COLOUR TELEVISION AV-32WFR1EK AV-28WFR1EK CONTENTS SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . 2 PREPARATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 T-V LINK FUNCTIONS . . . . . . . . . . . . . . . . . . . . . . . 7 BASIC OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . 8 REMOTE CONTROL BUTTONS AND FUNCTIONS . 11 MENU OPERATION . . . . . . . . . . . . . . . . . . . . . . . . 16 PICTURE SETTING. . . . . . . . . . . . . . . . . . . . . . . . . 17 PICTURE FEATURES . . . . . . . . . . . . . . . . . . . . . . . 18 SOUND SETTING . . . . . . . . . . . . . . . . . . . . . . . . . . 20 DIGITAL SURROUND . . . . . . . . . . . . . . . . . . . . . . . 21 HEADPHONE SURROUND . . . . . . . . . . . . . . . . . . 23 EXT SETTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 FEATURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 INSTALL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 DEMO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32 ADDITIONAL MENU OPERATIONS . . . . . . . . . . . . 33 ADDITIONAL PREPARATION. . . . . . . . . . . . . . . . . 36 TV BUTTONS AND PARTS. . . . . . . . . . . . . . . . . . . 38 TROUBLESHOOTING. . . . . . . . . . . . . . . . . . . . . . . 39 INSTRUCTIONS SPECIFICATIONS . . . . . . . . . . . . . . . . . . . Back cover Thank you for buying this colour television. To make sure your fully understand how to use your new TV, please read this manual thoroughly before you begin.  s TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. s DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or adaptor or consult your dealer. If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply. If a new mains plug has to be fitted, then follow the instruction given below: s TO ENSURE PERSONAL SAFETY, OBSERVE THE FOLLOWING RULES REGARDING THE USE OF THIS UNIT. 1 Operate only from the power source specified (AC 220 ­ 240 V, 50 Hz) on the unit. 2 Avoid damaging the AC plug and power cord. 3 Avoid improper installation and never position the unit where good ventilation is unattainable. When installing this television, distance recommendations must be maintained between the floor and wall, as well as instalment in a tightly enclosed area or piece of furniture. Please adhere to the minimum distance guidelines shown for safe operation. IMPORTANT DO NOT make any connection to the larger terminal which is marked with the letter E or by the safety earth symbol or coloured green or green-and-yellow. The wires in the mains lead on this product are coloured in accordance with the following code: Blue: Neutral Brown: Live As these colours may not correspond with the coloured marking identifying the terminals in your plug proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When replacing the fuse only a correctly rated approved type should be used and be sure to re-fit the fuse cover. 15 cm 10 cm 10 cm 15 cm 4 Do not allow objects or liquid into the cabinet openings. 5 In the event of a fault, unplug the unit and call a service technician. Do not attempt to repair it yourself or remove the rear cover. 6 For AV-32WFR1EK only: The surface of the TV screen is coated with a thin film, which can easily be damaged. Be very careful with it when handling the TV. Should the TV screen become soiled, wipe it with a soft dry cloth. Never rub it forcefully. Never use any cleaner or detergent on it. 7 When you don't use this TV set for a long period of time, be sure to disconnect the power plug from the AC outlet. 8 Do not hold the front panel door when moving the TV, if you do you may break it. IF IN DOUBT -- CONSULT A COMPETENT ELECTRICIAN. How To Replace The Fuse Open the fuse compartment with a blade screwdriver, and replace the fuse. Fuse s  This equipment has been designed and manufactured to comply with international safety standards. However, as with any electrical appliance, care must be taken to ensure optimal results and operational safety. · Before attempting to use this equipment, read the operating instructions thoroughly. · Ensure that all electrical connections (including the mains plug, extension leads, etc.) have been made in accordance with the manufacturer's instructions. · If ever in doubt about the installation, operation or safety of this equipment, consult your dealer. · Handle all glass panels or covers with care. · Never operate this equipment if it appears damaged or operates abnormally. Turn the power off, disconnect the main power plug and consult your dealer. · Never remove any affixed panels or covers. Doing so may result in electrical shock. · Never leave this equipment operating unattended unless otherwise specifically stated that it is designed to do so or in standby mode. Only use the designated power switch to turn off the power and ensure that all potential users are instructed how to do so. Make special arrangements for infirm or handicapped persons. · Never watch TV while operating a motor vehicle. It is illegal to watch TV while driving. · Never listen to headphones at high volume. Doing so may damage your hearing. · Never obstruct the ventilation of this equipment. Doing so may cause overheating and result in a malfunction or damage. · Never use makeshift stands or attempt to affix legs with wood screws. When using a manufacturer's approved stand or legs, use only the fixtures provided and follow the installation instructions. · Never allow this equipment to be exposed to rain or moisture. · Never allow anyone, especially children, to insert anything into an opening in the case. Doing so may result in a fatal electrical shock. · Never guess or take chances with electrical equipment of any kind. It is better to be safe than sorry. s  If connecting a VCR, follow A B C D. If not connecting a VCR, follow 1 2. AC Outlet (AC 220 - 240 V, 50 Hz) UHF Aerial *1: To operate T-V LINK functions, a T-V LINK compatible VCR must be connected to the EXT-2 terminal on the TV. For details about T-V LINK functions, see "T-V LINK FUNCTIONS" on page 7. Note: · For further details, refer to the manuals provided with the devices to be connected. · The connecting cables are not provided. · A video can be viewed from the VCR without performing C. For details, refer to your VCR instruction manual. · To connect additional external devices, please see "ADDITIONAL PREPARATION" on page 36. · To connect external speakers and audio system, please see "Connecting Speakers/Amplifier" on page 37. · When a decoder is connected to a T-V LINK compatible VCR, set the DECODER (EXT-2) function to ON. For details, see "Using the DECODER (EXT-2) function" on page 33. Otherwise, you will not be able to view scrambled channels. Power Cord *1 AUDIO OUT R L EXT-2 S EXT-3 S 75-ohm Coaxial Cable (8 ) SURROUND REAR EXT-1 Aerial Plug 21-pin SCART Cable Aerial Plug 75-ohm Coaxial Cable VCR To Aerial Input AV IN/OUT Terminal To Aerial Output Aerial Plug s   Use two AAA/R03 dry cell batteries. Insert the batteries from the end, making sure the and polarities are correct. To open the battery compartment, slide the door downwards and lift off. Replace the door by sliding it upwards until it is secure. Note: · Follow the warnings printed on the batteries. · Battery life is about six months to one year, depending on your frequency of use. · If the remote control does not work properly, replace the batteries. · The batteries we supply are only for setting up and testing your TV, please replace them as soon as necessary. · Always use good quality batteries. PREPARATION s When the TV is first turned on, it enters the initial setting mode, and the JVC logo is displayed. Follow the instructions on the on-screen display to make the initial settings. 1 Press the Main power button on the TV. The Power lamp lights red (for power on), then green (for TV on) and the JVC logo is displayed. Main power button Power lamp Note: · If the power lamp stays red and does not change to green: Your TV is in the standby mode. Press the (Standby) button on the remote control to turn your TV on. · The JVC logo does not appear when your TV has been turned on once. In this case, use the "LANGUAGE" and "AUTO PROGRAM" functions to make the initial settings. For details, see "INSTALL" on page 28. 1 4 7 2 5 8 0 3 6 9 AV 2 Press the button. The LANGUAGE menu appears. TV P MENU OK P 3 Press the buttons to choose ENGLISH. English is set for the on-screen display description. RM-C52 TV PREPARATION 4 Press the button to start the AUTO PROGRAM function. The AUTO PROGRAM menu appears and received TV channels are automatically registered in the Programme numbers (PR). To cancel the AUTO PROGRAM function: Press the button. 5 After the TV channels have been registered in the Programme numbers (PR), the EDIT menu appears. You can proceed to edit the Programme numbers (PR) using the EDIT/MANUAL function. For details, see "EDIT/MANUAL" on page 29. When not using the EDIT/MANUAL function: If you do not need to use the EDIT/MANUAL function, go to the next step. Note: · BBC1, BBC2, ITV, CHANNEL4 and CHANNEL 5 are automatically set to the Programme numbers PR 1 to PR 5. SKY 1 is set to the Programme number PR 6, but no TV channel name (ID) be set. If the TV doesn't receive one of these TV channels, that Programme number (PR) will not be set. · To receive SKY 1 a satelite tuner is needed. You must have the satelite tuner set to SKY 1 before starting the AUTO PROGRAM function. · If a TV channel you want to view is not set to a Programme number (PR), manually set it using the MANUAL function. For details, see "EDIT/MANUAL" on page 29. · The TV channel is not registered in Programme number PR 0 (AV). When you want to register a TV channel to PR 0 (AV), manually set it using the MANUAL function. For details, see "EDIT/MANUAL" on page 29. · In some areas TV reception is possible from more than one transmitter, e.g. different ITV regions. In this case each TV channel may be set twice. If this happens the first set of channels will have the stronger signal. If you want to delete the second set of channels, you will have to do it manually, see page 31. 6 Press the button to display the T-V LINK menu. If you have had any problems setting up your new TV, please call the Helpline at 0181-208-7654 Enjoy your new TV! 7 Operate the T-V LINK menu according to the type of a VCR connected to the EXT-2 terminal. When a T-V LINK compatible VCR is not connected: Press the button to exit the T-V LINK menu. The T-V LINK menu disappears. When a T-V LINK compatible VCR is connected: Follow the operating procedure "Downloading the data to VCR" on page 33 to transmit the Programme number (PR) data. 8 Now, the initial settings are complete, and you can watch the TV.  When a T-V LINK compatible VCR is connected to the EXT2 Terminal on the TV, it is easier to set up the VCR and to view videos. T-V LINK uses the following features: To use T-V LINK functions: A T-V LINK compatible VCR is necessary. The VCR must be connected to the EXT-2 terminal on the TV by a fully wired SCART cable. Note: · A "T-V LINK compatible VCR" means a JVC VCR with the T-V LINK logo or a VCR with one of the following logos. However, these VCRs may support some or all of the features described below. For details, refer to your VCR instruction manual. "Q-LINK" (a trademark of Panasonic Corporation) "Data Logic" (a trademark of Metz Corporation) "Easy Link" (a trademark of Phillips Corporation) "Megalogic" (a trademark of Grundig Corporation) "SMARTLINK" (a trademark of Sony Corporation) Note: · Operation via the TV is not possible. · Generally, the VCR cannot record a TV channel that cannot be received properly by the VCR's tuner, even though you can view that TV channel on the TV. However, some VCRs can record a TV channel by using the TV's output if that channel can be viewed on the TV, even though the TV channel cannot be received properly by the VCR's tuner. For details, refer to your VCR instruction manual. s  When the VCR starts playing, the TV automatically turns on and the images from EXT-2 terminal are displayed on the screen. When the VCR menu is operated, the TV automatically turns on and the images from EXT-2 terminal are displayed on the screen. Note: · This fun ...