Stage Piano MP4 Owner's Manual Important Safety Instructions SAVE THESE INSTRUCTIONS INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS WARNING CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. AVIS : RISQUE DE CHOC ELECTRIQUE The lighting flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. - NE PAS OUVRIR. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the leterature accompanying the product. Examples of Picture Symbols denotes that care should be taken. The example instructs the user to take care not to allow fingers to be trapped. denotes a prohibited operation. The example instructs that disassembly of the product is prohibited. denotes an operation that should be carried out. The example instructs the user to remove the power cord plug from the AC outlet. Read all the instructions before using the product. WARNING - When using electric products, basic precautions should always be followed, including the following. potential could result in death WARNING Indicates ainjury if thehazard thathandled incorrectly. or serious product is The product should be connected to an AC outlet of the specified voltage. 120V 230V 240V G If you are going to use an AC power cord, make sure that its has the correct plug shape and conforms to the specified power voltage. G Failure to do so may result in fire. Do not insert or disconnect the power cord plug with wet hands. Doing so may cause electric shock. When using the headphones, do not listen for long periods of time at high volume levels. Doing so may result in hearing problems. Do not disassemble, repair or modify the product. Doing so may result in product breakdown, electric shock or short-circuit. 2 When disconnecting the AC power cord's plug, always hold the plug and pull it to remove it. The product is not completely disconnected from the power supply even when the power switch is turned off. If the product will not be used for a long time, unplug the AC power cord from the AC outlet. G Pulling the AC power cord itself may damage the cord, causing a fire, electric shock or short-circuit. G Failure to do so may cause fire in case of lightning. G Failure to do so may over-heat the product, resulting in fire. potential hazard that or damage CAUTION Indicates a to the product or othercould result in injury Do not use the product in the following areas. G Areas, such as those near windows, where the product is exposed to direct sunlight G Extremely hot areas, such as near a heater G Extremely cold areas, such as outside G Extremely humid areas G Areas where a large amount of sand or dust is present G Areas where the product is exposed to excessive vibrations Using the product in such areas may result in product breakdown. Use the product only in moderate climates (not in tropical climates). Before connecting cords, make sure that the power to this product and other devices is turned OFF. Take care not to allow any foreign matter to enter the product. OFF Failure to do so may cause breakdown of this product and other devices. Entry of water, needles or hair pins may result in breakdown or short-circuit. The product shall not be exposed to dripping or splashing. No objects filled with liquids, such as vases, shall be placed on the product. Please lift up the product when moving it. Please note that the product is heavy and must be carried by more than two persons. Dropping the product may result in breakdown. Do not drag the product on the floor. Take care not to drop the product. Do not place the product near electrical appliances such as TVs and radios. G Doing so may cause the product to generate noise. G If the product generates noise, move the product sufficiently away from the electrical appliance or connect it to another AC outlet. Failure to do so may damage them, resulting in fire, electric shock or short-circuit. When connecting the AC power cord and other cords, take care not to get them tangled. Do not wipe the product with benzene or thinner. G Doing so may result in discoloration or deformation of the product. G When cleaning the product, put a soft cloth in lukewarm water, squeeze it well, then wipe the product. Do not stand on the product or exert excessive force. G Doing so may cause the product to become deformed or fall over, resulting in breakdown or injury. The product should be located so that its location or position does not interfere with its proper ventilation. Ensure a minimum distance of 5cm around the product for sufficient ventilation. Ensure that the ventilation is not impeded by covering the ventilation openings with items, such as newspaper, table-cloths, curtains, etc. 3 Do not place naked flame sources, such as lighted candles on the product. The product should be serviced by qualified service personnel when: G The power supply cord or the plug has been damaged. G Objects have fallen, or liquid has been spilled into the product. G The product has been exposed to rain. G The product does not appear to operate normally or exhibits a marked change in performance. G The product has been dropped, or the enclosure damaged. Notes on Repair Should an abnormality occur in the product, immediately turn the power OFF, disconnect the power cord plug, and then contact the shop from which the product was purchased. GROUNDING INSTRUCTIONS This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an eqipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. DANGER - Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the product is properly grounded. Do not modify the plug provided with the product - if it will not fit the outlet, have a proper outlet installed by a qualified electrician. Declaration of Conformity according to FCC Part 15 Responsible Party: Kawai America Corporation Address: 2055 East University Drive, Rancho Dominguez, CA 90220 Telephone: (310) 631-1771 declares that the product: Stage Piano MP4 complies with Part 15 of the FCC Rules. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interferenc, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a different electrical circuit from the receiver. - Consult the dealer or an experienced radio/TV technician for help. FCC WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Canadian Radio Interference Regulations This instrument complies with the limits for a class B digital apparatus, pursuant to the Radio Interference Regulations, C.R.C., c. 1374. 4 WELCOME TO THE MP4 Thank you for purchasing the KAWAI MP4. The MP4 Stage Piano features 64 Internal Sounds of the highest quality. The MP4 can also be used as a MIDI master controller. On stage, at home, or in the studio, the MP4 has been designed to offer quick and easy access to many sophisticated features. BASIC FEATURES of the MP4 4 ASSIGNABLE ZONES The MP4 keyboard can be divided into 4 zones. Each zone can be set to INT, EXT or BOTH individually. INT (Internal) is to play any of the 64 internal sounds. EXT (External) is to play external MIDI devices. BOTH is to play internal sounds and external MIDI devices at the same time. Each zone can be played individually, or multiple zones can be freely split, layered and velocity switched to create stunning and personalized performances. ACOUSTIC TOUCH KEYBOARD The MP4's Advanced Hammer Action IV keyboard provides excellent feel and control like that found in an acoustic piano. 64 INTERNAL SOUNDS, 64 SETUPS The MP4 offers not only acoustic piano and electric piano sounds, but also other sounds such as organ, brass, pads and so on. All the settings of these sounds, together with the settings to control the external devices, can be stored into 64 setups. REVERB AND EFFECTS The MP4 offers 7 high quality REVERB types, and 20 different EFFECT types to improve acoustical realism and enhance tonal quality. CONTROL KNOBS The MP4 has 4 multi-function CONTROL KNOBS, which offer real time control of the EFFECTS, EQ, TONE MODIFY and MIDI-CONTROL CHANGE messages. 5 TABLE OF CONTENTS WELCOME TO THE MP4.....5 1. NAMES AND FUNCTIONS.....8 1.1 FRONT PANEL.....8 1.2 REAR PANEL.....10 2. Basic Operations.....12 2.1 Getting Ready.....12 2.2 Selecting a Sound.....12 2.3 Layer.....13 2.4 Split.....13 2.5 Piano Only.....14 2.6 Metronome.....14 2.7 Transpose.....15 2.8 Using the MP4 as a MIDI controller.....15 2.9 Selecting a SETUP.....16 3. SW Button.....17 3.1 Panel Lock.....17 3.2 Touch Curve.....17 3.3 Rotary Slow/Fast.....17 3.4 EQ Bypass On/Off.....18 3.5 Wheel Lock.....18 3.6 Foot Switch Lock.....19 3.7 Expression Pedal Lock.....19 3.8 External Sequencer Start/Stop.....20 6.2.9 Bank MSB/LSB (Ext only).....31 6.2.10 Key Range Hi/Lo .....31 6.2.11 Velocity Switch.....32 6.2.12 Velocity Switch Value.....32 6.2.13 Velocity Compression.....32 6.2.14 Velocity Offset.....33 6.2.15 Zone Transpose.....33 6.2.16 Transmitting Volume (Ext only).....33 6.2.17 Volume.....33 6.2.18 Transmitting Control Change.....33 6.2.19 Pan.....33 6.2.20 Fine Tune.....34 6.2.21 Damper.....34 6.2.22 Foot Switch.....34 6.2.23 Expression Pedal.....34 6.2.24 Modulation.....34 6.2.25 Bender.....34 6.2.26 Transmitting Bender Range (Ext only).....34 6.2.27 Bender Range.....35 6.2.28 Solo.....35 6.2.29 Solo Mode.....35 6.3 Common Parameters.....35 6.3.1 Stretch Tuning.....35 6.3.2 Temperament.....36 6.3.3 Key of Temperament.....36 6.3.4 Tuning C-B.....36 6.3.5 FSW Control Cahnge Number.....37 6.3.6 EXP Control Change Number.....37 6.3.7 Master Volume.....37 7. STORE.....38 4. EFX/REVERB.....21 4.1 EFX.....21 4.2 REVERB.....22 5. Control Knobs.....23 5.1 EFFECT.....23 5.2 EQ (EQUALIZER).....24 5.3 TONE MODIFY.....24 5.4 MIDI CC# (Control Change).....25 7.1 Storing the settings as a SETUP.....38 8. SYSTEM.....39 8.1 System Menu.....39 8.2 System Parameters.....39 8.2.1 System Channel.....39 8.2.2 Touch .....40 8.2.3 System Tuning.....41 8.2.4 Volume Slider Action.....41 8.2.5 Local Control.....41 8.2.6 Multi-Timbral Mode.....41 8.2.7 Receive Channel.....41 8.2.8 LCD Contrast.....42 8.2.9 LED Brightness.....42 8.2.10 Out Mode.....42 6. MENU.....28 6.1 Editing Procedure and Parameters.....29 6.2 Edit Parameters.....29 6.2.1 Zone Mode.....29 6.2.2 Sound (Int only).....29 6.2.3 Voicing (Int Piano only).....29 6.2.4 Pedal Effect (Int Piano only).....30 6.2.5 TX Ch (Ext only).....30 6.2.6 TX Prg # (Ext only).....30 6.2.7 Prg # (Ext only).....30 6.2.8 TX Bank (Ext only).....31 8.3 System Dump.....42 8.3.1 Dump Current.....42 8.3.2 Dump All.....42 8.4 System Rest.....43 8.4.1 Reset One SETUP.....43 8.4.2 Reset All.....43 6 9. OTHER.....44 9.1 MIDI IN.....44 9.2 SETUP Program Number Table.....44 9.3 SOUND Program Number List.....45 9.4 Notes about USB.....46 Specifications.....47 MP4 MIDI Implementation.....48 1. Recognized Data.....49 1.1 Channel Voice Message.....49 1.2 Channel Mode Message.....51 1.3 System Realtime Message.....52 2. Transmitted ...