Detailed instructions for use are in the User's Guide.
IM_091-31-12-115/230 Revision A, 12-09-04
INSTRUCTION MANUAL
AUTO CHARGE 1
MODEL(S): 091-31-12-115 091-31-12-230
OUTPUT: 13.25 VOLTS DC, 1 AMPERE. INPUT: 115VAC, 50/60HZ or 230VAC, 50/60HZ
3 YEAR WARRANTY
KUSSMAUL ELECTRONICS CO., INC.
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796
TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826
INTRODUCTION
The Model 091-31-12-115/230 automatic battery charger is a completely automatic battery charger designed to charge small lead-acid batteries at a rate of 1 ampere or less. The unit is current limited to 1 ampere and provides a low ripple charging current. The charger will charge the batteries whenever their float voltage drops. When the batteries are fully charged, all charging stops. Any load applied to the battery when the charger is connected and energized will automatically be supplied by the charger up to the maximum 1 ampere capacity. The Model 091-31-12-115/230 is factory set for 115VAC or 230VAC primary power operation at time of order. Please verify that installation primary power and 091-31-12-115/230 input power requirements are correct prior to installation and operation.
SPECIFICATIONS:
Input: 115VAC or 230VAC +/- 10 volts, 50/60 Hertz. Factory Set Output: DC, 13.25 Volts, Ripple: less than 100 mv Current: 0 to 1 amp depending on battery state of charge Input Wiring: #18 AWG: Blue and Brown, Refer to Figure 1. Output Wiring: Via P1/J1: Refer to Figure 1 Power Indicator: none Weight: 19 ounces
FIGURE 1
INSTALLATION and WIRING
BRO WN BLUE
12
BRO WN BLUE
+
BATTE RY
WIRECO R LO BRO WN BLUE
* 50/ 60Hz VACCO CTIO NNE N 115/ 230VAC ACLine 115/ 230VAC ACReturn
* 115VACO 230VACO RATIO SE AT FACTO R PE NT RY. CHE SE CK RIAL NUMBE TAGFO VACINPUT SE R R TTINGBE REINSTALLATIO FO N.
INSTALLATION RECORD & WARRANTY
Date Installed Installed By Vehicle Identification Vehicle Owner
WARRANTY
All products of Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped. Kussmaul Electronics Company, Inc. shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. products. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees others.
...