SAFETY LOCK 4 ANTI-THEFT DEVICE A CONTROLLER THAT PERMITS UNATTENDED ENGINE OPERATION BUT PREVENTS UNAUTHORIZED USE OF VEHICLE PERMITS ENGINE TO RUN WITH THE IGNITION KEY REMOVED ENGINE STOPS AND CANNOT BE RESTARTED IF ATTEMPT IS MADE TO DRIVE AWAY MODEL #091-160 This simple, low cost controller bypasses the ignition switch when activated by the closure of a momentary switch. The operator may then remove the ignition key without shutting the engine down. Movement of the vehicle is prohibited by interlocking the SAFETY LOCK 4 with the brake light switch, a neutral safety switch on the gearshift or a parking brake operated switch. Operating any one of these will cause the relays in the SAFETY LOCK 4 to drop out and interrupt the ignition circuit to stop the engine. The authorized operator need only insert the key and turn on the ignition to operate the vehicle. With the key in the lock and turned on, the ignition circuit is completed as normal and the opening of the SAFETY LOCK 4 relays has no effect on engine operation. The SAFETY LOCK 4 contains 4 relays to permit energizing 3 auxiliary circuits in addition to the ignition switch bypass. 5.25 3/16" DIA. SPECIFICATIONS: Volts: 12 volts, D.C. Relay Contacts: Normally open, 30 Amps. Weight: 4 ounces Enclosure: Unsealed 4,75 1.50 3.00 OUTLINE DRAWING KUSSMAUL ELECTRONICS COMPANY, INC. 170 CHERRY AVE., WEST SAYVILLE, NY 11796 TELEPHONE in NY: 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826 E-MAIL: sales@kussmaul.com The common terminal of Relay K1 must be connected to the +12 volt power for the unit to operate +12 volt Power IGNITION SWITCH To Ignition System Output #2 K1 COM. K2 N.C. N.O. N.C. N.O. COM. Output #3 Output #4 +12 V K4 N.C. N.O. COM. K3 N.C. N.O. COM. r to ity ca lar g di o In e p llin D rv ta LE se ins b O hen W SET PUSHBUTTON Brake Light Switch This line resets Brake Light 12345 S1 (bypasses ignition) Indicator illuminates when ignition switch is bypassed (OPTIONAL) NOTE: Outputs 2, 3 and 4 provide +12 volts to accessories when SAFETY LOCK 4 is activated INSTALLATION: 1. Mount unit in a suitable location protected from moisture and excessive heat. 2. Wire in accordance with the wiring diagram above OPERATION: 1. With the engine running depress the momentary SET switch S1. The relay will close, the LED will be illuminated and the engine will continue to run when the key is removed. 2. Remove the key from the ignition. The LED will continue to be illuminated and the engine will continue to run. 3. Step on the foot brake. The LED will go out and the engine will stop. 4. Start the engine and repeat step 1. 5. Insert the key, turn ignition switch to ON and verify that the en gine continues to run when the brake pedal is depressed. MODEL 091-160 SAFETY LOCK 4 A Controller To Permit Engine Operation With The Ignition Switch Removed INSTALLATION AND WIRING INSTRUCTIONS SINCE 1967, DESIGNERS OF INNOVATIVE PRODUCTS KUSSMAUL ELECTRONICS COMPANY, INC. 170 CHERRY AVENUE, WEST SAYVILLE, NEW YORK, 11796-1221 USA October 19, 2004 TEL: 631-567-0314, FAX: 631-567-5826, ...