Synthesized Marine Transceiver VHF/FM 25/1 Watt REGATTATM 2 Models RG2W or RG2B Page 1 TABLE OF CONTENTS 3 ABOVE ALL... SAFETY! ..............................................................4 3.1 3.2 Symbols used .........................................................................4 Warnings ................................................................................4 3.2. General..................................................................................................... 4 3.2.a Radio Frequency / Installation.............................................................. 4 3.2.b Environmental ......................................................................................... 4 5.6 5.7 5.8 6 Selecting high and low transmission power............................. 15 Instant recall of channel 16 .................................................... 15 Display lighting ..................................................................... 15 SCANNING FUNCTIONS........................................................... 16 6.1 Channel scanning................................................................. 16 6.2 Dual Watch and Triple Watch ................................................ 16 6.3 Activation of Dual Watch/Triple .............................................. 16 Memory channels (MEM mode)....................................................... 17 6.4. Memory scanning (SCAN MEMORY)...............................................17 6.4.a Reception/Transmission during SCAN MEMORY...........................17 6.4.b To delete/To jump a pre-selected channel in memory ...................17 3.3 3.4 3.5 3 Registration of your Marine Transceiver....................................4 Assistance..............................................................................5 Manual Notes..........................................................................5 7 DESCRIPTION OF CONTROLS AND CONNECTORS...................7 3.6 3.7 3.7 3.3 Front panel .............................................................................7 8 Back panel (connections).........................................................8 Microphone.............................................................................9 USE WITH GPS......................................................................... 18 7.1 7.2 7.3 Function ............................................................................... 18 GPS information on the display .............................................. 18 Customized setup................................................................. 18 4 INSTALLATION......................................................................... 10 4.1 Contents of package.............................................................. 10 4.2 Location for the transceiver ........................................................ 10 4.3 Mounting the transceiver............................................................ 11 4.4 Adjustment of angle................................................................... 11 4.5 Installation of the antenna/electromagnetic exposure ................... 12 4.6 Mounting of Microphone............................................................. 12 4.7 Connections.............................................................................. 13 4.7.a Power Supply........................................................................................13 4.7.b GPS device............................................................................................13 Male (Regatta) connector view.....................................................................13 4.7.c Antenna.................................................................................................13 8 DIGITAL SELECTIVE CALLING (DSC)...................................... 18 8.1 8.2 8.3 8.4 8.5 Introduction .......................................................................... 18 Mobile Marine Identification Service (MMSI) ........................... 18 Navigating the DSC menu ..................................................... 18 Individual call (Routine To) .................................................... 18 8.4. Sending an individual call ....................................................................19 Group calling (Group Call) ..................................................... 19 Sending a group call ......................................................................................19 8.6 General call to all ships (ALL SHIP SAFETY ­ ALL SHIP URGENCY).................................................................................... 20 8.6. Sending a call to all ships....................................................................20 8.7. DSC DISTRESS call ................................................................ 20 8.7.a Sending a DISTRESS call ..................................................................20 5 BASIC OPERATION.................................................................. 14 5.1 5.2 5.3 5.4 5.5 Turning REGATTA 2 on/off .................................................... 14 Volume regulation ................................................................. 14 Squelch Regulation ............................................................... 14 Selecting an operating channel............................................... 14 5.4. With alphanumeric keypad ..................................................................14 5.4.a Using the microphone buttons (UP or DOWN) ................................14 9 RECEIVING A DSC CALL ......................................................... 22 9.1 Receiving a distress call........................................................ 22 9.2 General call to all ships ......................................................... 22 Individual call ................................................................................. 22 10 CUSTOMIZATION ..................................................................... 23 10.1 Menu settings ....................................................................... 23 10.2 Navigation in the menu of settings.......................................... 23 Transmission and reception ................................................... 14 Page 2 10.3 10.4 10.5 10.6 10.7 10.8 10.9 10.10 List of settings ....................................................................... 23 " Log" (list of registered calls) ................................................. 23 "Dir" (Entries in the directory).................................................. 23 "Posn"(Setting of position co-ordinates and adjustment of UTC time) 24 "LCD" (display contrast)......................................................... 24 "Beep" (Enable/disable keypad beep) ..................................... 24 "ZONE"(Adjustment of UTC time deviation)............................. 25 MMSI (Setting of personal MMSI code and MMSI group code). 25 11 MAINTENANCE......................................................................... 25 11.1 Maintenance and warnings .................................................... 25 12 TROUBLESHOOTING ............................................................... 26 13 TECHNICAL SPECIFICATIONS:................................................ 27 13.1 Transmitter............................................................................ 27 13.2 Receiver............................................................................... 27 14 FREQUENCY TABLE................................................................ 28 Page 3 3 ABOVE ALL... SAFETY! 3.1 Symbols used with current regulations. Not following these instructions can cause personal injury and/or malfunction of the device. I I For ease and convenience of viewing, REGATTA 2 uses symbols to highlight urgent situations, practical advice, and general information. Do not use REGATTA 2 before connecting a suitable antenna that is in perfect working condition ­ although REGATTA 2 is protected, this may seriously damage the stages of transmission power. Do not use transmit before ensuring proper connection of the antenna. During transmission, remain at a minimum distance of 3 feet from the antenna. I Warnings such as this, shown using an open hand symbol, indicate a crucial description regarding technical repairs, dangerous conditions, safety warnings, advice and/or important information. Ignoring these symbols may result in serious problems and/or damage and/or personal injury. Notes such as this one indicate practical advice that we suggest be followed for optimal performance with REGATTA 2. 3.2.b Environmental I 2 Pay attention to ambient conditions ­ although REGATTA 2 is designed to operate under the most severe conditions, it is important to avoid exposure to environments that are excessively humid or dusty, or to temperatures outside the +5°F to +55°F range. Also avoid exposure to direct sunlight. Avoid jarring and excessive vibration ­ REGATTA 2 is built to resist mechanical shock and vibration as long as these are within the norm for any electrical device. Do not use this device in potentially explosive environments. A single spark may cause an explosion. 3.2 3.2. Warnings I I General This device has been tested for compliance with Class D digital marine device limits. These limits were created to allow for reasonable protection against damaging interference. This device is to be used solely as an aid to navigation. Its settings may be influenced by diverse factors, such as defects or malfunction of the device, environmental conditions or improper use. It is the user's responsibility to observe reasonable prudence and judgement in navigation, and as such this device should not be considered a substitute for this reasonable prudence and judgement. Do not open the radio for any reason! REGATTA 2's precision mechanics and electronics require expertise and specialized equipment; for the same reason, the radio should under no circumstances be realigned as it has already been calibrated for maximum performance. Unauthorized opening of the transceiver will nullify the warranty. I I I I 3.3 Registration of your Marine Transceiver For using GMDSS and DSC functions, the operator must have a GMDSS radio operator's certificate (SRC or LRC) and apply for a ships MMSI number at the local radio authority. Without MMSI number the radio can only be used as conventional VHF marine radio without DSC. Your distributor may program your radio according to your needs. 3.2.a Radio Frequency / Installation I Midland recommends following the requirements for prevention of radio frequency exposure. Unauthorized changes or modifications to this device may invalidate conformity to the FCC Regulations. All changes or modifications must be approved in writing by MIDLAND RADIO CORPORATION. This VHF DSC transceiver generates and irradiates electromagnetic energy (EME) at radio frequency (RF), and as such must be installed and placed in operating conditions that are in conformity with the instructions contained in this manual and I Page 4 3.4 Assistance ____________________________________________ We urge you to write the serial number of your transceiver in the space provided below. This number is found on the back panel of the transceiver and will be useful in the event of repair/assistance and/or loss and/or theft. IN CASE OF EMERGENCY If you have need of assistance, contact other vessels and the Coast guard by sending a distress signal on Channel 16. NOTE . A WARNING STICKER is supplied with this transceiver. To comply with FCC regulations, this sticker must be affixed in such a location as to be readily seen from the operating controls of the radio as in the diagram below. Make sure the chosen location is clean and dry before applying the sticker. USING CHANNEL 16 DISTRESS CALL PROCEDURE 1. 2. 3. 4. 5. 6. "MAYDAY MAYDAY MAYDAY." "THIS IS ............." (name of vessel) Your callsign or other indication of the vessel (and 9-digit DSC ID if you have one. "LOCATED AT ............" (your position) The nature of the distress or assistance required. Any other information which might facilitate the rescue. Or transmit your distress call using Digital Selective Calling on channel 70. USING DIGITAL SELECTIVE CALLING (ch70) DISTRESS CALL PROCEDURE 1. 2. 3. 4. 5. While holding aside the key cover, press the DISTRESS key. Repeat pressing softkey "Undefined" to select the type of distress. Holding aside the key cover, press and hold the DISTRESS key for 5 seconds until you have heard 5 beeps. Wait for an acknowledgement from a coast station. Channel 16 is automatically selected. Press PTT and transmit the information listed above. 3.5 Manual Notes Writing of this manual has been completed with the intention of supplying information that is comprehensive, precise and up-to-date. Nevertheless, Midland does not assume responsibility for the actual ...