COMPACT DISC PLAYER WITH AM/FM RADIO MODEL CD-1095 OPERATING INSTRUCTIONS · · · · · · PLAYS MUSIC COMPACT DISCS FULLY PROGRAMMABLE CD PLAYER WITH REPEAT PLAY RECEIVES AM/FM BROADCASTS POWER LED INDICATOR 2 WAY POWER - AC/DC REQUIRES 6 SIZE "C" BATTERIES (not included) PLEASE READ CAREFULLY BEFORE USE IB-CD1095(SY)-WM-E-031604 WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THE PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER ( OR BACK). NO USER SERVICEABLE PARTS INSIDE. R E F E R S E R V I C IN G TO Q U A LIFIED S ER V I C E PERSONNEL. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. IMPORTANT SAFETY INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. 8. 9. Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings, install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Only use attachments/accessories specified by the manufacturer. Unplug this apparatus during lightning storms or when unused for long periods of time. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped. This appliance shall not be exposed to dripping or splashing water and that no object filled with liquid such as vases shall be placed on the apparatus. 1 IB-CD1095(SY)-WM-E-031604 10. 11. 12. 13. 14. ADDITIONAL SAFETY INSTRUCTIONS 1. Power Sources - The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. 2. Wall or Ceiling Mounting - The appliance should not be mounted to a wall or ceiling. 3. Object and Liquid Entry - Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. 4. Servicing - The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. Do not apply oil or petroleum products or solvents to any part of this set. CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. This compact disc player is classified as CLASS 1 LASER PRODUCT as stated at the back of the set. 2 IB-CD1095(SY)-WM-E-031604 BATTERY SAFETY INSTRUCTIONS CAUTION: TO REDUCE THE RISK OF FIRE OR PERSONAL INJURY OR DAMAGE TO YOUR SET, READ AND FOLLOW THESE INSTRUCTIONS. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Use only the type and size of batteries mentioned in the operating instructions booklet (batteries are not included with this set, please buy the proper batteries). Do not dispose the batteries into a fire. The cells may explode. Check with local codes for possible special disposal instructions. Do not open or mutilate the batteries. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed. Be careful when handling batteries in order not to short the battery with conducting materials such as rings, bracelets and keys. The battery or conductor may over heat and cause burns. Do not attempt to recharge non-rechargeable batteries. The batteries may leak corrosive electrolyte or explode. Do not attempt to rejuvenate the batteries identified for use with this product by heating them. Sudden release of the battery electrolyte may cause burns or irritation to eyes or skin. All batteries should be replaced at the same time. Mixing fresh and discharged batteries could increase internal cell pressure and rupture the batteries. When inserting batteries into this product, the proper polarity ( and ) or direction must be observed. Reverse insertion of some or all of the batteries may result in battery electrolyte leakage or explosion. Remove the batteries from this product if the product will not be used for a long period of time (several months or more) since during the period the batteries could leak, damaging the product. Discard weak or dead batteries as soon as possible since they are more likely to leak in the product. Batteries should be replaced (depending on the product) when the display gets dim or if the Low Battery Indicator shows or if the sound gets distorted. Do not store this product in high temperature areas. Batteries that are stored in a freezer or refrigerator for the purpose of extending shelf life should be protected from condensation during storage and defrosting. Batteries should be stabilized at room temperature prior to use after cold storage. If this product does not operate normally, see TROUBLE SHOOTING in this instruction manual. If you can't resolve the problem, or if the product is damaged, refer to the LENOXX WARRANTY INFORMATION. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the appliance is subsequently used. If liquid leaks from the batteries, carefully wipe this liquid. Do not allow it to touch your skin, and discard the leaking batteries. Do not mix batteries (OLD and NEW or CARBON and ALKALINE, etc.). The use of rechargeable batteries is not recommended for this set because their voltage and life is lower than standard batteries. Installation of batteries should be done by an adult only. 11. 12. 13. 14. 15. 16. SAVE THESE INSTRUCTIONS 3 IB-CD1095(SY)-WM-E-031604 CHOOSING THE POWER SOURCES You can use the AC power or batteries as a power source. To a wall outlet NOTE: One blade of the plug and outlet is wider. AC SOCKET · Replace the batteries when the POWER lamp dims or when the player stops operating. Replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player and remember to check the Battery Safety Instructions on Page 3. If the CD does not play on batteries, this means the batteries are almost used up. But the radio may continue to play on these weak batteries because it uses less power than the CD player. 1. Connecting the AC power cord Insert one end of the supplied AC power cord into the socket located at the rear of the player, and the other end to the wall outlet. Insert 6 size "C" batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect and remove the AC power cord both from back of the player and the wall outlet. 2. Using the player on batteries · Insert new batteries as shown. 4 IB-CD1095(SY)-WM-E-031604 PLAYING A CD OPEN THE CD DOOR BY LIFTING HERE FUNCTION SWITCH (at the left side of the set) PLAY/PAUSE Connect the supplied AC power cord or batteries (see page 4). 1 2 3 RADIO OFF FUNCTION CD Slide the FUNCTION switch (at the left side of the set) to CD position, the POWER lamp will turn on and the display will show 2 dashes "--" flashing, ". then " Lift the right corner of the CD DOOR to open it and place a CD in the CD compartment. T h e l a be l s id e o f t he C D should face upward. POWER lamp C lo s e th e C D D OO R b y pushing it down. The display will show the total tracks of that CD. 4 Pr ess the PLAY /PAU SE button. The PLAY/PAUSE lamp will be steadily on, the player will play all the tracks in order once. Track PLAY/PAUSE number lamp 5 IB-CD1095(SY)-WM-E-031604 USE THESE BUTTONS FOR ADDITIONAL OPERATIONS VOLUME CONTROL PHONES JACK OPEN THE CD DOOR BY LIFTING HERE FUNCTION SWITCH (at the left side of the set) STOP BACKWARD PLAY/PAUSE FORWARD TIP When CD play is paused, the PLAY/ PAUS E la m p w il l flash and no music will play. To r es um e p l ay, p r e s s th e P L AY / PAU S E bu t to n again, t he PL AY/ PAU S E la m p w il l stop flashing and music will play. To Adjust the volume Stop playback Press or Adjust VOLUME control STOP PLAY/PAUSE The PLAY/PAUSE lamp will flash during pause. Press again to resume play after pause. Pause playback Go to the next track Go back to the previous track Locate a point in a song FORWARDS BACKWARDS BACKWARDS FORWARDS or , press and hold down while playing until you find the point. Insert your headphones (not i nc luded ) p l ug i n to th e PHONES jack (at the left side of the set). Lift the right corner of the CD DOOR (press STOP first). Slide the FUNCTION switch (at the left side of the set) to OFF position. IB-CD1095(SY)-WM-E-031604 TIP If you bump the set during CD play, the music will stop or s ki p f or a fe w se c onds. This is normal for this type of player. To e nj o y th e m u si c without disturbing others Remove the CD Turn off the power 6 PLAYING CD TRACKS REPEATEDLY (REPEAT PLAY) You can play CD tracks over and over in normal or programmed play modes (see page 8). FUNCTION SWITCH (at the left side of the set) PLAY/PAUSE REPEAT BUTTON PROGRAM BUTTON BACKWARD FORWARD 1. Slide the FUNCTION switch (at the left side of the set) to the CD position. 2. Select the track by pressing SKIP/SEARCH BACKWARD or FORWARD , and then press .. 3. Press the CD REPEAT button. To repeat a single track (song) Press P r e s s th e R E PE AT bu t to n once, the REPEAT lamp will be flashing. Display shows REPEAT PROGRAM PLAY/ PAUSE REPEAT PROGRAM PLAY/ PAUSE P r e s s th e R E PE AT bu t to n all the tracks (all songs) twice, the REPEAT lamp will be steadily on. During programmed play, press the REPEAT button twice, the REPEAT lamp and the PROGRAM lamp will be steadily on. REPEAT PROGRAM PLAY/ PAUSE programmed tracks To cancel Repeat Play Press the REPEAT button until the REPEAT lamp goes off. 7 IB-CD1095(SY)-WM-E-031604 SELECTING YOUR OWN MUSIC PLAYING ORDER (Programmed Play) You can make a program of up to 20 tracks in the order you want them to be played. PROGRAM BUTTON PROGRAM LAMP 1. Slide the FUNCTION switch to CD position. Make sure the CD is stopped. 2. Pre ss th e P RO G. b utt on. The l e tte rs " " and the PROGRAM lamp will flash in the display. or to select the tracks you want to Press program in the order you want. The selected number will be steadily on and the program lamp will be flashing. Press the PROG. button to confirm. The letters " " and the PROGRAM lamp will flash in the display for next selection. Repeat steps 3 and 4. You can program up to 20 tracks until the display shows the tracks what you selected. Press to start programmed play. The PLAY/ PAUSE lamp and the PROGRAM lamp will be steadily on. REPEAT PROGRAM PLAY/ PAUSE 3. REPEAT PROGRAM PLAY/ PAUSE 4. 5. REPEAT PROGRAM PLAY/ PAUSE 6. To change the current program Just create a new program following the programming procedure. To cancel Programmed Play Slide the FUNCTION switch to OFF position. 8 IB-CD1095(SY)-WM-E-031604 LISTENING TO THE RADIO FUNCTION SWITCH (at the left side of the set) TUNING CONTROL BAND SWITCH Connect the supplied AC power cord or batteries (see page 4). 1 2 RADIO OFF FUNCTION CD Slide the FUNCTION switch (at the left side of the set) to RADIO position, the POWER lamp will turn on . AM BAND FM Slide the BAND switch (at the right side of the set) to the proper band position (AM or FM) that you want. 3 Tune into the station you prefer using the TUNING control. Adjust for the clearest sound. 9 IB-CD1095(SY)-WM-E-031604 USE THESE BUTTONS FOR ADDITIONAL OPERATIONS VOLUME CONTROL FUNCTION SWITCH (at the left side of the set) TIP To Adjust the volume · Next Slide or Adjust VOLUME control Slide the FUNCTION switch (at th ...