we may better serve you should you require warranty service, please retain your original sales receipt and serial number. INSTALLATION WARNING INSTALLATION TIPS Playing loud music in an automobile can hinder your ability to hear traffic and permanently damage your hearing. We recommend listening at low or moderate levels while driving your car. JBL accepts no liability for hearing loss, bodily injury or property damage resulting from the use or misuse of this product. · Always wear protective eyewear when using tools. · Turn off all audio components and other electrical devices before you start. Disconnect the (­) negative lead from your vehicle's battery. · Check clearances on both sides of a planned mounting surface. Be sure that screws or wires will not puncture brake lines, fuel lines or wiring harnesses, and that wire routing will not interfere with the safe operation of the vehicle. · When making electrical connections, make sure they are secure and properly insulated. · Before drilling or cutting holes, use a utility knife to remove unwanted fabric or vinyl, to keep material from snagging in a drill bit or saw. · Do not mount speakers where they will get wet. · If a fuse must be replaced, be sure to use the same type of fuse and current rating as that of the original. POWER CONNECTIONS CHOOSING A MOUNTING LOCATION FOR ENCLOSURE Connect speaker cable to enclosure as shown in Figure 1. Please observe the following installation tips: Use at least 0.5mm2 speaker wire for speaker-level input connections. Figure 1. HEAD UNIT Choose a mounting location that doesn't interfere with cargo, the fold-down rear seat or the trunk lid. The best location is usually a corner of the trunk or cargo area. Securely mount enclosure to the mounting surface using the supplied material. L R Remote Turn-On Speaker Out AMP BATTERY SPECIFICATIONS CS1000B 250mm Subwoofer Type: RMS Power: Max Power: Sensitivity (2.83V, 1m): Frequency Response: Impedance: Dimensions (L x W x H): Sealed 100W 400W 94dB 38Hz ­ 500Hz 4 ohms 360mm x 385mm x 320mm CS1200B 300mm Subwoofer Sealed 125W 500W 94dB 38Hz ­ 500Hz 4 ohms 410mm x 385mm x 360mm CS1200T 300mm Subwoofer Bass Reflex 125W 500W 94dB 38Hz ­ 500Hz 4 ohms Dia: 335mm x 660mm A valid serial number is required for warranty coverage. Features, specifications and appearance are subject to change without notice. Declaration of Conformity We, Harman Consumer International 2, route de Tours 72500 Chateau-du-Loir France declare in own responsibility that the products described in this owner's manual are in compliance with technical standards: EN 50081-1:1992 EN 50082-1:1997 JBL Consumer Products 2, route de Tours, 72500 Chateau-du-Loir, France www.jbl.com © 2003 Harman International Industries, Incorporated JBL is a registered trademark of Harman International Industries, Incorporated. Emmanuel Millot Harman Consumer International Chateau-du-Loir, France 9/03 Part No. CSENCOM8/03