Movita child I - child II User manual These operating instructions contain information, settings, safety precautions, which are to be considered with the use of Movita child I and child II, as well as other important data. Movita child I and child II are not to be used on diagonal and uneven ground. Movita child I and child II are walking aids for children of 1-11/2 years to 8 years. Movita is directed mainly towards walk-obstructed people who, without support, cannot keep themselves upright. Movita can be adapted individually to the needs of a child. The thoracic support holds the upper body in an upright position and gives the user security. The pelvic support holds the child on the seat, and the handle gives a relieved support for the arms. The thoracic support and the pelvic support can be opened with a simple motion, this makes the transfer particularly easy. Movita child I and child II can be used indoors and outdoors, thanks to the large wheels. Start-up Movita child I and child II are assembled completely when delivered. Under the seat a hexagonal wrench is located (fig. 2). Basic model adjustment Height of the thoracic support and seat For height adjustment of the thoracic support, loosen the two bottom handles (fig. 4). Once the desired height has been reached, the handles need to be tightened whereby the same height can be adjusted on both sides with the help of the height framework. The seat height can be adjusted by loosening both upper handles (fig. 4). Once the desired height has been achieved, both handles need to be tightened, whereby with the help of the height framework the exact height can be adjusted. Thoracic support The thoracic support can be opened or closed through lightly raising or pressing down on the padded pipe (fig. 6). Springs The two springs in the lower pipes can be exchanged, if a harder or softer suspension is needed (fig. 5). The springs are available in four different levels of stiffness, which are appropriate for the following body weights 10 kg - 15 kg 20 kg -25 kg. To exchange the springs, the front handle will first need to be unscrewed from the pipes on both sides (fig. 7). Then the front handle is swiveled forward and the entire upper section is lifted from the stand (fig. 8). The underframe is placed upside down, thus the springs can fall out (fig. 9). After the new springs are introduced, the upper section can be inserted again into the pipes. Seat The seat can be pushed backwards and forwards. Loosen the large screw under the seat attachment pipe (fig. 10). When the desired position is found the screw needs to be tightened again. In addition, the angle of the seat can be adjusted by loosening the two internal hexagonal screws under the seat (fig. 10). After adjusting, the screws are tightened again. Manufacturer: elmi GmbH - Handwerkerzone 25 - I-39052 Kaltern - Tel 0471 961002 - FAX 0471 962374 elmisrl@tin.it - www.movita.it -2- Movita child l-child User manual Pelvic support The pelvic support behind the seat can be lifted or pushed down, whereby an internal hexagonal screw becomes visible. If the screw is loosened the pelvic support can be pushed back or forward (fig. 11). After adjusting, the screw is tightened again. Handle The handle is fastened to both sides by an aluminum part to the framework. The height and the length of the handle can be adjusted by opening both internal hexagonal screws. Safety precautions Warning: Never leave the user of Movita child I and child II without supervision. CE- tested brand: Movita child I and child II are provided with a CE-marking. Technical data length width seat height thoracic support height (side) thoracic support, perimeter wheels dimension front wheels dimension rear load in relation to shock absorbers frame wheels thoracic support and handle seat child I 72 cm 64.50 cm 21-41.80 cm 54 - 70.50 cm 70/90 cm 140x30 mm 250 x 50 mm 10kg/15kg/20kg/25kg stainless steel tubular frame, powder coated full rubber, suitable for indoor and outdoor use covered with soft and anallergic rubber anatomic child II 72cm 64.50cm 27-61 cm 69.50 - 84.50 cm 70/90 cm 140x30 mm 250 x 50 mm 10kg/15kg/20kg/25kg Manufacturer: elmi GmbH - Handwerkerzone 25 - I-39052 Kaltern - Tel 0471 961002 - FAX 0471 962374 elmisrl@tin.it - www.movita.it ...