electronic user's manual file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/201B/manual.html [8/29/2001 3:11:09 PM] Safety & Troubleshooting Safety and Troubleshooting Information Safety Precautions and Maintenance · Troubleshooting · Regulatory Information · Other Related Information Safety precautions and maintenance WARNING: Use of controls, adjustments, or procedures other than those specified in this documentation may result in exposure to shock, electrical hazards, and/or mechanical hazards. Read and follow these instructions when connecting and using your computer monitor: q Disconnect the monitor from the power supply if the monitor is not to be used for an extended period of time. q q q q q Do not attempt to remove the back cover, as you will be exposed to a shock hazard. The back cover should only be removed by qualified service personnel. Do not place objects on top of the monitor cabinet, objects could fall into vents or cover them and prevent proper cooling of the monitor's electronic devices. To avoid the risk of shock or permanent damage to the set, do not expose the monitor to rain or excessive moisture. Do not use alcohol or ammonia-based liquid to clean the monitor. If necessary, clean with a slightly damp cloth. Disconnect the monitor from the power supply before cleaning. When positioning the monitor, make sure the power plug and outlet are easily accessible. Consult a service technician if the monitor does not operate normally when operating instructions of this manual are followed. RETURN TO TOP OF THE PAGE file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/201B/SAFETY/SAFETY.HTM [8/29/2001 3:11:38 PM] About This Electronic User's Manual About This Electronic User's Manual About This Guide · Other Documents You May Need · Notational Descriptions About This Guide This electronic user's guide is intended for anyone who uses the Philips Color Monitor. It describes the monitor's features, setup, operation and all other information, which is the same exact information described in our printed version. The sections are as follows: q q q Safety and Troubleshooting Information provides tips and solutions for common problems, and other related information you may need. About This Electronic User's Manual gives overview of what information are included as well as notation icon descriptions and other documentation you can refer to. Product Information gives an overview of the monitor's features and as well as the technical specifications for this monitor. Installing Your Monitor describes the initial setup process and gives an overview of how to use the monitor. On Screen Display provides information on adjusting the settings on your monitor. Customer Care and Warranty is a list of worldwide Philips consumer information centers along with the help desk phone numbers and information on the applicable warranty of your product.. Glossary provides more information for technical terms. Download allows users to install the entire manual on their hard drive. Frequently Asked Questions provides answers to commonly asked questions. q q q q q q RETURN TO TOP OF THE PAGE Other Documents You May Need In addition to this Electronic User's Guide, you may need to refer to the following documentation: q Philips Color Monitor Quick Start Guide which summarizes the steps for setting up the monitor. This is included with this product. RETURN TO TOP OF THE PAGE Notational Descriptions file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/201B/ABOUT/ABOUT.HTM (1 of 2) [8/29/2001 3:11:38 PM] About This Electronic User's Manual The following subsections describe notational conventions used in this document. Notes, Cautions, and Warnings Throughout this guide, blocks of text may be accompanied by an icon and printed in bold type or in italic type. These blocks are notes, cautions, and warnings, and they are used as follows: NOTE: This icon indicates important information and tips that help you make better use of your computer system. CAUTION: This icon indicates information that tells you how to avoid either potential damage to hardware or loss of data. WARNING: This icon indicates the potential for bodily harm and tells you how to avoid the problem. SMART HELP: This icon indicates helpful information when adjusting the On Screen Display of your monitor. Some warnings may appear in alternate formats and may be unaccompanied by an icon. In such cases, the specific presentation of the warning is mandated by regulatory authority. RETURN TO TOP OF THE PAGE ©2001 Koninklijke Philips Electronics N.V. All rights reserved. Reproduction, copying, usage, modifying, hiring, renting, public performance, transmission and/or broadcasting in whole or in part is prohibited without written consent of Philips Electronics N.V. file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/201B/ABOUT/ABOUT.HTM (2 of 2) [8/29/2001 3:11:38 PM] 201B Product Information Product Information Product Features · Technical Specifications · Automatic Power Saving · Physical Specification · Pin Assignment · Product Views Product Features 201B10: q q q q q q q 21-inch (20.0" VIS) color monitor with excellent front of screen performance for use with MACs, PCs or Workstations Autoscan covers horizontal frequencies up to 107 kHz offering a maximum resolution of 1920 x 1440 with flicker free display of 1600 x 1200 at up to 86 Hz Flat square Super High Contrast CRT with high-resolution 0.25 mm pitch (0.21 hdp) Auto Calibrate extends the useful life of the monitor by automatically adjusting color and luminance to original values. XSD-Xtra Space Design for large screen display in a small footprint: World's shortest 21-inch monitor with maximum depth of only 467 mm/18.4" Outstanding ease of use thanks to CustoMax® monitor control software via USB FCC, CE (in selected countries only) and ISO9241, ISO14001 certified RETURN TO TOP OF THE PAGE Technical Specifications* CRT · Size and deflection · Dot pitch / Grille pitch · Horizontal pitch · Tube type · Phosphor · Recommended display area 21 inch / 51 cm ; 201B10 - 90° deflection angle 0.25 mm 0.21 mm Shadow mask, flat square, super high contrast, anti-glare, anti-static, anti reflection, light transmission 43% P22 15.4" x 11.6" / 392 x 294 mm · Maximum display 16.0" x 12.0" / 406 x 305 mm area SCANNING · Horizontal scanning 30 - 107 KHz · Vertical scanning 50 - 160 Hz VIDEO file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/201B/PRODUCT/PRODUCT.HTM (1 of 4) [8/29/2001 3:11:39 PM] 201B Product Information · Video dot rate · Input impedance - Video - Sync · Input signal levels · Sync input signal 261 MHz 75 ohm 2.2 kOhm 0.7 Vpp Separate sync Composite sync · Sync polarities Positive and negative WHITE COLOR TEMPERATURE Chromaticity CIE coordinates: · at 9300 K degrees · at 6500 K degrees · at 5500 K degrees x = 0.283 / y = 0.297 x = 0.313 / y = 0.329 x = 0.332 / y = 0.347 * These information are subject to change without notice. RETURN TO TOP OF THE PAGE Automatic Power Saving If you have VESA's DPMS compliance display card or software installed in your PC, the monitor can automatically reduce its power consumption when not in use. And if an input from a keyboard, mouse or other input device is detected, the monitor will automatically "wake up". The following table shows the power consumption and signaling of this automatic power saving features: 201B10: Power Management Definition VESA's Mode ON Stand-by Suspend OFF Video Active Blanked Blanked Blanked H-sync Yes No Yes No V-sync Yes Yes No No Power Used < 104W < 3W < 3W < 3W Power LED color Saving (%) 0% 97% 97% 97% Green Yellow Yellow Yellow file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/201B/PRODUCT/PRODUCT.HTM (2 of 4) [8/29/2001 3:11:39 PM] 201B Product Information This monitor is ENERGY STAR® compliant. As an ENERGY STAR® Partner, PHILIPS has determined that this product meets the ENERGY STAR® guidelines for energy efficiency. RETURN TO TOP OF THE PAGE Physical Specifications 201B10 - 19.0" x 18.7" x 18.4" / 482 x 476 x 467 mm (including base) · Dimensions 201B10 - 19.0" x 17.2" x 18.4" / 482 x 437 x 467 mm (excluding base) · Weight · Power supply · Temperature (operating) · Temperature (storage) · Relative humidity 201B10 - 28.0 kg 90 - 264 VAC, 50/60Hz 0° to 35°C / 32° to 95°F -25° to +65°C / -13° to +149°F 5% to 95% * Resolution 1280 x 1024, standard size, contrast max., brightness 50%, 9300°, full white pattern. * These information are subject to change without notice. RETURN TO TOP OF THE PAGE Pin Assignment The 15-pin D-sub connector (male) of the signal cable (IBM systems): Pin Assignment No. 1 2 Red video input Green video input Pin Assignment No. 9 10 +5V Logic ground file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/201B/PRODUCT/PRODUCT.HTM (3 of 4) [8/29/2001 3:11:39 PM] 201B Product Information 3 4 5 6 7 8 Blue video input Identical output - connected to pin 10 Ground Red video ground Green video ground Blue video ground 11 12 13 14 15 Identical output - connected to pin 10 Serial data line (SDA) H. Sync / H+V V. Sync (VCLK for DDC) Data clock line (SCL) RETURN TO TOP OF THE PAGE Views Follow the links to see various views of the monitor and its components. Front View Rear View RETURN TO TOP OF THE PAGE file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/201B/PRODUCT/PRODUCT.HTM (4 of 4) [8/29/2001 3:11:39 PM] Installing your Monitor Installing your Monitor Front View · Rear View · PCUH411 USB Hub (option) Front View Power button switches your monitor on. OK button which when pressed will take you to the OSD controls Contrast hotkey. When the UP arrow is pressed, the adjustment controls for the CONTRAST will show up. file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/INSTALL_4/INSTALL.HTM (1 of 4) [8/29/2001 3:11:39 PM] Installing your Monitor UP and DOWN buttons are used when adjusting the OSD of your monitor Brightness hotkey. When the RIGHT arrow is pressed ,the adjustment controls for BRIGHTNESS will show up. LEFT and RIGHT buttons, like the UP and DOWN buttons, are also used in adjusting the OSD of your monitor. By pressing both the UP and OK buttons, you can easily access the Input Signals A and/or B. RETURN TO TOP OF THE PAGE Rear View file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/INSTALL_4/INSTALL.HTM (2 of 4) [8/29/2001 3:11:39 PM] Installing your Monitor 1. D-Sub Port - Attach the D-Sub connector that comes with your monitor here. Other end connects to your PC. 2. Power in - Attach power cable here. 3. USB Port - Attach your USB Upstream cable here. Connect the other end to your USB hub or your PC's USB connector. (Not available on all models.) 4. BNC Connectors - Attach the connectors here to get the best video file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/INSTALL_4/INSTALL.HTM (3 of 4) [8/29/2001 3:11:39 PM] Installing your Monitor performance from your monitor. RETURN TO TOP OF THE PAGE file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/INSTALL_4/INSTALL.HTM (4 of 4) [8/29/2001 3:11:39 PM] On-Screen Display On-Screen Display Description of the On-Screen Display · The OSD Tree · The OSD Controls Description of the On Screen Display What is the On-Screen Display? This is a feature in all Philips monitors which allows an end-user to adjust screen performance of monitors directly though an on-screen instruction window. The user interface provides user-friendliness and ease-of-use when operating the monitor. Basic and simple instruction on the control keys. On the front controls of your monitor, once you press the Use the or the button, the On Screen Display (OSD) Main Controls window will pop up and you can now start making adjustments to your monitor's various features. keys to make your adjustments within. file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/OSD/OSDDESC.HTM (1 of 4) [8/29/2001 3:11:40 PM] On-Screen Display RETURN TO TOP OF THE PAGE The OSD Tree Below is an overall view of the structure of the On-Screen Display. You can use this as reference when you want to later on work your way around the different adjustments. file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/OSD/OSDDESC.HTM (2 of 4) [8/29/2001 3:11:40 PM] On-Screen Display file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/OSD/OSDDESC.HTM (3 of 4) [8/29/2001 3:11:40 PM] On-Screen Display RETURN TO TOP OF THE PAGE file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/OSD/OSDDESC.HTM (4 of 4) [8/29/2001 3:11:40 PM] Customer Care and Warranty Customer Care & Warranty PLEASE SELECT YOUR COUNTRY/AREA TO READ THE WARRANTY COVERED: WESTERN EUROPE: Austria · Belgium · Cyprus · Denmark · France · Germany · Greece · Finland · Ireland · Italy · Luxembourg · the Netherlands · Norway · Portugal · Sweden · Switzerland · Spain · United Kingdom EASTERN EUROPE: Czech Republic · Hungary · Poland · Russia · Turkey · Bulgaria LATIN AMERICA: Antilles · Argenti ...