INSTALLATION INSTRUCTIONS BATTERY SAVER FILTER Model 091-137 Typical Installation single filter, 3 amp or less load. 3 ampere IN OUT BATTERY SAVER + - + - LOAD BATTERY SAVER FILTER BATTERY SAVER FILTER Model 091-137 Model 091-137 Typical Installation 6 ampere load 2 filters in parallel + 6 AMPERE LOAD IN OUT IN OUT BATTERY SAVER + - 1. The Model 091-137 Battery Saver Filter is designed to filter the full wave rectified, unfiltered D.C. Output of the Battery Saver. The output is a low ripple 13.8 VDC. 2. Install the filter in a convenient, dry location and wire as illustrated in the diagram above. Use #18 AWG minimum wire size for wire runs up to 15 feet. Longer distances require a larger wire size. 3. Note that the maximum current capacity of the filter is 3 amps. For higher currents use 2 or more filters may be connected in parallel. SINCE 1967, DESIGNERS OF INNOVATIVE PRODUCTS KUSSMAUL ELECTRONICS COMPANY, INC. 170 CHERRY AVENUE, WEST SAYVILLE, NEW YORK, 11796-1221 USA TEL. In NY: 631 567-0314 FEB. 7, 2003 TOLL FREE: 800 346-0857 FAX: 631 567-5826 ...