Installing the IPC-6 RMP Step 1 A A A A Step 2 C: Remove screws from the bottom of the front panel and detach from chassis CAUTION! Unit must be unplugged before cover is removed A: Remove screws from the IPC-6 chassis B: Remove the top cover. B A A C C C C Step 3 D: Slide out the plastic retainers Step 4 E: Pull the circuit board away from the front panel E D BACKVIEW BACKVIEW D E Step 5 F: Gently line-up and place circuit board into the rack-mount panel F Step 6 G: Slide the plastic retainers back into place F G G Step 7 H: Return the front panel to the chassis and replace screws at the bottom of the front panel Step 8 J J J J I I: Return the cover to the unit H H H H J: Return the screws to the RVL-6 cover J J Niles Audio Corporation 12331 SW 130th Street Miami, Florida 33186 Tel: (305) 238-4373 Fax: (305) 238-0185 © 1999 Niles Audio Corporation. All rights reserved. Because Niles constantly strives to improve the quality of its products, Niles reserves the right to change product specifications without notice. Niles and the Niles logo are registered trademarks of Niles Audio Corporation. Printed in the USA 6/96 DS00170 www.nilesaudio.com ...