6SHFLILFDWLRQV Model Item AV28S2EK/AV32S2EK AV28S2EK* CCIR I AV32S2EK* Broadcasting systems Colour systems Channels and frequencies Sound-multiplex systems Teletext systems Power requirements Power consumption Picture tube size Audio output Speakers EXT-1 terminal PAL · The EXT terminals also support the NTSC 3.58/4.43 MHz system. E21-E69 NICAM (I) system FLOF (Fastext), WST (World Standard Text) 220 - 240 V AC, 50 Hz Maximum: 168 W, Average: 115 W, Standby: 0.8 W Viewable area 66 cm (measured diagonally) Rated Power output: 7.5 W + 7.5 W (20 cm × 4 cm) oval × 2 Euroconnector (21-pin, SCART) · Video input, Audio L/R inputs and RGB inputs are available. · TV broadcast outputs (Video and Audio L/R) are available. Euroconnector (21-pin, SCART) · Video input, S-VIDEO (Y/C) input and Audio L/R inputs are available. · Video and Audio L/R outputs are available. · T-V LINK functions are available. Euroconnector (21-pin, SCART) · Video input, S-VIDEO (Y/C) input and Audio L/R inputs are available. RCA connectors × 3 S-VIDEO connector × 1 · Video input, S-VIDEO (Y/C) input and Audio L/R inputs are available. RCA connectors × 2 · Variable audio L/R outputs are available. · Variable out 0-1 Vrms, low impedance Stereo mini-jack (3.5 mm in diameter) 800 mm × 500 mm × 498 mm 41 kg Remote control unit RM-C55 × 1 AAA/R03 dry cell battery × 2 901 mm × 556 mm × 557 mm 57.4 kg Maximum: 172 W, Average: 121 W, Standby: 0.8 W Viewable area 76 cm (measured diagonally) Colour Television AV28S2EK AV32S2EK Contents Safety precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Setting up your TV . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 T-V LINK functions. . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Using your TV­the basics . . . . . . . . . . . . . . . . . . . . . 8 Remote control buttons and functions . . . . . . . . . . . . 11 Using the TV's menus . . . . . . . . . . . . . . . . . . . . . . . 16 Picture setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Picture features . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 Sound setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 EXT SETTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 FEATURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 INSTALL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 DEMO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Other menus . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Further preparation . . . . . . . . . . . . . . . . . . . . . . . . . 32 TV buttons and parts . . . . . . . . . . . . . . . . . . . . . . . . 34 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 Specifications. . . . . . . . . . . . . . . . . . . . . . . Back Cover EXT-2 terminal EXT-3 terminal EXT-4 terminal AUDIO OUT terminal Headphone jack Dimensions (W × H × D) Weight Accessories * A basic model number. The actual model number may have characters added (such as "S" for silver) showing the colour of the TV set. We may change the design and specifications without notice. Pictures displayed on the screen using this TV's ZOOM functions should not be shown for any commercial or demonstration purpose in public places (cafes, hotels, etc.) without the consent of the owners of copyright of the original picture sources, as this would be an infringement of copyright. INSTRUCTIONS ©2000 VICTOR COMPANY OF JAPAN, LIMITED LCT0895-001A-U 1200-T-CR-JMUK Thank you for buying this colour television. To make sure you fully understand how to use your new TV, please read this manual thoroughly before you begin. 6DIHW\#SUHFDXWLRQV s :DUQLQJ To prevent fire or shock hazard, do not expose this appliance to rain or moisture. s :DUQLQJ DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or adaptor or consult your dealer. If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply. If a new mains plug has to be fitted, then follow the instruction given below: s &DXWLRQ To ensure personal safety, observe the following rules regarding the use of this unit. 1 Operate only from the power source specified (AC 220 ­ 240 V, 50 Hz) on the unit. 2 Avoid damaging the AC plug and power cord. 3 Avoid improper installation and never position the unit where good ventilation is unattainable. When installing this television, distance recommendations must be maintained between the floor and wall, as well as instalment in a tightly enclosed area or piece of furniture. Please adhere to the minimum distance guidelines shown for safe operation. Important Do not make any connection to the larger terminal which is marked with the letter E or by the safety earth symbol or coloured green or green-and-yellow. The wires in the mains lead on this product are coloured in accordance with the following code: Blue: Neutral Brown: Live As these colours may not correspond with the coloured marking identifying the terminals in your plug proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When replacing the fuse only a correctly rated approved type should be used and be sure to re-fit the fuse cover. 15 cm 10 cm 10 cm 15 cm 4 Do not allow objects or liquid into the cabinet openings. 5 In the event of a fault, unplug the unit and call a service technician. Do not attempt to repair it yourself or remove the rear cover. 6 The surface of the TV screen is easily damaged. Be very careful with it when handling the TV. Should the TV screen become soiled, wipe it with a soft dry cloth. Never rub it forcefully. Never use any cleaner or detergent on it. 7 When you don't use this TV set for a long period of time, be sure to disconnect the power plug from the AC outlet. If in doubt -- consult a competent electrician. How to replace the fuse Open the fuse compartment with a blade screwdriver, and replace the fuse. Fuse 5 s *XLGHOLQHV#IRU#VDIH#RSHUDWLRQ This equipment has been designed and manufactured to comply with international safety standards. However, as with any electrical appliance, care must be taken to ensure optimal results and operational safety. · Before attempting to use this equipment, read the operating instructions thoroughly. · Ensure that all electrical connections (including the mains plug, extension leads, etc.) have been made in accordance with the manufacturer's instructions. · If ever in doubt about the installation, operation or safety of this equipment, consult your dealer. · Handle all glass panels or covers with care. · Never operate this equipment if it appears damaged or operates abnormally. Turn the power off, disconnect the main power plug and consult your dealer. · Never remove any affixed panels or covers. Doing so may result in electrical shock. · Never leave this equipment operating unattended unless otherwise specifically stated that it is designed to do so or in standby mode. Only use the designated power switch to turn off the power and ensure that all potential users are instructed how to do so. Make special arrangements for infirm or handicapped persons. · Never watch TV while operating a motor vehicle. It is illegal to watch TV while driving. · Never listen to headphones at high volume. Doing so may damage your hearing. · Never obstruct the ventilation of this equipment. Doing so may cause overheating and result in a malfunction or damage. · Never use makeshift stands or attempt to affix legs with wood screws. When using a manufacturer's approved stand or legs, use only the fixtures provided and follow the installation instructions. · Never allow this equipment to be exposed to rain or moisture. · Never allow anyone, especially children, to insert anything into an opening in the case. Doing so may result in a fatal electrical shock. · Never guess or take chances with electrical equipment of any kind. It is better to be safe than sorry. 6 6HWWLQJ#XS#\RXU#79 s &RQQHFWLQJ#WKH#DHULDO#DQG#YLGHR#FDVVHWWH#UHFRUGHU#+9&5, If you are connecting a VCR, follow A B C D in the diagram opposite. If you are not connecting a VCR, follow 1 2. · For more details, see the manuals that came with the equipment you want to connect. · The connecting cables are not provided. · You can watch a video using the VCR without doing C. For details, see your VCR instruction manual. · To connect more equipment, please see "Further preparation" on page 32. · To connect external speakers and an audio system, please see "Connecting speakers or an amplifier" on page 33. · If you connect a decoder to a T-V LINK compatible VCR, set the DECODER (EXT-2) function to ON. For details, see "Using the DECODER (EXT-2) function" on page 30. Otherwise, you will not be able to watch scrambled channels. To use the T-V LINK functions, you must have a T-V LINK compatible VCR connected by a SCART cable C to the EXT-2 terminal on the TV. For details about T-V LINK functions, see "T-V LINK functions" on page 7. Mains outlet (AC 220 - 240 V, 50 Hz) UHF aerial EXT-2 EXT-3 S L P E X T 4 R L AUDIO OUT EXT-1 R power Cord 75-ohm coaxial cable EXT-2 EXT-3 L R AUDIO OUT EXT-1 aerial plug 21-pin SCART Cable aerial plug 75-ohm coaxial cable To Aerial Input aerial plug AV IN/OUT terminal to aerial output s 3XWWLQJ#EDWWHULHV#LQWR#WKH#UHPRWH#FRQWURO Use two AAA/R03 dry cell batteries. Insert the batteries holding from the ó end, making sure the ô and ó terminals are correctly lined up. To open the battery compartment, slide the door downwards and lift off. Replace the door by sliding it upwards until it fastens into place. · Follow the warnings printed on the batteries. · Battery life is about six months to one year, depending on how much you use the remote control. · If the remote control does not work properly, fit new batteries. · The batteries we supply are only for setting up and testing your TV. Please replace them as soon as you need to. · Always use good-quality batteries. 7 Setting up your TV s ,QLWLDO#VHWWLQJV When the TV is first turned on, it goes into the initial setting mode, and you will see the JVC logo. Follow the instructions on the screen to make the initial settings. 1 Press the main power button on the TV The power lamp lights red (for power on), then green (for TV on) and the JVC logo is appears. · If the power lamp stays red and does not change to green: your TV is in the standby mode. Press the = (standby) button on the remote control to turn your TV on. · If the JVC logo does not appear this is because your TV has already been turned on for the first time: use the "LANGUAGE" and "AUTO PROGRAM" functions to make the initial settings. For details, see "INSTALL" on page 25. main power button power lamp 2 Press the 3 button The LANGUAGE menu appears. 1 4 7 2 5 8 0 3 6 9 AV P TV MENU OK 3 Press the ë buttons to choose ENGLISH The on-screen display will then be in English. P RM-C55 TV 8 Setting up your TV To receive SKY 1 you need a satelite tuner. You must have the satellite tuner set to SKY 1 before starting the AUTO PROGRAM function which follows. Note: · BBC1, BBC2, ITV, Channel 4 and Channel 5 are automatically set to programme numbers PR 1 to PR 5. SKY 1 is set to programme number PR 6, but no TV channel name (ID) is set. If the TV doesn't receive one of these TV channels, that programme number (PR) will not be set. · If a TV channel you want to view is not set to a programme number (PR), you can set it using the MANUAL function. For details, see "EDIT/MANUAL" on page 26. · The AUTO PROGRAM function does not set the programme number PR 0 (AV) for your video cassette recorder. You will need to set this using the MANUAL function. · In some areas you may get TV reception from more than one transmitter, for example different ITV regions. In this case each TV channel could be set twice. If this happens, the first set of channels will have the stronger signal. If you want to delete the second set of channels, you will have to do it manually (see page 28). 4 Press the 3 button to start the AUTO PROGRAM function The AUTO PROGRAM menu appears and the TV channels you receive are automatically stored in the programme numbers list (PR). To cancel the AUTO PROGRAM function: Press the 4 button. 5 After the TV channels have been registered in the programme numbers list (PR), the EDIT menu appears If you want to, you can now edit the programme numbers (PR) using the EDIT/MANUAL function. For details ...