MODEL: DCD6011-MER OWNER'S MANUAL SAFETY PRECAUTIONS RISK OF ELECTRIC SHOCK DO NOT OPEN English "A" CAUTION LOCATION OF CONTROLS DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. ATTENTION: The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. 1. Headphones 1 Jack (Side of Unit) 2. Headphones 2 Jack (Side of Unit) 3. SKIP/SEARCH (o) Button 4. VOLUME Control 5. SKIP/SEARCH (n) 8. DC 4.5V Jack (Rear of Unit) Z DANGER: This product utilizes a Class 1 laser to read Compact Discs. This laser Compact Disc player is equipped with safety switches to avoid exposure when the CD door is open and the safety interlocks are defeated. Invisible and hazardous laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam. Please do not attempt to defeat or bypass the safety switches. Button 6. PLAY/PAUSE (®p)/POWER ON Button 7. DBBS Switch 9. CD Compartment with Battery Compartment (inside) 10.Display 11.MODE Button 12.PROG (Program) Button 13.ESP (Anti-Skip Protection) Button 14.STOP (I)/POWER OFF Button 15.CD OPEN Switch INFORMATION: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. · · · · · Do not open the CD compartment while the CD is rotating. Always keep the CD compartment closed when not in use. Keep all foreign objects out of the CD compartment. Place the unit on a stable surface. Avoid installing the unit in locations described below: · Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters. · On top of other stereo equipment that radiates too much heat. · Places lacking ventilation or dusty places. · Places subject to constant vibration. · Humid or moist places. AC OPERATION To operate the unit using AC power, connect an AC adapter (not included) to an AC outlet having 120V, 60Hz AC only. Plug the small end into the DC 4.5V jack on the rear of the unit and connect the other end into an AC outlet. The batteries are automatically disconnected when an AC adapter is used. CAUTION: When not using AC power, disconnect the AC adapter from the wall outlet by pulling the plug (not the cord). Do not touch the AC adapter with wet hands. Fully insert the plug without exposing any part of the blade. 60 SECOND MOTION PROOF ELECTRONIC ANTI-SHOCK SYSTEM This CD player has a built-in Anti-Shock System that cuts down on CD skipping, which is useful when using the CD player in the car or while jogging/walking. Anti-Shock is automatically activated when the unit is turned on. To turn the Anti-Shock System off, press the ESP button once; the ESP indicator will disappear. HEADPHONE JACKS There are two Headphones jacks. Plug headphones in one jack for private listening or both jacks for sharing. OPERATION ATTENTION: POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISES ET POUSSER JUSQU'AU FOND. This Class B digital apparatus complies with Canadian ICES003. / Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. SURGE PROTECTORS: It is recommended to use a surge protector for AC connection. Lightning and power surges ARE NOT covered under warranty for this product. TO PLAY A CD (Standard, CD-R and CD-RW) 1. Open the CD compartment door by sliding the CD OPEN switch to the right. Gently press a disc, label side up, onto the spindle until it locks in place. Close the CD compartment door. Insert headphones into the Headphones jack. 2. While the unit is off, press the PLAY/PAUSE (®p)/ POWER + ­ + ­ FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. BATTERY INSTALLATION The battery low indicator will blink in the ­­ display when the batteries need replacing. 1. Open the Battery Compartment door (inside the CD compartment) by ++ pressing in on the tab and then lifting up. To prevent the possibility of losing the cover, it cannot be removed. 2. Insert two (2) "AA" batteries (not included) according to the polarity diagram inside the Battery Compartment. Alkaline batteries are recommended for the longest playing time. POWER SOURCES MODE PLAYBACK 1. With a CD inserted, press the PLAY/PAUSE (®p)/ POWER ON button to turn the unit on, then select a track using the SKIP/SEARCH O or N button (if desired). 2. Press the MODE button once; the Repeat 1 indicator ALL 1 will appear in the display. The unit will then play the same track over and over until the STOP (I)/POWER OFF button is pressed. 3. Press the MODE button a second time; the Repeat All ALL will appear in the display. The unit will indicator then play all the tracks on the CD over and over until the STOP (I)/POWER OFF button is pressed. 4. While in the Stop mode, press the MODE button three times; the INTRO indicator will appear in the display. Press the PLAY/PAUSE (®p)/POWER ON button and the unit will play the first 10 seconds of each track. Press the STOP (I)/POWER OFF button to stop Intro playback. 5. While in the Stop mode, press the MODE button four times; the RAND indicator will appear in the display. The unit will play all the tracks in random order. When all the tracks have been played, the unit will stop. Press the STOP (I)/POWER OFF button to stop Random playback. 6. Adjust the VOLUME control and DBBS switch as desired. TO CANCEL Mode Play, press the Mode button until the indicators disappear. TO PROGRAM THE MEMORY (UP TO 20 TRACKS) 1. While in the Stop mode, press the PROG button. The track number will blink and "01" will appear in the display. 2. Select a track to be programmed using the Skip/ SEARCH O or N button. 3. Press the PROG button to memorize the track. Repeat Steps 1 and 2 to program additional tracks up to a maximum of 20 tracks. 4. Press the PLAY/PAUSE (®p)/POWER ON button to begin Program playback. NOTES: · You can review the program by pressing the PROG button repeatedly while in the Stop mode. · Press the STOP (I)/POWER OFF button to stop the program before it is finished (the program memory will be kept). Press the STOP (I)/POWER OFF button to turn the unit off and clear the Program memory. · Each track may be stored in the program memory as many times as desired (up to 20 files). · You can scroll through the program while it is playing using the Skip/Search O or N button. ON button to start playback. To pause playback, press the PLAY/PAUSE (®p)/POWER ON button again, the elapsed time will blink. Press once again to resume playback. 3. Adjust the VOLUME control and DBBS switch (to enhance the bass) as desired. To skip forward or backward through the tracks on the disc, press the SKIP/SEARCH O or N button. To search forward or backward through the tracks on the disc, press and hold the SKIP/SEARCH O or N button. 4. When the disc is through playing, it will stop. Press the STOP (I)/POWER OFF button to stop the disc before it is finished; the total number of tracks will appear. Press the STOP (I)/POWER OFF button again while in the Stop mode to turn the unit off or wait approximately 30 seconds and the unit will automatically turn off. NOTES: · This unit is capable of playing standard CDs or 3" singles; no adapter is required. · If a disc is inserted incorrectly, dirty, damaged or not present at all, the display will show "disc". · As each track is played, the track number and elapsed time are shown in the display. · To remove the disc, open the CD compartment while the unit is in the Stop mode or off, then hold the edge of the CD, gently press the center pivot and lift the CD. · The display will show "OPEN" when the CD compartment door is open. WARRANTY: 90 days parts and labor. For additional warranty information or operating assistance, please visit www.disneyelectronics.com or contact customer service at (954) 660-7026. Please keep all packaging material for at least 90 days in case you need to return this product to your place of purchase or Memcorp. For parts and accessories, contact Fox International at 1-800-321-6993. Distributed by Memcorp Inc., Weston, FL, Disney Elements © Disney 2006. MODÈLE: DCD6011-MER GUIDE D'UTILISATION CONSIGNES DE SÉCURITÉ RISQUE DE CHOC ÉLECTRIQUE NE PAS OUVRIR MISE EN GARDE EMPLACEMENT DES CONTRÔLES TENSIONS DANGEREUSES : Le symbole d'éclair avec une flèche, à l'intérieur d'un triangle équilatéral, alerte l'utilisateur de la présence de « tensions dangereuses » non isolées à l'intérieur du boîtier de l'appareil, d'une valeur suffisante pour constituer un risque d'électrocution. MISE EN GARDE : POUR RÉDUIRE LES RISQUES DE CHOCS ÉLECTRIQUES, N'OUVREZ JAMAIS LE BOÎTIER DE L'APPAREIL (NI LE COUVERCLE ARRIÈRE). AUCUNE PIÈCE À L'USAGE DE L'UTILISATEUR NE SE TROUVE À L'INTÉRIEUR. CONFIEZ LA RÉPARATION À UN TECHNICIEN QUALIFIÉ. ATTENTION : Le point d'exclamation à l'intérieur d'un triangle équilatéral est destiné à attirer l'attention de l'utilisateur sur la présence d'instructions d'exploitation et d'entretien dans le manuel fourni avec l'appareil. DANGER : Ce produit utilise un laser de classe 1 pour lire les disques compacts. Ce lecteur laser de disques compacts est équipé d'un interrupteur de sûreté pour éviter les risques d'exposition lorsque le couvercle du compartiment CD est ouvert et que les interrupteurs de verrouillage sont déconnectés. Le rayonnement laser émis lorsque le couvercle est ouvert et que les interrupteurs de verrouillage sont défectueux ou déconnectés, est invisible et dangereux. Évitez tout contact direct avec le faisceau. N'essayez pas de déconnecter les interrupteurs de sûreté. 1. Prise pour casque d'écoute (Partie latérale de l'appareil) 2. 2 prises pour casque d'écoute (Partie latérale de l'appareil) 3. Bouton SKIP/SEARCH (o) (Recherche/Saut) 6. Bouton PLAY/PAUSE (®p)/POWER ON 4. Réglage du VOLUME 5. Bouton SKIP/SEARCH (n) (Recherche/Saut) 9. Compartiment CD avec compartiment à piles (à l'intérieur) 10. Affichage 11. Bouton MODE (Mode) 12. Bouton PROG (Programmation) 13. Bouton ESP (Circuit antichoc) 14. Bouton STOP (X)/POWER OFF (Lecture/Pause) 7. Interrupteur DBBS 8. Prise d'alimentation CC 4,5 V (DC 4.5 V)­à l'endos Z (Stop/Arrêt) 15. Interrupteur CD OPEN (Ouverture/Fermeture du compartiment CD) 2. Si l'appareil est éteint, appuyez sur le bouton PLAY/PAUSE (®p)/ POWER ON (Lecture/Pause) pour lire le CD. Pour mettre sur pause, appuyez à nouveau sur le bouton PLAY/PAUSE (®p)/POWER ON (Lecture/Pause), le temps écoulé clignote. Appuyez une seconde fois pour redémarrer la lecture. 3. Réglez la commande du VOLUME et l'interrupteur DBBS (pour augmenter la basse) jusqu'à obtenir le son désiré. Pour sauter en avant ou en arrière entre les pistes du disque, appuyez sur le bouton SKIP/SEARCH O ou N (Recherche/Saut). Pour chercher en avant ou en arrière entre les pistes du disque, appuyez sur le bouton SKIP/SEARCH O ou N (Recherche/Saut). 4. La lecture du disque s'arrête. Appuyez sur le bouton STOP (X)/POWER OFF (Stop/Arrêt) pour arrêter la lecture du disque avant la fin de celui-ci, le nombre total de pistes apparaît. En mode arrêt, appuyez à nouveau sur le bouton STOP (X)/POWER OFF (Stop/Arrêt) pour éteindre l'appare ...