INSTALLATION INSTRUCTIONS Model 091-18-098 DYNAMIC DISCONNECT The Model 091-18-098 Dynamic Disconnect is a coupling device wired between an Auto Eject and the vehicle and serves to only connect the A.C. power after the plug has been inserted into the Auto Eject. Upon vehicle startup the Dynamic Disconnect opens the load circuit before ejecting the plug. By providing the time delays on both application and removal of power, no arcing can occur at the connector. Note: A.C. power must be present at the shore line connector in order to operate the Dynamic Disconnect. Installation is simple, mount the Dynamic Disconnect at some convenient location, protected from the weather. Wire in accordance with the diagram below. N.C. N.O. COM. TO VEHICLE 120 VOLT LOADS RED LED Indicates Auto Eject solenoid is energized J2 12 J1 12 3 45 GREEN LED Indicates Dynamic Disconnect relay is energized +12V FROM STARTER GROUND +12V LINE 120 VOLTS FROM AUTO EJECT NEUTRAL 2 AMP FUSE AUTO EJECT TO VEHICLE 120 V LOADS SOLENOID SINCE 1967, DESIGNERS OF INNOVATIVE PRODUCTS KUSSMAUL ELECTRONICS COMPANY, INC. 170 CHERRY AVENUE, WEST SAYVILLE, NEW YORK, 11796-1221 USA TEL. In NY: 631 567-0314 November 12, 2004 TOLL FREE: 800 346-0857 FAX: 631 567-5826 ...