® COMPACT DISC PLAYER AM/FM STEREO CASSETTE RECORDER MODEL CD-108 OPERATING INSTRUCTIONS PLAYS ALL MUSIC COMPACT DISCS FULLY PROGRAMMABLE CD PLAYER WITH REPEAT RECEIVES AM/FM STEREO BROADCASTS RECORDS FROM CD, RADIO, OR BUILT-IN MICROPHONE FM STEREO AND POWER INDICATORS 2 WAY POWER - AC/DC BASS BOOST SWITCH REQUIRES 8 SIZE C BATTERIES PLEASE READ CAREFULLY BEFORE USE CD-108072799 v.1 E SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash and arrow head within the triangle is a warning sign alerting you of dangerous voltage inside the product. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER S E RVICING TO QUALIFIED SERVICE PERSONNEL. The exclamation point within the triangle is a warning sign alerting you of important instructions accompanying the product. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. THESE IMPORTANT SAFETY INSTRUCTIONS ARE INCLUDED, AS APPLICABLE TO THE APPLIANCE, CONVEYING TO THE USER THE INFORMATION ITEMIZED BELOW: 1. Read Instructions - All the safety and operating instructions should be read before the appliance is operated. 2. Retain Instructions - The safety and operating instructions should be retained for future reference. 3. Heed Warnings - All warnings on the appliance and in the operating instructions should be adhered to. 4. Follow Instructions - All operating and use instructions should be followed. 5. Water and Moisture - The appliance should not be used near water - for example near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, and the like. 6. Wall or Ceiling Mounting - The appliance should not be mounted to a wall or ceiling. 7. Ventilation - The appliance should be situated so that its location or position does not interfere with its proper ventilation. For example, the appliance should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings; or, placed in a built-in installation, such as a bookcase or cabinet that impede the flow air through the ventilation openings. 8. Heat - The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including amplifiers) that produce heat. 9. Power Sources - The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. 10. Grounding or Polarization - Precautions should be taken so that the grounding or polarization means of an appliance is not defeated. 11. Power Cord Protection - Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenient receptacles, and the point where they exit from the appliance. 12. Cleaning - The appliance should be cleaned only as recommended by the manufacturer. 13. Nonuse periods - The power cord of the appliance should be unplugged from the outlet when left unused for a long period of time. 1 CD-108072799 v.1 E SAFETY INSTRUCTIONS 14. Object and Liquid Entry - Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. 15. Damage Requiring Service - The appliance should be serviced by qualified service personnel when: A. The power supply cord or the plug has been damaged; or B. Objects have fallen, or liquid has been spilled into the appliance; or C. The appliance has been exposed to rain; or D. The appliance does not appear to operate normally or exhibits a marked change in performance; or E. The appliance has been dropped, or the enclosure damaged. 16. Servicing - The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. 17. Power lines - An outdoor antenna should be located away from power lines. 18. Outdoor Antenna Grounding - If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges. Section 810 of the National Electrical Code, ANSI/ NFPA 70 provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See Figure. EXAMPLE OF ANTENNA GROUNDING AS PER NEC - NATIONAL ELECTRICAL CODE ANTENNA LEAD IN WIRE GROUND CLAMP ANTENNA DISCHARGE UNIT (NEC SECTION 810-20) GROUNDING CONDUCTORS (NEC SECTION 810-21) GROUND CLAMPS POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PART H) ELECTRIC SERVICE EQUIPMENT It is the intent of Lenoxx that this product be used in full compliance with the copyright laws of the United States and that prior permission be obtained from copyright owners whenever copying tapes or CDs. Do not apply oil or petroleum products or solvents to any part of this set. CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. This compact disc player is classified as CLASS 1 LASER PRODUCT as stated on the back of the set. 2 CD-108072799 v.1 E BATTERY SAFETY INSTRUCTIONS CAUTION: TO REDUCE THE RISK OF FIRE OR PERSONAL INJURY OR DAMAGE TO YOUR SET, READ AND FOLLOW THESE INSTRUCTIONS. 1. Use only the type and size of batteries mentioned in the operating instructions booklet (batteries are not included with this set, please buy the proper batteries). 2. Do not dispose the batteries into a fire. The cells may explode. Check with local codes for possible special disposal instructions. 3. Do not open or mutilate the batteries. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed. 4. Be careful when handling batteries in order not to short the battery with conducting materials such as rings, bracelets and keys. The battery or conductor may over heat and cause burns. 5. Do not attempt to recharge non-rechargeable batteries. The batteries may leak corrosive electrolyte or explode. 6. Do not attempt to rejuvenate the batteries identified for use with this product by heating them. Sudden release of the battery electrolyte may cause burns or irritation to eyes or skin. 7. All batteries should be replaced at the same time. Mixing fresh and discharged batteries could increase internal cell pressure and rupture the batteries. 8. When inserting batteries into this product, the proper polarity ( and ) or direction must be observed. Reverse insertion of some or all of the batteries may result in battery eletrolyte leakage or explosion. 9. Remove the batteries from this product if the product will not be used for a long period of time (several months or more) since during the period the batteries could leak, damaging the product. 10. Discard weak or dead batteries as soon as possible since they are more likely to leak in the product. Batteries should be replaced (depending on the product) when the display gets dim or if the Low Battery Indicator shows or if the sound gets distorted. 11. Do not store this product in high temperature areas. Batteries that are stored in a freezer or refrigerator for the purpose of extending shelf life should be protected from condensation during storage and defrosting. Batteries should be stabilized at room temperature prior to use after cold storage. 12. If this product does not operate normally, see TROUBLE SHOOTING on page 18. If you cant resolve the problem, or if the product is damaged, refer to the LENOXX WARRANTY INFORMATION. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the appliance is subsequently used. 13. If liquid leaks from the batteries, carefully wipe this liquid. Do not allow it to touch your skin, and discard the leaking batteries. 14. Do not mix batteries (OLD and NEW or CARBON and ALKALINE, etc.). 15. The use of rechargeable batteries is not recommended for this set because their voltage and life is lower than standard batteries. 16. Installation of batteries should be done by an adult only. SAVE THESE INSTRUCTIONS 3 CD-108072799 v.1 E Playing a CD 1 2 4 3 Connect the supplied AC power cord or batteries(see page 14). 1 CD TAPE Slide the Function Switch to CD position (power on). RADIO 2 CD OPEN Press the CD Door Open button to open the CD Door and place the CD in the CD compartment. The label side of the CD should face you. 3 4 Close the CD door by pushing it back. Press the CD Play Button. The player plays all the tracks once. Play/Pause Lamp Track number 4 CD-108072799 v.1 E Use these buttons for additional operations Volume Control Tip When CD play is paused, the Play/ Pause Lamp will flash and no music will play. To resume play, press the Pause Button again, the Play/Pause Lamp will stop flashing and music will play. Function CD Open Switch Button To Adjust the volume Stop playback Pause playback Press or Adjust Volume Control The Lamp will flash during pause. Press again to resume play after pause. Go to the next track Go back to the previous track Locate a point in a song or while playing, press and hold down until you find the point. CD door Open Button (press Stop first) Slide the Function Switch to TAPE position Play/Pause Lamp Remove the CD Turn off the power 5 CD-108072799 v.1 E Playing CD tracks repeatedly (Repeat Play) You can play CD tracks repeatedly in normal or program play modes (see page 7). Function Switch Repeat Button Program Lamp 1. Slide the Function Switch to CD position. 2. Press the CD Repeat Button. To repeat a single track (song) all the tracks (songs) programmed tracks Press Press the Repeat Button once Press the Repeat Button twice Press the Program Button, and then the Repeat Button twice Repeat Lamp Repeat Lamp Flashing Steady on Steady on (the Program Lamp flashing) . 3. Select the track by pressing or , and then press To cancel Repeat Play Press the Repeat Button until the Repeat Lamp is off. 6 CD-108072799 v.1 E Creating your own music program (Program Play) You can make a program of up to 19 tracks in the order you want them to be played. Program Program Lamp 1. Slide the Function Switch to CD position. 2. Press the Program Button. The number and the Program Lamp will flash. 3. Press or to select the tracks you want to program in the order you want. 4. Press the Program Button to confirm. The number and the Program Lamp will flash. 5. Repeat steps 3 and 4. You can program up to 19 tracks. 6. Press to start program play. The Program Lamp will remain flashing. To change the current program Just creat a new program following the Programing procedure. To cancel Program Play Press the Stop Button and the Program Lamp goes off. 7 CD-108072799 v.1 E Listening to the radio 2 3 1 1 CD 4 Connect the supplied AC power cord or batteries (see page 14). Slide the Function Switch to RADIO position (power on). RADIO TAPE 2 AM FM FM ST . Slide the Band Switch to the proper band position that you want. BAND 3 Tune into the station you prefer using the Tuning Control. Adjust for the clearest sound. 4 FM STEREO This indicator will light up when receiving FM Stereo broadcasts. 8 CD-108072799 v.1 E Use these buttons for additional operations Volume Control Function Switch Tip To Adjust the volume Turn off the Radio Slide or Adjust Volume Control Slide the Function Switch to TAPE position · If the FM broadcast is noisy, slide the Band Switch from FM Stereo to FM position. To improve broadcast reception Reorient the antenna for FM or FM Stereo. Reorient the player itself for AM. 9 CD-108072799 v.1 E Playing a tape 3 1 CD TAPE 2 Connect the supplied AC power cord or batteries(see page 14). Slide the Function Switch to TAPE position. RADIO STOP/EJECT 7654321 7654321 7654321 7654321 7654321 7654321 3 7654321 1 7654321 7654321 7654321 7654321 7654321 765432 2 Press the Stop/Eject Button to open the tape compartment and insert a recorded tape. Close the door. LL FU E E L R PLAY Press the Play Button. The player truns on and starts playing. Y PT EM EEL R Full reel on the left side. 10 CD-108072799 v.1 E Use these buttons for additional operations VOLUME CONTROL PHONES JACK BASS BOOST SWITCH PAUSE PLAY FAST F.& REWIND STOP/EJECT Tip When the tape finishes playing that side of the tape, the set will stop. To hear the otherside, flip tape over, then insert and press Play. To Adjust the volume Stop playback Fast forward or rewind the tape Pause playback Press or Adjust Volume Control Stop/Eject Button Fast Forward Button or Rewind Button Pa ...