Graph The wide smooth frequency response, good sensitivity and high power handling make the I 2.40 suitable for use in any quality installation CAR AUDIO EQUIPMENT ® I 2.40 Specifications Power Handling: Nominal Impedance: Frequency Response: Sensitivity (2.83V/1m): Unit Size Voice coil Woofer Tweeter ø -100 mm (4") ø - 54 mm (2 1/4") ø - 28 mm (1 1/8") 125 Hz 3.40 Ohm 0.22 mH 4 mm ± 2 mm 2.79 tm 80 Watts satellite (max. music) 50 Watts full range (max. music) 4 Ohm 80-25.000 Hz 89 dB Qms: Qes: Q/Ts: VAS: Cms: Moving Mass (ms): Magnet System: Cone Material: Dome Material: Nett Weight (per piece): 4.98 1.26 1.00 1.21 lt 443 µM/N 3.66 gr Triple magnet DPC Soft Fabric 0.5 Kg Installation Guide Illustrated Options for Specific & Standard Installation Resonant Frequency: Dc Resistance: Voice Coil Inductance @ 1Khz Air Gap Height: X-Max Linear Excursion: Force Factor (BXL) MACROM LTD. 3 Moree ST., 6850 MENDRISIO SWITZERLAND MACROM ® is Registered Trade Mark of Macrom Ltd. Dublin Ireland Use of Bi-wiring The Integra are prepared for bi-wiring connection. This allows you to separate the Tweeter from the Woofer using external crossover. Active or passive crossovers can be used according to requirements. The unit is supplied with a passive 6dB/Oct filter thanks to the perfect woofer roll off. For correctcuse of Bi-wiring please proceed as follows: Instruction for use Standard 2 way system connection Connect the terminals marked INPUT INTEGRA directly to the amplifier. Substitute Installation Use the screw clips in any combination, with or without the plastic frame. These clips can be used either way up depending on installation requirements. Installation system for FIAT car`s Use the non-screw clips to install the woofer in the dashboard or other locations which do not require screws.Insert the clips in the small holes on the side of the woofer according to your requirements. Input Integra Cut the two Tweeter cables coming from the Magnet cover Example of Bi-wiring connection with electronic crossover Head Unit Pre Output Input Tweeter Power Amplifier Electronic Crossover Power Amplifier Input Woofer Input High Output (min. 3kHz) Low Output Installation system for AUDI, TOYOTA car`s Integra TWEETER WARNING: The tweeter CANNOT reproduce the whole audio range. You must absolutely use a passive or electronic crossover with a frequency cutting not lower than 3kHz. Integra Woofer Input Woofer Input Tweeter Input Tweeter Input Standard installation with grille kits Versatile unit suitable for replacing car manufacturers` existing speaker installation or as a new component with grille kits protection. Use the supplied accessories in to grille kit (fasteners, clips, screw, plastic frame and grille) according to the desired installation position. Any number and combination of fixings cam be used to ensure satisfactory installation. Where necessary use the plastic frame as a template. Sprung Steel Fastener Mounting Ring Installation system for MERCEDES, VOLKSWAGEN car`s Screw Clips Grille ...