Philips 200P3M/200P3G Electronic User's Manual file:///D|/K1/english/200p3mg/index.htm [1/3/2003 3:34:16 PM] Safety & Troubleshooting Safety and Troubleshooting Information Safety Precautions and Maintenance · Installation Locations · FAQs · Troubleshooting · Regulatory Information · Other Related Information Safety precautions and maintenance WARNING: Use of controls, adjustments or procedures other than those specified in this documentation may result in exposure to shock, electrical hazards and/or mechanical hazards. Read and follow these instructions when connecting and using your computer monitor: q Unplug the monitor if you are not going to use it for an extensive period of time. q Unplug the monitor if you need to clean it with a slightly damp cloth. The screen many be wiped with a dry cloth when the power is off. However, never use alcohol, solvents or ammonia-based liquids. q q q q q q q q q q q Consult a service technician if the monitor does not operate normally when you have followed the instructions in this manual. The casing cover should be opened only by qualified service personnel. Keep the monitor out of direct sunlight and away from stoves or any other heat source. Remove any object that could fall into the vents or prevent proper cooling of the monitor's electronics. Do not block the ventilation holes on the cabinet. Keep the monitor dry. To avoid electric shock, do not expose it to rain or excessive moisture. When positioning the monitor make sure the power plug and outlet are easily accessible. If turning off the monitor by detaching power cable or DC power cord, wait for 6 seconds before attaching the power cable or DC power cord for normal operation. To avoid the risk of shock or permanent damage to the set do not expose the monitor to rain or excessive moisture. When positioning the monitor, make sure the power plug and outlet are easily accessible. IMPORTANT: Always activate a screen saver program during your application. If a still image in high contrast remains on the screen for an extended period of time, it may leave an 'after-image' or 'ghost image' on front of the screen. This is a well-known phenomenon that is caused by the shortcomings inherent in LCD technology. In most cases the after-image will disappear gradually over a period of time after the power has been switched off. Be aware that the after-image symptom cannot be repaired and is not covered under warranty. Consult a service technician if the monitor does not operate normally when the operating instructions given in this manual have been followed. RETURN TO TOP OF THE PAGE Installation Locations q Avoid exposure to heat and extreme cold file:///D|/K1/english/200p3mg/safety/safety.htm (1 of 2) [1/3/2003 3:34:22 PM] Safety & Troubleshooting q q Do not store or use the LCD monitor in locations exposed to heat, direct sunlight or extreme cold. Avoid moving the LCD monitor between locations with large temperature differences. Choose a site that falls within the following temperature and humidity ranges. r Temperature: 5-35°C 41-95°F Humidity: 20-80% RH Do not subject the LCD monitor to severe vibration or high impact conditions. Do not place the LCD monitor inside a car boot. r q q q Take care not to mishandle this product by either knocking or dropping during operation or transportation. Do not store or use the LCD monitor in locations where there is a high level of humidity or in dusty environments. Do not allow water or other liquids to spill on or into the LCD monitor. RETURN TO TOP OF THE PAGE file:///D|/K1/english/200p3mg/safety/safety.htm (2 of 2) [1/3/2003 3:34:22 PM] About This Electronic User's Manual About This Manual About This Guide · Notational Descriptions About This Guide This electronic user's guide is intended for anyone who uses the Philips LCD Monitor. It describes the LCD monitor's features, setup, operation and other important information. Its contents are identical to the information in our printed version. It includes the following sections: q q q Safety and Troubleshooting Information provides tips and solutions for common problems as well as other related information you may need. About This Electronic User's Manual gives an overview of information included, along with notation icon descriptions and other documentation for your reference. Product Information gives an overview of the monitor's features as well as the technical specifications for this monitor. Installing Your Monitor describes the initial setup process and gives an overview of how to use the monitor. On-Screen Display provides information on adjusting the settings on your monitor. Customer Care and Warranty contains a list of worldwide Philips Consumer Information Centers along with help desk phone numbers and information on the warranty applicable to your product. Glossary defines technical terms. Download and Print Option transfers this entire manual to your hard drive for easy reference. q q q q q RETURN TO TOP OF THE PAGE Notational Descriptions The following subsections describe notational conventions used in this document. Notes, Cautions and Warnings Throughout this guide blocks of text may be accompanied by an icon and printed in bold or italic type. These blocks contain notes, cautions or warnings. They are used as follows: NOTE: This icon indicates important information and tips that help you make better use of your computer system. file:///D|/K1/english/200p3mg/about/about.htm (1 of 2) [1/3/2003 3:34:24 PM] About This Electronic User's Manual CAUTION: This icon indicates information that tells you how to avoid either potential damage to hardware or loss of data. WARNING: This icon indicates the potential for bodily harm and tells you how to avoid the problem. Some warnings may appear in alternate formats and may not be accompanied by an icon. In such cases, the specific presentation of the warning is mandated by the relevant regulatory authority. RETURN TO TOP OF THE PAGE ©2002 Koninklijke Philips Electronics N.V. All rights reserved. Reproduction, copying, usage, modifying, hiring, renting, public performance, transmission and/or broadcasting in whole or in part is prohibited without written consent of Philips Electronics N.V. file:///D|/K1/english/200p3mg/about/about.htm (2 of 2) [1/3/2003 3:34:24 PM] 200P3M/200P3G Product Information Product Information Product Features · Technical Specifications · Resolution & Preset Modes · Philips Pixel Defect Policy · Automatic Power Saving · Physical Specification · Pin Assignment · Product Views · Physical Function Product Features BRILLIANCE 200P3M/200P3G q q q q q q q 20-inch color LCD monitor with excellent display performance Multiple video input allowing displaying of DVI-I digital/ analog, VGA analog, S-Video & CVBS Video inputs. Picture-in-Picture (PIP) function for displaying both PC and video simultaneous on the screen Embedded AC power supply Front firing speakers with stereo 2x2W RMS stereo sound output Advanced AUTO adjustment optimizes picture quality Adjustable tilt and swivel function RETURN TO TOP OF THE PAGE Technical Specifications* LCD PANEL · Type · Screen size · Pixel Pitch · LCD Panel type · Effective viewing area · Display Colors TFT LCD 20.1" / 51cm 0.255 x 0.255mm 1600 x 1200 pixels R.G.B. vertical stripe Anti-glare polarizer, hard coated 408 x 306 mm 8 bits interface (16M colors) SCANNING Vertical refresh rate Horizontal Frequency 56Hz-85Hz 30kHz-94kHz (Analog input), 30kHz-92kHz(Digital input) file:///D|/K1/english/200p3mg/product/product.htm (1 of 7) [1/3/2003 3:34:27 PM] 200P3M/200P3G Product Information VIDEO · Video dot rate · Input impedance - Video - Sync · Input signal levels · Sync input signal · Sync polarities · S-Video · CVBS ·Video interface 75 ohm 2K ohm 0.7 Vpp Separate sync Composite sync Sync on green Positive and negative Y input 1.0Vpp, C input 0.3Vpp, 75ohm input impedance Composite, 1.0Vpp, 75ohm input impedance Triple input(two connectors): D-Sub(analog) and DVI-I(accepts both digital and analog) are available and user selectable S-Video & CVBS 202 MHz AUDIO-IN · Input signal level · Headphone out signal level · Input signal connector · Loudspeaker 0.7 Vpp 32 20+20mW 3.5mm mini jack 4W Stereo Audio (2W/channel RMSx2, 200Hz-12kHz, 4 ohm,THD=10%) MICROPHONE · Sensitivity · Output impedance · Directivity · Frequency range -45dB re 1V/Pa at 1kHz 2.2K max. -5dB at 180° 300Hz-3kHz Optical characteristics · Contrast ratio: · Brightness: · Peak contrast angle · White Chromatcity: 300 (typ.) 250 cd/m2 (typ.) 6 o'clock x: 0.281 y: 0.311 (at 9300°K) x: 0.312 y: 0.338 (at 6500°K) file:///D|/K1/english/200p3mg/product/product.htm (2 of 7) [1/3/2003 3:34:27 PM] 200P3M/200P3G Product Information · Viewing Angle: (C/R>10) · Response time Upper >85° (typ.) Lower >85° (typ.) Left >85° (typ.) Right >85° (typ.) <30ms (typ.) * This data is subject to change without notice. RETURN TO TOP OF THE PAGE Resolution & Preset Modes · Maximum 1600 x 1200 at 75Hz(analog input) 1600 x 1200 at 60Hz(digtal input) · Recommended 1600 x 1200 at 60Hz 50 user definable modes 18 factory preset modes: H. freq (kHz) 31.5 31.5 31.5 35.0 37.5 35.2 37.9 46.9 49.7 48.4 60.0 69.0 71.8 63.9 80 Resolution 640*350 720*400 640*480 640*480 640*480 800*600 800*600 800*600 832*624 1024*768 1024*768 1152*870 1152*900 1280*1024 1280*1024 V. freq (Hz) 70 (IBM VGA 10h) 70 60 67 75 56 60 75 75 60 75 75 76 (SUN Mode II) 60 75 file:///D|/K1/english/200p3mg/product/product.htm (3 of 7) [1/3/2003 3:34:27 PM] 200P3M/200P3G Product Information 91.1 75.0 93.8 1280*1024 1600*1200 1600*1200 85 60 75 RETURN TO TOP OF THE PAGE Automatic Power Saving If you have VESA DPMS compliance display card or software installed in your PC, the monitor can automatically reduce its power consumption when not in use. If an input from a keyboard, mouse or other input device is detected, the monitor will 'wake up' automatically. The following table shows the power consumption and signaling of this automatic power saving feature: Power Management Definition VESA Mode Video H-sync V-sync Power Used LED color ON OFF Active Blanked Yes No Yes No < 60W < 3W Green Amber This monitor is ENERGY STAR® compliant. As an ENERGY STAR® Partner, PHILIPS has determined that this product meets the ENERGY STAR® guidelines for energy efficiency. RETURN TO TOP OF THE PAGE Physical Specifications · Dimension (WxHxD) · Weight · Tilt / Swivel · Power supply · Power consumption 488 x 459 x220 mm (incl. Pedestal) 10.0 Kg -5° ~ 25° / + - 175° 100 -- 240 VAC, 50/60 Hz 52 W (typ.) file:///D|/K1/english/200p3mg/product/product.htm (4 of 7) [1/3/2003 3:34:27 PM] 200P3M/200P3G Product Information · Temperature · Relative humidity · System MTBF · Cabinet color 5° C to 35° C (operating) -20° C to 60° C (storage) 20% to 80% 50K hrs (including CCFL 40K hrs) 200P3M: Light Gray 200P3G: Black * This data is subject to change without notice. * Resolution 1600x1200, standard size, contrast max., brightness 50%, 9300° K, full white pattern, without audio/USB. RETURN TO TOP OF THE PAGE Pin Assignment 1. The digital/analog DVI-I onnector contains 29 signal contacts organized in three rows of eight contacts. Signal pin assignments are listed in the following table: Pin No. 1 2 3 4 Signal Assignment TMDS Data 2TMDS Data 2+ TMDS Data 2/4 Shield TMDS Data 4- Pin No. 9 Signal Assignment TMDS Data 1- Pin Signal No. Assignment 17 18 19 20 TMDS Data 0TMDS Data 0+ TMDS Data 0/5 Shield TMDS Data 5TMDS Data 5+ TMDS Clock Shield TMDS Clock+ TMDS Clock- Pin No. C1 C2 C3 C4 Signal Assignment Analog Red Video Out Analog Green Video Out Analog Blue Video Out Analog Horizontal Sync Analog Common Ground Return (Red, Green, Blue Video Out) 10 TMDS Data 1+ 11 TMDS Data 1/3 Shield 12 TMDS Data 3- 5 TMDS Data 4+ 13 TMDS Data 3+ 21 C5 6 7 8 DDC Clock DDC Data Analog Vertical Sync 14 +5V Power 15 Ground (+5V, Analog H/V Sync) 22 23 24 16 Hot Plug Detect file:///D|/K1/english/200p3mg/product/product.htm (5 of 7) [1/3/2003 3:34:27 PM] 200P3M/200P3G Product Information 2. The 15-pin D-sub connector (male) of the signal cable: Pin Assignment No. 1 2 3 4 5 6 7 8 Red video input Green video input/SOG Blue video input Sense (GND) Not connected Red video ground Green video ground Blue video ground Pin Assignment No. 9 10 11 12 13 14 15 +5V Logic ground Identical output - connected to pin 10 Serial data line (SDA) H. Sync / H+V V. Sync (VCLK for DDC) Data clock line (SCL) RETURN TO TOP OF THE PAGE Product Views Follow the links to see various views of the monitor and its components. Front View Product Description RETURN TO TOP OF THE PAGE Physical Function file:///D|/K1/english/200p3mg/product/product.htm (6 of 7) [1/3/2003 3:34:27 PM] 200P3M/200P3G Product Information 1) Tilt 2) Swivel RETURN TO TOP OF THE PAGE file:///D|/K1/english/200p3mg ...