ST Mon o ST Inp Mon ut o M3A.250 2 CHANNEL Lef t Rig ht Con t 1V Flat Fil rol POWER AMPLIFIER Lef t /F ilt e Inp ut 8V 0,2 V H ter ig h Low r -M ode - 60H z ST Mon o 30 Illustration Guide For more informations 600 Rig ht Low Level Input 8V 1V ST / mono selector 0,2 V 8V Input setting Filter setting 0,2 V Gain Control Adjust 150 Hz Flat Response 20Hz 20kHz Left 1V Right 8V 0,2V 30 600 30 30 600 600 Input Control / Filter Flat High Filter Low 60Hz - Mode ST Mono 1V 8V /F Fla il t Fil H ter ig h Low 0,2 V Con tro l or high pass filter control Con t 1V 8V 0,2 V /F Fla ilt t er Fil H ter ig h Low rol 20Hz 30Hz 600Hz 20kHz or FILTER Low pass or High pass Low pass filter control 20Hz 30Hz 600Hz 20kHz Technical Data IHF max power handling Configuration RMS Power 4 ohm Stereo load at 14,4 V RMS Power 2 ohm Stereo load at 14,4 V RMS Power 4 ohm Bridged load Frequency response (+0/-1 dB) Signal to noise ratio Input sensitivity Input impedance Crossover tipe Crossover frequency & filter slop (High-pass) Crossover frequency & filter slop (Low-pass) Dimensions (w * h * d) 350 Watts "1 - 2" 50 x 2 watts 70 x 2 watts 140 x 1 watts 10 - 45,000 Hz >95 dB 200 - 8,000 mV 22.000 ohm variable 30 to 600/12 Hz/dB 30 to 600/12 Hz/dB 265 x 50 x 195 mm Output/Power connection M3A.250 2 CHANNEL POWER AMPLIFIER Illustration Guide For more informations IMPEDANCE REQUIREMENT 2 OHM MINIMUM 4 ohm 4 ohm 4 ohm 4 ohm 4 ohm + + L Spe ake Stereo - Brid Out put ged + r + R - Spe a L + - ker Brid Out ged put + R Fus e 20A +BAT T Pow er Ter mi Remo te nal -GND + - + - + or + Speakers output + Left Speakers output + Right - AMP Two 4 ohm speakers AMP 3 or more 4 ohm speakers Min load 2ohm OK 4 ohm NOT OK 2 ohm Bridged Min load 4ohm + + L Power connection +BA TT Pow er T er m Rem ote ina l -GN D Spe ake - Brid Out put ged r + R - + - + - + - + - Speaker output Speaker output AMP One 4 ohm speaker AMP One 4 ohm speaker + Bridged - + - CAR CHASSIS OK NOT OK CAR CHASSIS ...