User manual NILES SVL-6 RMP - INSTALL GUIDE

Installing the SVL-4 RMP, SVL-4A/B RMP, SVL-6 RMP Step 1 A A CAUTION! Before removing top cover disconnect the speaker selector to the amplifier/receiver. A: Remove the screws from the top and sides of the chassis A B A A B: Remove the top cover A Step 2 C: Turn each knob completely counterclockwise (to the full "off" position). With a 5/64" allen wrench, locate the two set screws on the side of the knob and loosen both screws until the knob can be removed. Remove all knobs D: Remove the screws from the bottom of the front panel and detach from the chassis C D D D D Step 3 E: Secure the rack mount panel to the chassis replacing screws at the bottom of the panel F: Return all of the knobs to the full "off" position, secure both set screws using the allen wrench F E E E E Step 4 H H G H G: Return the top cover to the unit H: Replace the top cover screws H H H Niles Audio Corporation 12331 S.W. 130th Street Miami, Florida 33186 Tel: (305) 238-4373 Fax: (305) 238-0185 © 1999 Niles Audio Corporation. All rights reserved. Because Niles constantly strives to improve the quality of its products, Niles reserves the right to change product specifications without notice. Niles and the Niles logo are registered trademarks of Niles Audio Corporation. Printed in the USA 7/96 DS00176A www.nilesaudio.com