User's Guide Specification 1. Model Description MODEL SUFFIX Z32/3742LC2DA-UE BRAND Product Name Zenith Part No. Z32LC2DA, Z37LC2DA, Z42LC2DA USA 38289U0527H (0611-REV02) 2. Printing Specification 1. Trim Size (Format) : 185mm x 260 mm 2. Printing Colors · Cover : 1 COLOR (BLACK) · Inside : 1 COLOR (BLACK) 3. Stock (Paper) · Cover : Uncoated paper , 80 g/ · Inside : Uncoated paper , 80 g/ 4. Printing Method : Off set 5. Bindery : Saddle stitch 6. Language : English (1) 7. Number of pages : 64 N O T E S "This part contain Eco-hazardous substances (Pb, Cd, Hg, Cr6+, PBB, PBDE, etc.) within LG standard level, Details should be followed Eco-SCM management standard[LG(56)-A-2524]. Especially, Part should be followed and controlled the following specification. (1)Eco-hazardous substances test report should be submitted when Part certification test and First Mass Production. (2) Especially, Don't use or contain lead(Pb) and cadmium(Cd) in ink. 3. Special Instructions (1) Origin Notification * LGEDI : Printed in Indonesia * LGESP : Printed in Brazil * LGENT : Printed in China * LGEWA : Printed in U.K. * LGEMX : Printed in Mexico * LGEIL : Printed in India 4. 9 8 7 6 5 4 3 2 1 REV. NO. Changes MM/DD/YY CHANGE NO. CHANGE CONTENTS Pagination sheet Front cover Rear cover Zenith(EN) Zenith WTY 2 3 .... .... ... 63 P/NO. Installation and Operating Guide | Warranty Model Numbers | Z32LC2DA, Z37LC2DA, Z42LC2DA | LCD TV ENERGY STAR is a set of power-saving guidelines issued by the U.S. Environmental Protection Agency(EPA). As an ENERGY STAR Partner LGE U.S.A., Inc. has determined that this product meets the ENERGY STAR guidelines for energy efficiency. © Copyright 2006, LG Electronics USA, Inc. Warning Warning CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. NOTE TO CABLE/TV INSTALLER: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the National Electric Code (U.S.A.). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical. REGULATORY INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. CAUTION: Do not attempt to modify this product in any way without written authorization from LG Electronics Corporation. Unauthorized modification could void the user's authority to operate this product. COMPLIANCE: The responsible party for this device compliance is: Zenith Electronics Corporation 1-201-816-2000 Marked and Distributed in the United States by LG Electronics U.S.A., Inc. 1000 Sylvan Avenue, Englewood Cliffs, NJ 07632 http://www.zenith.com 2 Safety Instructions Safety Instructions WARNING : To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. Ow ner's Man ual 2. Keep these instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 3. Heed all warnings. 4. Follow all instructions. 9. Do not defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 7. Do not block any of the ventilation openings. Install in accordance with the manufacturer's instructions. 11. Only use the attachments / accessories specified by the manufacturer. 3 Safety Instructions 12. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart / apparatus combination to avoid injury from tip-over. 14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 13. Unplug this apparatus during lightning storms or when unused for long periods of time. 15. DISCONNECTING DEVICE FROM MAINS Main plug is the disconnecting device.The plug must remain redily operable. Note - If the TV feels cold to the touch, there may be a small "flicker" when when it is turned on. This is normal, there is nothing wrong with TV. - Some minute dot defects may be visible on the screen, appearing as tiny red, green, or blue spots. However, they have no adverse effect on the monitor's performance. - Avoid touching the LCD screen or holding your finger(s) against it for long periods of time. Doing so may produce some temporary distortion effects on the screen. CAUTION concerning the Power Cord Most appliances recommend they be placed upon a dedicated circuit; that is, a single outlet circuit which powers only that appliance and has no additional outlets or branch circuits. Check the specification page of this owner's manual to be certain. Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension cords, frayed power cords, or damaged or cracked wire insulation are dangerous. Any of these conditions could result in electric shock or fire. Periodically examine the cord of your appliance, and if its appearance indicates damage or deterioration, unplug it, discontinue use of the appliance, and have the cord replaced with an exact replacement part by an authorized servicer. Protect the power cord from physical or mechanical abuse, such as being twisted, kinked, pinched, closed in a door, or walked upon. Pay particular attention to plugs, wall outlets, and the point where the cord exits the appliance. On Disposal a. The fluorescent lamp used in this product contains a small amount of mercury. b. Do not dispose of this product with general household waste. Disposal of this product must be carried out in accordance to the regulations of your local authority. 4 Contents Contents 2 3~4 Warning Safety Instructions Accessories Controls (Model Name: Z42/50PX3D) Connection Options (Model Name: Z42/50PX3D) Controls (Model Name: Z32LC2DA, Z37LC2DA, Z42LC2DA) Connection Options (Model Name: Z32LC2DA, Z37LC2DA, Z42LC2DA) Introduction 7 8 9 10 11 12~13 Remote Control Key Functions Installation 14 15 15 External Equipment Connections 16 17~18 18 19~20 21~22 23 23 24~26 27 27 27 27 28 29 29 30 31 31 32 33 33~34 35 36 37 38 39 39~40 41 41 Basic connection Attaching the TV to a wall Desktop Pedestal Installation Antenna or Cable Connection VCR Setup External AV Source Setup DVD Setup HDSTB Setup AV Out Setup Digital Audio Output PC Setup Turning on the TV Volume Adjustment Channel Selection On Screen Menus Language Selection On Screen Menus Selection and Adjustment EZ Scan (Channel Search) Manual Scan Channel Edit DTV Signal Strength Input Source Input Label Auto Picture Control(EZ Picture) Color Temperature Control DB Advanced-Cinema 3:2 Mode / Black Level Video Reset Audio Language Auto Sound Control(EZ Sound) Manual Sound Control (EZ Sound-User option) Balance TV Speakers On/Off Setup Basic operation Setup Menu Options Operation Video Menu Options Audio Menu Options 5 Contents Time Menu Options Operation 42 42 43 43 44 45 46 47 47 48 Manual Clock Setup Auto Clock Setup On/Off Timer Setup Sleep Timer Auto Off Aspect Ratio Control Caption/Text Caption Option Low Power (Z42/50PX3D only) ISM (Image Sticking Minimization) Method (Z42/50PX3D only) Option Menu Features Lock Menu Options 49~50 Parental Lock Setup 51~56 57~58 External Control Device Setup IR Codes Programming the Remote Programming Codes Troubleshooting Checklist Maintenance Product Specifications Warranty Reference 59 60~61 62~63 64 65 67~68 6 Introduction Introduction Accessories Ensure that the following accessories are included with your TV. If any accessory is missing, please contact the dealer from where you purchased the product. User must use shielded signal interface cables (D-sub 15 pin cable) with ferrite cores to maintain standard compliance for the product. NU ME SA P R TE EN ER TIM VO L SH K FLA BAC INP TE MU 1 2 5 6 9 V UT TV CH INP UT TIO RA PO W ER 3 EZ IT EX CC NU ME P SA ER TIM CO MP 1 CO MP DV EZ UN SO D 2 D HD R VC MI ST JU AD C B-P RG INF O PIC MOD E TV R TE EN VO L SH K FLA BAC TE MU 1 4 2 7 5 8 6 0 9 FAV CH 3 1.5V 1.5V Power Cord 75 Round Cable Owner's Manual Remote Control / Batteries For Z32LC2DA, Z37LC2DA, Z42LC2DA For Z42/50PX3D 2-Wall brackets 2-eye-bolts 2-TV brackets 2-Wall brackets 2-TV Bracket Bolts Twister Holder Arrange the wires with the twister holder. Cable Management (Refer p.18) Option Extras Z32LC2DA only 4-bolts for stand assembly See below for detail information. D-sub 15 pin cable Stand Installation for Z32LC2DA 1 Carefully place the product screen side down on a cushioned surface that will protect product and screen from damage. 2 Place the hook of the stand in the back of the product as shown. 3 Install the 4 bolts provided securely, in the back of the product. 7 Introduction Controls (Model Name: Z42/50PX3D) - This is a simplified representation of front panel. - This picture shown below may be somewhat different from your TV. INPUT MENU ENTER VOL CH CHANNEL POWER INPUT MENU ENTER VOLUME Button Button Button Button (F , G)Buttons (E , D)Buttons E F Power Standby Indicator Illuminates red in standby mode. Illuminates green when the set is switched on. 8 Introduction Connection Options (Model Name: Z42/50PX3D) - This picture shown below may be somewhat different from your TV. S-VIDEO Input Provides better picture quality than the video input. AUDIO Input Connections are available for listening to stereo sound from an external device. VIDEO Input Connects the video signal from a video device. 1 1 10 1 SERVICE 7 COMPONENT IN COMPONENT IN VIDEO AUDIO 6 4 HDMI / DVI IN ANTENNA/ CABLE IN 5 REMOTE 8 VIDEO AUDIO COMPONENT IN AV OUT AV OUT AV IN 1 2 3 OPTICAL PTICAL (CONTROL & SERVICE) DIGITAL AUDIO OUT (MONO) S-VIDEO VIDEO AUDIO AV OUT AV IN 1 9 1 COMPONENT IN DIGITAL AUDIO OUT Connect a component video/audio device to these jacks. AV OUT Connect a second TV or monitor. AV (Audio/Video) IN 1 Connect audio/video output from an external device to these jacks. S-VIDEO Connect S-Video out from an S-VIDEO device. ANTENNA/CABLE IN Connect over-the air signals to this jack. Connect cable signals to this jack. DIGITAL AUDIO OUT Connect digital audio from ...