NIKE OREGON SERIES ANALOG chrono Chronograph MINUTES dial (0-60) Pull Crown to first click to set time Chronograph 1/10 SECOND dial (0-2) Crown Chronograph SECONDS dial (0-60) 24 HOUR Clock corresponds with Time of Day NOTE: To conserve battery life, the 1/10 SECOND dial will stop after the first minute and only move to mark tenths of a second when the LAP button is pressed. Start / Stop Chronograph If the stopwatch dial hands do not return to "0" position, pull Crown for calibration Mark Lap Press until 1/10 SECOND dial reads zero Pull Crown for calibration Restart Chronograph after Marked Lap Reset Stopped Chronograph Press and Hold until MINUTES and SECONDS dials read zero NOTE: The 1/10 SECOND dial will stop after 60 seconds to save battery life. The MINUTES and SECONDS dials will continue movement NOTE: The Chronograph will stop and reset after one hour NOTE: The MINUTES dial moves one minute for every 60 second revolution of the SECONDS dial NIKE OREGON SERIES ANALOG super & regular H20 RESIST 100 m Crown OPERATING TEMPERATURE -5 to 50° Celsius Material Specifications 27 CRYSTAL Mineral Glass STRAP Polyurethane CASE Aluminum CASEBACK Stainless Steel Pull Crown to first click to set date BUTTONS Stainless Steel BUCKLE Stainless Steel 27 28 Battery CHRONO SR920SW SUPER SR621SW REGULAR SR621SW Pull Crown to second click to set time 28 Battery Replacement Do not open watch back . Battery replacement must be performed by a certified Nike service center to retain a valid warranty. In addition to battery replacement, the service center will test movement, gaskets, water resistance and hardware, to further ensure the long-term care of your watch. © 2003 Nike, Inc. All rights reser ved. ...