User manual NETGEAR AG711T - INSTALLATION GUIDE

TM Gigabit Ethernet Modules AG711T / AG711F The modularity of the FS726 and 750 Switches provides you with a highly adaptable network. You not only can configure your network for copper and/or fiber gigabit uplinks, but you also can opt to expand your network gradually and affordably, as needed. Installing a Gigabit Ethernet module: 1. Unscrew and remove the module cover plate. 2. Insert the module into the slot, pressing firmly to seat the module. 3. Tighten the module screws. 4. Press the reset button if the power has remained on throughout the installation of the gigabit modules. Trademarks NETGEAR is a registered trademark of NETGEAR, Inc., in the United States and other countries. All other trademarks and registered trademarks are the property of their respective owners. All rights reserved. Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the products described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein. Certificate of the Manufacturer/Importer It is hereby certified the NETGEAR Model AG711T and AG711F Product Description has been suppressed in accordance with the conditions set out in the MBPT-AmtsblVfg 243/1991 and Vfg 46/1992. The operation of some equipment (for example, test transmitters) in accordance with the regulations may, however, be subject to certain restrictions. Please refer to the notes in the operating instructions. Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and has been granted the right to test the series for compliance with the regulations. EN 55 022 Declaration of Conformance This is to certify that the NETGEAR Model AG711T and AG711F Product Description is shielded against the generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Article 4a. Conformity is declared by the application of EN 55 022 Class A (CISPR 22) FCC Compliance Notice: Radio Frequency Notice Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: - This device may not cause harmful interference. - This device mush accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case users will be required to take whatever measures may be necessary to correct the interference at their own expense. Warning/Logo Warning: This is a Class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take appropriate measures. Specifications AG711T: IEEE802.3ab 1000BASE-T Gigabit Ethernet AG711F: IEEE802.3z 1000BASE-SX Gigabit Ethernet M1-AG711-0 TM