MICRO COMPONENT SYSTEM UX-J60-- Consists of CA-UXJ60 and SP-UXJ60 UX-J50-- Consists of CA-UXJ50 and SP-UXJ50 RM-SUXJ60R REMOTE CONTROL SP-UXJ60 CA-UXJ60 SP-UXJ60 RM - SUXJ50R REMOTE CONTROL SP-UXJ50 CA-UXJ50 SP-UXJ50 INSTRUCTIONS For Customer Use: Enter below the Model No. and Serial No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference. Model No. Serial No. GVT0102-008A [B] Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply. If this product is not supplied fitted with a mains plug then follow the instructions given below: IMPORTANT: DO NOT make any connection to the terminal which is marked with the letter E or by the safety earth symbol or coloured green or green-and-yellow. The wires in the mains lead on this product are coloured in accordance with the following code: Blue : Neutral Brown : Live As these colours may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. IF IN DOUBT--CONSULT A COMPETENT ELECTRICIAN. 2 WARNING LABEL INSIDE THE UNIT CAUTION: Invisible laser radiation when open and interlock failed or defeated. AVOID DIRECT EXPOSURE TO BEAM. (e) ADVARSEL: Usynlig laserstråling ved åbning, når sikkerhedsafbrydere er ude af funktion. Undgå udsættelse for stråling (d) VARNING: Osynlig laserstrålning när denna del är öppnad och spärren är urkopplad. Betrakta ej strålen. (s) VARO: Avattaessa ja suojalukitus ohitettaessa olet alttiina näkymättömälle lasersäteilylle. Älä katso säteeseen. (f) REPRODUCTION OF LABELS 1 CLASSIFICATION LABEL ON EXTERIOR SURFACE 1. CLASS 1 LASER PRODUCT 2. CAUTION: Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam. 3. CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel. CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture. CAUTION CAUTION--STANDBY/ON button! Disconnect the mains plug to shut the power off completely (the STANDBY/ON lamp goes off). The STANDBY/ON button in any position does not disconnect the mains line. · When the unit is on standby, the STANDBY/ON lamp lights red. · When the unit is turned on, the STANDBY/ON lamp lights green. The power can be remote controlled. · Do not block the ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.) · Do not place any naked flame sources, such as lighted candles, on the apparatus. · When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must be followed strictly. · Do not expose this apparatus to rain, moisture, dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. CAUTION: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1 Front: No obstructions and open spacing. 2 Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3 Bottom: Place on a level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. Front View 1 cm 15 cm 15 cm 1 cm 15 cm Side View 15 cm 15 cm UX-J60 UX-J50 10 cm UX-J60/UX-J50 G-1 SAFETY INSTRUCTIONS "SOME DOS AND DON'TS ON THE SAFE USE OF EQUIPMENT" This equipment has been designed and manufactured to meet international safety standards, but like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and interconnections between pieces of equipment) are properly made and in accordance with the manufacturer's instructions. Switch off and withdraw the mains plug when making or changing connections. Do consult your dealer if you are ever in doubt about the installation, operation or safety of your equipment. Do be careful with glass panels or doors on equipment. DON'T continue to operate the equipment if you are in any doubt about it working normally, or if it is damaged in any way --switch off, withdraw the mains plug and consult your dealer. DON'T remove any fixed cover as this may expose dangerous voltages. DON'T leave equipment switched on when it is unattended unless it is specifically stated that it is designed for unattended operation or has a standby mode. Switch off using the switch on the equipment and make sure that your family know how to do this. Special arrangements may need to be made for infirm or handicapped people. DON'T use equipment such as personal stereos or radios so that you are distracted from the requirements of traffic safety. It is illegal to watch television whilst driving. DON'T listen to headphones at high volume as such use can permanently damage your hearing. DON'T obstruct the ventilation of the equipment, for example with curtains or soft furnishings. Overheating will cause damage and shorten the life of the equipment. DON'T use makeshift stands and NEVER fix legs with wood screws--to ensure complete safety always fit the manufacturer's approved stand or legs with the fixings provided according to the instructions. DON'T allow electrical equipment to be exposed to rain or moisture. ABOVE ALL -- NEVER let anyone, especially children, push anything into holes, slots or any other opening in the case--this could result in a fatal electrical shock. -- NEVER guess or take chances with electrical equipment of any kind--it is better to be safe than sorry! G-2 Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. About This Manual This manual is organized as follows: · The manual mainly explains operations using the buttons on the remote control. You can use the buttons both on the remote control and on the main unit for the same operations if they have the same or similar names (or marks), unless mentioned otherwise. The illustrations used in this manual are of UX-J60 unless mentioned otherwise. · Basic and common information that is the same for many functions is grouped in one place, and is not repeated for each procedure. For instance, we do not repeat the information about turning on/off the unit, setting the volume, changing the sound effects, and others, which are explained in the section "Common Operations" on pages 9 to 11. · The following symbols are used in this manual: Gives you warning and caution to prevent damage or risk of fire/electric shock. Furthermore, it gives you information about what is not good for obtaining the best possible performance from the unit. Gives you information and hints you should know. Power sources · When unplugging the unit from the wall outlet, always pull on the plug, not the AC power cord. DO NOT handle the AC power cord with wet hands. Moisture condensation Moisture may condense on the lens inside the unit in the following cases: · After starting heating in the room · In a damp room · If the unit is brought directly from a cold to a warm place Should condensation occur, the unit may malfunction. In this case, leave the unit turned on for a few hours until the moisture evaporates, unplug the AC power cord, then plug it in again. Others · Should any metallic object or liquid fall into the unit, unplug the power cord and consult your dealer before operating any further. · If you are not going to operate the unit for an extended period of time, unplug the AC power cord from the wall outlet. DO NOT disassemble the unit since there are no user serviceable parts inside. Precautions Installation · Install in a place which is level, dry and neither too hot nor too cold--between 5°C and 35°C. · Install the unit in a location with adequate ventilation to prevent internal heat buildup in the unit. · Leave sufficient distance between the unit and the TV. · Keep the speakers away from the TV to avoid interference with TV. DO NOT install the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or vibration. If anything goes wrong, unplug the AC power cord and consult your dealer. 1 Contents Location of the Buttons and Control ..................................... 3 Front Panel ........................................................................................... 3 Remote Control .................................................................................... 5 Getting Started ........................................................................ 6 Supplied Accessories ............................................................................ 6 Putting the Batteries into the Remote Control ..................................... 6 Connecting Antennas ........................................................................... 6 Connecting Speakers ............................................................................ 7 Connecting Other Equipment ............................................................... 8 Common Operations ............................................................... 9 Setting the Clock .................................................................................. 9 Turning On the Power .......................................................................... 9 Adjusting the Volume ......................................................................... 10 Enjoying Sound Effects ...................................................................... 10 Selecting the Illumination Brightness ................................................ 11 Selecting the Display Color (ONLY FOR UX-J60) ........................... 11 Listening to FM and AM (MW) Broadcasts ....................... 12 Tuning in to a Station ......................................................................... 12 Presetting Stations .............................................................................. 12 Tuning in to a Preset Station .............................................................. 13 Receiving FM Stations with RDS ...................................................... 13 Changing the RDS Information ......................................................... 14 Searching for Programs by PTY Codes (PTY Search) ...................... 14 Switching Temporarily to a Program Type of Your Choice ............... 15 Playing Back Discs ................................................................ 16 Playing Back the Entire Disc--Normal Play ..................................... 16 Basic Disc Operations ........................................................................ 17 Programming the Playing Order of the Tracks --Program Play ............................................................................ 17 Playing at Random--Random Play ................................................... 18 Repeating Tracks--Repeat Play ......................................................... 18 Prohibiting Disc Ejection--Tray Lock .............................................. 18 Playing Back Tapes ................................................................ 19 Playing Back a Tape ........................................................................... 19 Recording ............................................................................... 20 Recording on a Tape ........................................................................... 20 Disc Direct Recording ........................................................................ 21 One Track Recording ......................................................................... 21 Using the Timers .................................................................... 22 U ...