CD-RECEIVER RECEPTEUR CD CD-RECEIVER KD-S656R/S653R Detachable KD-S656R 0 /ATT KS-S656R 35Wx4 ¢ SEL 4 7 8 9 10 11 12 SSM MO RND TP/RDS PTY SOUND RPT DISP AM FM CD 5 KD-S653R 0 /ATT KS-S653R 35Wx4 ¢ SEL 4 7 8 9 10 11 12 SSM MO RND TP/RDS PTY SOUND RPT DISP AM FM CD 5 For installation and connections, refer to the separate manual. Für den Einbau und die Anschlüsse siehe das eigenständige Handbuch. Pour l'installation et les raccordements, se référer au manuel séparé. Bijzonderheden over de installatie en aansluiting van het apparaat vindt u in de desbetreffende handleiding. INSTRUCTIONS BEDIENUNGSANLEITUNG MANUEL D'INSTRUCTIONS GEBRUIKSAANWIJZING LVT0148-001A [E] NEDERLANDS FRANÇAIS DEUTSCH CD RECEIVER ENGLISH Position And Reproduction Of Labels Bottom panel of the main unit DANGER: Invisible laser radiation when open and interlock failed or defeated. AVOID DIRECT EXPOSURE TO BEAM. (e) ADVARSEL:Usynlig laserstråling ved åbning, når sikkerhedsafbrydere erude af funktion. Undgåudsættelse for stråling. (d) VARNING:Osynlig laserstrålning när denna del är öppnadoch spärren är urkopplad. Betrakta ej strålen. (s) VARO: Avattaessa ja suojalukitus ohitettaessa olet alttiina näkymättömälle lasersäteilylle. Älä katso säteeseen. (f) Name/Rating plate IMPORTANT FOR LASER PRODUCTS Precautions: 1. CLASS 1 LASER PRODUCT 2. DANGER: Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam. 3. CAUTION: Do not open the top cover. There are no user-serviceable parts inside. Leave all servicing to qualified service personnel. 4. CAUTION: This CD player uses invisible laser radiation and is equipped with safety switches to prevent radiation emission when unloading CDs. It is dangerous to defeat the safety switches. 5. CAUTION: Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Caution: This product contains a laser component of higher laser class than Class 1. Note: For security reasons, a numbered ID card is provided with this unit, and the same ID number is imprinted on the unit's chassis. Keep the card in a safe place, as it will help the authorities to identify your unit if stolen. BEFORE USE * For safety.... · Do not raise the volume level too much, as this will block outside sounds, making driving dangerous. · Stop the car before performing any complicated operations. 2 *Temperature inside the car.... If you have parked the car for a long time in hot or cold weather, wait until the temperature in the car becomes normal before operating the unit. Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. BASIC OPERATIONS .................................................... 4 RADIO OPERATIONS ................................................... 5 Listening to the radio ..................................................................... 5 Storing stations in memory ............................................................ 6 FM station automatic preset:SSM ................................................ 6 Manual preset.............................................................................. 7 Tuning into a preset station ........................................................... 8 When an FM stereo broadcast is hard to receive ........................ 8 RDS OPERATIONS ....................................................... 9 What you can do with RDS EON .................................................. 9 Tracing the same programme automatically (Network-Tracking Reception) ................................................. 9 Using Standby Reception .......................................................... 11 Selecting Your Favorite Programme for PTY Standby Reception ............................................................ 12 Searching Your Favorite Programme.......................................... 12 Other convenient RDS functions ................................................. 15 Automatic selection of the station when using the number buttons ............................................ 15 Changing the display mode while listening to an FM station ..... 15 Setting the TA volume level ........................................................ 15 Automatic clock adjustment ...................................................... 16 CD OPERATIONS....................................................... 17 Playing a CD ................................................................................. 17 Locating a track or a particular portion on a CD ..................... 18 Selecting CD playback modes ...................................................... 19 Prohibiting CD ejection ............................................................... 19 SOUND ADJUSTMENTS ............................................. 20 Selecting preset sound modes ...................................................... 20 Adjusting the sound ...................................................................... 21 Storing your own sound adjustments ......................................... 22 OTHER MAIN FUNCTIONS ......................................... 23 Setting the clock ............................................................................ 23 Changing the general settings ...................................................... 25 Detaching the control panel ......................................................... 26 MAINTENANCE ......................................................... 27 Handling CDs ................................................................................ 27 TROUBLESHOOTING .................................................28 SPECIFICATIONS ....................................................... 29 3 ENGLISH CONTENTS BASIC OPERATIONS 1 Note: When you use this unit for the first time, set the built-in clock correctly, see page 23. 3 2 Turn on the power. 1 Note on One-Touch Operation: When you select a source in step 2 below, the power automatically comes on. You do not have to press this button to turn on the power. 2 AM FM CD Select the source. To operate the tuner, see pages 5 ­ 16. To operate the CD player, see pages 17 ­ 19. 3 Adjust the volume. Volume level indicator Volume level appears. 4 Adjust the sound as you want (see pages 20 ­ 22). To drop the volume in a moment Press briefly while listening to any source. "ATT" starts flashing on the display, and the volume level will drop in a moment. To resume the previous volume level, press the button briefly again. To turn off the power Press and hold 4 for more than 1 second. RADIO OPERATIONS ENGLISH Listening to the radio 2 1 Select the band (FM1, FM2, FM3 or AM). You can select any one of FM1, FM2, and FM3 to listen to an FM station. 1 AM AM FM FM1 FM2 FM3 2 SSM To search stations of higher frequencies. To search stations of lower frequencies. Start searching a station. When a station is received, searching stops. To stop searching before a station is received, press the same button you have pressed for searching. To tune in a particular frequency without searching: 1 Select the band (FM or AM). Press FM or AM. 2 Press and hold ¢ or 4 until "M" starts flashing on the display. Now you can manually change the frequency while "M" is flashing. 3 Press ¢ or 4 repeatedly until the frequency you want is reached. · If you hold down the button, the frequency keeps changing (in 50 kHz intervals for FM and 9kHz intervals for AM-MW/LW) until you release the button. 5 Storing stations in memory You can use one of the following two methods to store broadcasting stations in memory. · Automatic preset of FM stations:SSM (Strong-station Sequential Memory) · Manual preset of both FM and AM stations FM station automatic preset:SSM You can preset 6 local FM stations in each FM band (FM1, FM2, and FM3). 2 1 Select the FM band number (FM1, FM2 or FM3) you want to store FM stations into. FM1 FM2 FM3 1 FM 2 SSM Press and hold both buttons for more than 2 seconds. "SSM" appears, then disappears when automatic preset is over. Local FM stations with the strongest signals are searched and stored automatically in the band number you have selected (FM1, FM2 or FM3). These stations are preset in the number buttons -- No. 1 (lowest frequency) to No. 6 (highest frequency). When automatic preset is over, the station stored in number button 1 will be automatically tuned in. 6 Manual preset You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually. EXAMPLE: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band 23 1 Select the FM1 band. 1 FM 2 SSM Tune into a station of 88.3 MHz. See page 5 to tune into a station. 3 1 2 Press and hold the button for more than 2 seconds. "P1" flashes for a few seconds. 4 Repeat the above procedure to store other stations into other preset numbers. Notes: · A previously preset station is erased when a new station is stored in the same preset number. · Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again. 7 ENGLISH Tuning into a preset station You can easily tune into a preset station. Remember that you must store stations first. If you have not stored them yet, see pages 6 and 7. 2 1 Select the band (FM1, FM2, FM3 or AM) you want. 1 AM AM FM FM1 FM2 FM3 2 1 2 3 4 5 6 Select the number (1 ­ 6) for the preset station you want. When an FM stereo broadcast is hard to receive MO/RND Press MO/RND (Mono/Random) while listening to an FM stereo broadcast. The "MO" (Mono) indicator lights up on the display. The sound you hear becomes monaural but reception will be improved. Lights up when receiving an FM broadcast in stereo. To restore the stereo effect, press the same button again. 8 RDS OPERATIONS RDS (Radio Data System) allows FM stations to send an additional signal along with their regular programme signals. For example, the stations send their station names, as well as information about what type of programme they broadcast, such as sports or music, etc. Another advantage of RDS function is called "EON (Enhanced Other Networks)." The EON indicator lights up while receiving an FM station with the EON data. By using the EON data sent from a station, you can tune into a different station of a different network broadcasting your favorite programme or traffic announcement while listening to another programme or to another source such as CD. By receiving the RDS signals, this unit can do the following: · Tracing the same programme automatically (Network-Tracking Reception) · Standby Reception of TA (Traffic Announcement) or your favorite programme · PTY (Programme Type) search · TA (Traffic Announcement) search · And some other functions Tracing the same programme automatically (NetworkTracking Reception) When driving in an area where FM reception is not good, the tuner built in this unit automatically tunes in another RDS station, broadcasting the same programme with stronger signals. So, you can continue to listen to the same programme in its finest reception, no matter where you drive. (See the illustration on the next page.) Two types of the RDS signals are used to make Network-Tracking Reception work correctly -- PI (Programme Identification) and AF (Alternative Frequency) data. Without receiving these data correctly from the RDS station you are listening to, NetworkTracking Reception will not operate. To use Network-Tracking Reception, Press and hold TP/RDS (Traffic Programme/Radio Data System) for more than 1 second. Each time you press and hold the button, Network-Tracking Reception modes change as follows: TP/RDS Mode 1 Mode 2 Mode 3 9 ENGLISH What you can do with RDS EON Mode 1 (AF: on / REG: off) Network-Tracking is activated with Regionalization set to "off." Switches to another station within the same network when the receiving signals from the current station become weak. Note: In this mode, the programme may differ from the one currently received. Mode 2 (AF: on / REG: on) Network-Tracking is activated with Regionalization set to "on." Switches to another station, within the same network, broadcasting the same programme when the receiving signals from the current station become weak. Mode 3 (AF: off / REG: off) Network-Tracking is deactivated. The same programme can be received on different frequencies. Programme 1 broadcasting on frequency E Programme 1 broadcasting on frequency A Programme 1 broadcasting on frequency B Programme 1 broadcasting on frequency C Programme 1 broadcasting on frequency D 10 Using Standby Reception ENGLISH 11 Standby Reception allows the unit to switch temporarily to your fav ...