|
|
|
|
|
User manual PHILIPS 109P2099
Diplodocs help download the user guide PHILIPS 109P2099 .
This product, although classified under the brand PHILIPS, may have been manufactured by GEMINI INDUSTRIES, NORELCO, RADIOLA after mergers, acquisitions, or a change in name.
Preview of the first 3 pages of manual
You either have JavaScript turned off or an old version of Adobe Flash Player Get the latest Flash Player.
Manual abstract: user guide PHILIPS 109P2099
Detailed instructions for use are in the User's Guide. electronic user's manual
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/109P/manual.html [8/29/2001 3:06:26 PM]
Safety & Troubleshooting
Safety and Troubleshooting Information
Safety Precautions and Maintenance · Troubleshooting · Regulatory Information · Other Related Information
Safety precautions and maintenance WARNING: Use of controls, adjustments, or procedures other than those specified in this documentation may result in exposure to shock, electrical hazards, and/or mechanical hazards.
Read and follow these instructions when connecting and using your computer monitor: q Disconnect the monitor from the power supply if the monitor is not to be used for an extended period of time.
q q q q q
Do not attempt to remove the back cover, as you will be exposed to a shock hazard. The back cover should only be removed by qualified service personnel. Do not place objects on top of the monitor cabinet, objects could fall into vents or cover them and prevent proper cooling of the monitor's electronic devices. To avoid the risk of shock or permanent damage to the set, do not expose the monitor to rain or excessive moisture. Do not use alcohol or ammonia-based liquid to clean the monitor. If necessary, clean with a slightly damp cloth. Disconnect the monitor from the power supply before cleaning. When positioning the monitor, make sure the power plug and outlet are easily accessible.
Consult a service technician if the monitor does not operate normally when operating instructions of this manual are followed.
RETURN TO TOP OF THE PAGE
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/109P/SAFETY/SAFETY.HTM [8/29/2001 3:06:59 PM]
About This Electronic User's Manual
About This Electronic User's Manual
About This Guide · Other Documents You May Need · Notational Descriptions
About This Guide
This electronic user's guide is intended for anyone who uses the Philips Color Monitor. It describes the monitor's features, setup, operation and all other information, which is the same exact information described in our printed version. The sections are as follows:
q
q q
Safety and Troubleshooting Information provides tips and solutions for common problems, and other related information you may need. About This Electronic User's Manual gives overview of what information are included as well as notation icon descriptions and other documentation you can refer to. Product Information gives an overview of the monitor's features and as well as the technical specifications for this monitor. Installing Your Monitor describes the initial setup process and gives an overview of how to use the monitor. On Screen Display provides information on adjusting the settings on your monitor. Customer Care and Warranty is a list of worldwide Philips consumer information centers along with the help desk phone numbers and information on the applicable warranty of your product.. Glossary provides more information for technical terms. Download allows users to install the entire manual on their hard drive. Frequently Asked Questions provides answers to commonly asked questions.
q
q q
q q q
RETURN TO TOP OF THE PAGE
Other Documents You May Need
In addition to this Electronic User's Guide, you may need to refer to the following documentation:
q
Philips Color Monitor Quick Start Guide which summarizes the steps for setting up the monitor. This is included with this product.
RETURN TO TOP OF THE PAGE
Notational Descriptions
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/109P/ABOUT/ABOUT.HTM (1 of 2) [8/29/2001 3:06:59 PM]
About This Electronic User's Manual
The following subsections describe notational conventions used in this document. Notes, Cautions, and Warnings Throughout this guide, blocks of text may be accompanied by an icon and printed in bold type or in italic type. These blocks are notes, cautions, and warnings, and they are used as follows: NOTE: This icon indicates important information and tips that help you make better use of your computer system.
CAUTION: This icon indicates information that tells you how to avoid either potential damage to hardware or loss of data.
WARNING: This icon indicates the potential for bodily harm and tells you how to avoid the problem.
SMART HELP: This icon indicates helpful information when adjusting the On Screen Display of your monitor.
Some warnings may appear in alternate formats and may be unaccompanied by an icon. In such cases, the specific presentation of the warning is mandated by regulatory authority.
RETURN TO TOP OF THE PAGE
©2001 Koninklijke Philips Electronics N.V. All rights reserved. Reproduction, copying, usage, modifying, hiring, renting, public performance, transmission and/or broadcasting in whole or in part is prohibited without written consent of Philips Electronics N.V.
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/109P/ABOUT/ABOUT.HTM (2 of 2) [8/29/2001 3:06:59 PM]
109P Product Information
Product Information
Product Features · Technical Specifications · Automatic Power Saving · Physical Specification · Pin Assignment · Product Views
Product Features 109P20:
q q q q q q
19-inch (18.0" VIS) Real Flat color monitor featuring ICE technology for excellent front of screen performance for use with MACs, PCs or Workstations Autoscan covers horizontal frequencies up to 111 kHz offering a maximum resolution of 2048 x 1536 with flicker free display of 1280 x 1024 at up to 100 Hz Real Flat aperture grille CRT with high-resolution 0.24 mm uniform grille pitch. Auto Calibrate extends the useful life of the monitor by automatically adjusting color and luminance to original values XSD-Xtra Space Design for large screen display in a small footprint: World's shortest 19-inch Real Flat monitor with maximum depth of only 438mm/17.2" FCC, CE (in selected countries only) and ISO9241, ISO14001 certified RETURN TO TOP OF THE PAGE
Technical Specifications* CRT
· Size and deflection · Dot pitch / Grille pitch · Horizontal pitch · Tube type · Phosphor · Recommended display area · Maximum display area Aperture grille, flat, high contrast, anti-glare, anti-static, anti reflection, light transmission 41% B22 14.0" x 10.4" / 355 x 265 mm 14.4" x 10.8" / 365 x 274 mm 19 inch / 46 cm ; 90° deflection angle 0.24 mm
SCANNING
· Horizontal scanning · Vertical scanning 30 - 111 KHz 50 - 160 Hz
VIDEO
· Video dot rate · Input impedance 261 MHz
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/109P/PRODUCT/PRODUCT.HTM (1 of 4) [8/29/2001 3:06:59 PM]
109P Product Information
- Video - Sync · Input signal levels · Sync input signal
75 ohm 2.2 kOhm 0.7 Vpp Separate sync Composite sync
· Sync polarities
Positive and negative
WHITE COLOR TEMPERATURE
Chromaticity CIE coordinates: · at 9300 K degrees · at 6500 K degrees · at 5500 K degrees x = 0.283 / y = 0.297 x = 0.313 / y = 0.329 x = 0.332 / y = 0.347
* These information are subject to change without notice.
RETURN TO TOP OF THE PAGE
Automatic Power Saving
If you have VESA's DPMS compliance display card or software installed in your PC, the monitor can automatically reduce its power consumption when not in use. And if an input from a keyboard, mouse or other input device is detected, the monitor will automatically "wake up". The following table shows the power consumption and signaling of this automatic power saving features:
Power Management Definition VESA's Mode
ON Stand-by Suspend OFF
Video
Active Blanked Blanked Blanked
H-sync
Yes No Yes No
V-sync
Yes Yes No No
Power Used
Typical 120 W <3W < 3W <3W
Power LED color Saving (%)
0% 97.5% 97.5% 97.5% Green Yellow Yellow Yellow
This monitor is ENERGY STAR® compliant. As an ENERGY STAR® Partner, PHILIPS has determined that this product meets the ENERGY STAR® guidelines for energy efficiency.
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/109P/PRODUCT/PRODUCT.HTM (2 of 4) [8/29/2001 3:06:59 PM]
109P Product Information
RETURN TO TOP OF THE PAGE
Physical Specifications
· Dimensions · Weight · Power supply · Temperature (operating) · Temperature (storage) · Relative humidity
17.9"x 18.5" x 17.2" / 456 x 469 x 437 mm (including base) 17.9"x 16.5" x 17.2" / 456 x 419 x 437 mm (excluding base) 23.5 kg 90 - 264 VAC, 50/60Hz 0° to 35°C / 32° to 95°F -25° to +65°C / -13° to +149°F 5% to 95%
* Resolution 1280 x 1024, standard size, contrast max., brightness 50%, 9300°, full white pattern.
* These information are subject to change without notice.
RETURN TO TOP OF THE PAGE
Pin Assignment
The 15-pin D-sub connector (male) of the signal cable (IBM systems):
Pin Assignment No.
1 2 3 4 5 6 Red video input Green video input Blue video input Identical output - connected to pin 10 Ground Red video ground
Pin Assignment No.
9 10 11 12 13 14 No pin Logic ground Identical output - connected to pin 10 Serial data line (SDA) H. Sync / H+V V. Sync (VCLK for DDC)
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/109P/PRODUCT/PRODUCT.HTM (3 of 4) [8/29/2001 3:06:59 PM]
109P Product Information
7 8
Green video ground Blue video ground
15
Data clock line (SCL)
RETURN TO TOP OF THE PAGE
Views
Follow the links to see various views of the monitor and its components.
Front View Rear View
RETURN TO TOP OF THE PAGE
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/109P/PRODUCT/PRODUCT.HTM (4 of 4) [8/29/2001 3:06:59 PM]
Installing your Monitor
Installing your Monitor
Front View · Rear View · 6G3B11 Multimedia Base (option) · PCUH411 USB Hub (option)
Front View
Power button switches your monitor on.
OK button which when pressed will take you to the OSD controls
Contrast hotkey. When the UP arrow is pressed, the adjustment controls for the CONTRAST will show up.
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/INSTALL_2/INSTALL.HTM (1 of 3) [8/29/2001 3:07:00 PM]
Installing your Monitor
UP and DOWN buttons are used when adjusting the OSD of your monitor
Brightness hotkey. When the RIGHT arrow is pressed, the adjustment controls for BRIGHTNESS will show up.
LEFT and RIGHT buttons, like the UP and DOWN buttons, are also used in adjusting the OSD of your monitor.
RETURN TO TOP OF THE PAGE
Rear View
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/INSTALL_2/INSTALL.HTM (2 of 3) [8/29/2001 3:07:00 PM]
Installing your Monitor
1. Power in - attach power cable here. 2. Video In - this is a cable which is already attached to your monitor. Connect the other end of the cable to your PC.
RETURN TO TOP OF THE PAGE
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/INSTALL_2/INSTALL.HTM (3 of 3) [8/29/2001 3:07:00 PM]
On-Screen Display
On-Screen Display
Description of the On-Screen Display · The OSD Tree · The OSD Controls
Description of the On Screen Display
What is the On-Screen Display? This is a feature in all Philips monitors which allows an end-user to adjust screen performance of monitors directly though an on-screen instruction window. The user interface provides user-friendliness and ease-of-use when operating the monitor.
Basic and simple instruction on the control keys. On the front controls of your monitor, once you press the Use the or the button, the On Screen Display (OSD) Main
Controls window will pop up and you can now start making adjustments to your monitor's various features. keys to make your adjustments within.
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/OSD/OSDDESC.HTM (1 of 4) [8/29/2001 3:07:00 PM]
On-Screen Display
RETURN TO TOP OF THE PAGE
The OSD Tree
Below is an overall view of the structure of the On-Screen Display. You can use this as reference when you want to later on work your way around the different adjustments.
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/OSD/OSDDESC.HTM (2 of 4) [8/29/2001 3:07:00 PM]
On-Screen Display
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/OSD/OSDDESC.HTM (3 of 4) [8/29/2001 3:07:00 PM]
On-Screen Display
RETURN TO TOP OF THE PAGE
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/OSD/OSDDESC.HTM (4 of 4) [8/29/2001 3:07:00 PM]
Customer Care and Warranty
Customer Care & Warranty
PLEASE SELECT YOUR COUNTRY/AREA TO READ THE WARRANTY COVERED: WESTERN EUROPE: Austria · Belgium · Cyprus · Denmark · France · Germany · Greece · Finland · Ireland · Italy · Luxembourg · the Netherlands · Norway · Portugal · Sweden · Switzerland · Spain · United Kingdom EASTERN EUROPE: Czech Republic · Hungary · Poland · Russia · Turkey · Bulgaria LATIN AMERICA: Antilles · Argentina · Brazil · Chile · Colombia · Mexico · Paraguay · Peru · Uruguay · Venezuela NORTH AMERICA: Canada · USA PACIFIC: Australia · New Zealand ASIA: Bangladesh · China · Hong Kong · India · Indonesia · Japan · Korea · Malaysia · Pakistan · Philippines · Singapore · Taiwan · Thailand AFRICA: Morocco · South Africa MIDDLE EAST: Dubai · Egypt
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/WARRANTY/WARRANTY.HTM [8/29/2001 3:07:00 PM]
Frequently Asked Questions
Frequently Asked Questio ...
|