FILE:091-55-120-REVF REV F: 03-28-05 INSTRUCTION MANUAL SUPER AUTO EJECT AUTOMATIC SHORE LINE DISCONNECT 1 YEAR WARRANTY KUSSMAUL ELECTRONICS CO., INC. 170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826 CAUTION The AUTO EJECT must be connected to the starter circuit so that the solenoid is energized only while the engine is cranking. If the solenoid is energized continuously it will OVERHEAT and BURN OUT. FAILURE TO FOLLOW THIS CAUTION NOTE WILL VOID THE WARRANTY INSTALLATION INSTRUCTIONS 1. Locate a convenient place on the vehicle to mount the AUTO EJECT. A minimum clearance of 3" behind the mounting panel is required. 2. Place the template in position and center punch in 5 places. 3. Drill 4 mounting holes, 3/16" diameter and one, 1 3/4" clearance hole for the AUTO EJECT. 4. On the 2 conductor cable the black wire is Connected to the vehicle's ground and the white wire to the vehicle's starter. USE #16 GAUGE WIRE OR HEAVIER. 5. On the 3 conductor cable connect the Green, Black and White power wires to the accessories on the vehicle. 6. Test installation by installing mating connector into the AUTO EJECT. Energizing the starter should energize the solenoid and eject the connector. 7. Keep connector and contacts of the AUTO EJECT clean. Clean contacts with WD-40 solvent as required. Make certain that WD-40 is dry before returning to service NOTE THAT WD-40 SOLVENT IS FLAMMABLE AND MAY BE IGNITED BY A SPARK Lubricate contacts monthly with "vaseline" to insure free operation. Note: USE ONLY CORD CONNECTOR (PLUG) SUPPLIED WITH THE AUTO EJECT All connectors are not identical, using a substitute may result in unreliable operations or failure of the AUTO EJECT to operate. #8-32 x 1-1/4" Pan Head Screw Note: Place the gasket with the notch at the bottom when installing SUPER AUTO EJECT Incoming Power to Vehicle Solenoid To Battery Weather Proof Cover hi W Bl ac k te Gasket Note: notch at bottom Truck Wall Vehicle Starter Chassis Ground Wiring Diagram SUPER AUTO EJECT 1 5/8" Dia. Hole 1 YEAR WARRANTY All Auto Ejects manufactured by Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 1 year from the date the equipment was shipped. Equipment is to be returned, shipping charges prepaid and will be returned, after repair, shipping charges paid. This warranty does not include normal wear and tear, pitting of the electrical contacts, malfunction due to contamination of the mechanism, or solenoid overheating due to improper installation. Kussmaul Electronics Company, Inc. shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. products. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others. ...