GRAPHIC EQUALIZER G-EQ300 INSTRUCTION MANUAL KENWOOD CORPORATION B60-3538-08 KO (K,P,Y,C,M,X,T) MC 97/12 11 10 9 8 7 6 5 4 3 2 1 96/12 11 10 9 8 7 5 Introduction G-EQ300 (En/K) 2 Before applying power Units are designed for operation as follows. Caution : Read this section carefully to ensure safe operation. U.S.A. and Canada ................................................................................................................................................................ AC 120 V only Australia ................................................................................................................................................................................. AC 240 V only China........................................................................................................................................................................................ AC 220 V only U.K. and Europe ..................................................................................................................................................................... AC 230 V only *Other countries ............................................................................................................................... AC 110-120 / 220-240 V switchable *AC voltage selection The AC voltage selector switch on the rear panel is set to the voltage that prevails in the area to which the unit is shipped. Before connecting the power cord to your AC outlet, make sure that the setting position of this switch matches your line voltage. If not, it must be set to your voltage in accordance with the following direction. AC voltage selector switch VOLTAGE SELECTOR AC 110 - 120V ` AC 220 - 240V ` Note Note: Our warranty does not cover damage caused by excessive line voltage due to improper setting of the AC voltage selector switch. VOLTAGE SELECTOR AC 110 - 120V ` AC 220 - 240V ` Move switch lever to match your line voltage with a small screwdriver or other pointed tool. For the United Kingdom Factory fitted moulded mains plug 1. The mains plug contains a fuse. For replacement, use only a 13- Amp ASTA-approved (BS1362) fuse. 2. The fuse cover must be refitted when replacing the fuse in the moulded plug. 3. Do not cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appro priate safety approved extension lead or adapter, or consult your dealer.If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply. IMPORTANT : The wires in the mains lead are coloured in accordance with the following code : Blue: Neutral Brown : Live Do not connect those leads to the earth terminal of a three - pin plug. Safety precautions CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN Caution : Read this section carefully to ensure safe operation. WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS. THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE. Introduction G-EQ300 (En/K) Special features Large FL display, 14-band equalizer and 27-spectrum analyzer MANUAL/REFERENCE modes MANUAL: REFERENCE: Five preset patterns have been factory-preset for this mode, too. In this mode, it is also possible to preset (assign) equalizer patterns created by the user in place of the factory presets. @ Five exemplary patterns have been preset at the factory. # Equalizer curves can be created by setting up to 3 center frequencies and the equalizing levels for them. % The equalizer curve can be adjusted in a detailed way for every frequency range. It is also possible to fine-adjust a curve which has been created in the PARAMETRIC mode. The GRAPHIC mode is to be used when detailed adjustment of acoustic compensation is required. & The large FL display, 14-band equalizer and 27-spectrum analyzer features high visibility of information and make it possible to set EQ (equalizer) curves with high accuracy. 3 PARAMETRIC/GRAPHIC modes PARAMETRIC: GRAPHIC: GENRE mode A total of 30 playback patterns have been factory-preset by combining five recommended equalizer patterns with six music genres, so that any of them can be selected by actually comparing them. Similarly, selection from 30 types of recording patterns for playback on car stereo or from 30 types of recording patterns for playback on headphone stereo is also available. Select the optimum equalizer pattern according to the music genre and purpose of use of the pattern. ( Contents Caution : Read the pages marked carefully to ensure safe operation. Introduction .................................................................................. 2 3Before applying power.............................................................. 2 3Safety precautions .................................................................... 2 Special features ........................................................................ 3 3Contents .................................................................................... 3 Accessories ............................................................................... 3 3IMPORTANT SAFEGUARDS ....................................................... 4 Before operation .......................................................................... 6 Safety precautions .................................................................... 6 Maintenance ............................................................................. 6 Names and functions of parts ................................................... 7 System connections .................................................................... 8 About the system control connections ..................................... 9 Display ......................................................................................... 10 Switching the display modes.................................................. 10 Accessories Check that the following accessories are present. Audio cord (2) System control cord (1) Demonstration method ........................................................... 11 Operation of graphic equalizer ............................................... 12 Operation of MANUAL feature ............................................... 12 Operation of REFERENCE feature ........................................... 13 Equalizer pattern list ............................................................... 14 Creation of desired equalizer patterns .................................. 15 Operation in PARAMETRIC mode ........................................... 15 Operation in GRAPHIC mode .................................................. 17 Registration of EQUALIZER pattern ........................................ 18 Operation of GENRE feature ................................................... 19 REVERSE key ........................................................................... 20 Use of equalizer effect with tape ........................................... 21 Applying equalizer effect to tape playback ............................ 21 Tape recording of sound with equalizer effect ....................... 22 Functions of the graphic equalizer ......................................... 23 In case of difficulty .................................................................... 24 3Specifications ............................................................................ 25 * AC plug adaptor (1) * Use to adapt the plug on the power cord to the shape of the wall outlet. (Accessory only for regions where use is necessary.) IMPORTANT SAFEGUARDS 3Caution : Read this page carefully to ensure safe operation. G-EQ300 (En/K) 4 Please read all of the safety and operating instructions before operating this appliance. Adhere to all warnings on the appliance and in the instruction manual. Follow all the safety and operating instructions. These safety and operating instructions should be retained for future reference. 1. Power sources ­ The appliance should be connected to a power supply only of the type described in the instruction manual or as marked on the appliance. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company. For appliances intended to operate from battery power, or other sources, refer to the instruction manual. 2. Power-cord protection ­ Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, pay particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. Never pull or stretch the cord. 6. Temperature ­ The appliance may not function properly if used at extremely low, or freezing temperatures. The ideal ambient temperature is above +5°C (41°F). 7. Heat ­ The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including amplifiers) that produce heat. 8. Electric shock ­ Care should be taken so that objects do not fall and liquid is not spilled into the enclosure through openings. If a metal objects, such as a hair pin or a needle, comes into contact with the inside of this appliance, a dangerous electric shock may result. For families with children, never permit children to put anything, especially metal, inside this appliance. 9. Enclosure removal ­ Never remove the enclosure. If the internal parts are touched accidentally, a serious electric shock might occur. 3. CAUTION ­ Polarization ­ This appliance may be equipped with a polarized alternating-current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug. 4. Ventilation ­ Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the appliance and to protect it from overheating, and these openings must not be blocked or covered. The appliance should be situated so that its location or position does not interfere with its proper ventilation. To maintain good ventilation, do not put records or a table-cloth on the appliance. Place the appliance at least 10 cm away from the walls. Do not use the appliance on a bed, sofa, rug or similar surface that may block the ventilation openings. This appliance should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. 10.Magnetic fields ­ Keep the appliance away from sources of magnetic fields such as TV sets, speaker systems, radios, motorized toys or magnetized objects. 11.Cleaning ­ Unplug this appliance from the wall outlet before cleaning. Do not use volatile solvents such as alcohol, paint thinner, gasoline, or benzine, etc. to clean the cabinet. Use a clean dry cloth. 12.Accessories ­ Do not place this appliance on an unstable cart, stand, tripod, bracket, or table. The appliance may fall, causing serious injury to a child or adult, and serious damage to the appliance. Use only with a cart, stand, tripod, bracket, or table recommended by the manufacturer, or sold with the appliance. Any mounting of the appliance should follow the manufacturer's instructions, and should use a mounting accessory recommended by the manufacturer. An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn. 5. Water and moisture ­ The appliance should not be used near water - for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. IMPORTANT SAFEGUARDS 3Caution : Read this page carefully to ensure safe operation. 13.Lightning ­ For added protection for this appliance during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable syst ...