CD Soundmachine Audio AZ1500 AZ1505 Remote Control for AZ1505 model only English Français Español Meet Philips at the Internet http://www.audio.philips.com AZ 1500 AZ 1505 CLASS 1 LASER PRODUCT 3140 115 2893.1 W Printed in Hong Kong 1 $ #@ ! 09 8 RE 40 P SET DIG T ITAL UNE R 1 2 34 5 6 7 % ^ 9 8 7 REPEAT VOLUM E SHUFF LE 1 2 3 4 & * ( SEARCH PRESET 6 + - SEARCH TUNIN 5 G Remote Control for AZ1505 model only 2 8 DBB 3 MW 4 X PROG FM 5 SHUFFLE PROG DBB C B A A 6 PROG 7 9 AUSTRALIA Philips product warranty for Australia only Warranty conditions valid for Colour Television, Video Cassette Recorders, CD Recordable, DVD Players, Audio Systems, and Portable Audio. The benefits given to the purchaser by this warranty are in addition to all other rights and remedies which the purchaser has in respect of the product under the Trade Practices Act or other Commonwealth or State Law. Philips Consumer Electronics warrants it's products to the purchaser as follows and subject to the stated conditions. 12 months free service Conditions of warranty 1. All claims for warranty service should be made to your nearest Philips Authorised Service Centre. Reasonable evidence of date of purchase must be provided. 2. This warranty extends only to defects occurring under normal use of the product when operated in accordance with the instructions. 3. Home service within the normal service area of our Philips Authorised Service Centres will be provided for television receivers with screen size 48cm and above. All other products are to be brought or sent to your nearest Philips Authorised Service Centre. 4. This warranty does not cover: a) Mileage or traveling time, pickup or delivery, cost of insurance. b) Service costs arising from failure to correctly adjust the controls of the product or to observe the instructions, or inspections that reveal that the product is in normal working order. c) Product failures caused by misuse, neglect, normal wear and tear, accidental breakage, transit damage, inexpert repairs or modification by unauthorised persons, lightning strikes, vermin infestation or liquid spillage. d) Cleaning of video or audio heads. e) Inadequate receiving antennae. f) Replacement of worn or used batteries, styli or other consumables. The conditions contained in this warranty card replace and override the provisions of the World-Wide Guarantee for Products sold in Australia. Philips Service Branches To contact your nearest Philips Authorised Service Centre call 1300 36 1392 from anywhere in Australia. Sydney Newcastle Perth Melbourne Brisbane Adelaide Hobart Wollongong Canberra Service is provided through 350 accredited service dealers throughout Australia.To find out about your nearest centre, call 1300 36 1392. Please record the following information for your records and keep in a safe place. Model No:.................................................... Serial No:.................................................... Please retain your purchase receipt which is required to claim service under warranty. Philips Consumer Electronics Australia Limited ACN 008 445 743, 3 Figtree Drive Homebush NSW 2140 Version 4, 03/99, FPCP­030 NEW ZEALAND Guarantee and Service for New Zealand Thank-you for purchasing this quality Philips product. Philips New Zealand Ltd guarantees this product against defective components and faulty workmanship for a period of 12 months. Any defect in materials or workmanship occurring within 12 months from the date of purchase subject to the following conditions will be rectified free of charge by the retailer from whom this product was purchased. This guarantee does not prejudice your rights under common law and statute, and is in addition to the normal responsibilities of the retailer and Philips. How to claim Should your Philips product fail within the guarantee period, please return it to the retailer from whom it was purchased. In most cases the retailer will be able to satisfactorily repair or replace the product. However, should the retailer not be able to conclude the matter satisfactorily, or if you have other diffi-culties claiming under this guarantee, please contact Conditions 1. The product must have been purchased in New Zealand. As proof of purchase, retain the original sales docket indicating the date of purchase. 2. The guarantee applies only to faults caused by defective components, or faulty workmanship on the part of the manufacturer. 3. The guarantee does not cover failures caused by misuse, neglect, normal wear and tear, accidental breakage, use on the incorrect voltage, use contrary to operating instructions, or unauthorised modification to the product or repair by an unauthorised technician. The Guarantee Controller Philips New Zealand Ltd. 4 P.O. Box 41.021 Auckland 3 (09) 84 94 160 fax (09) 84 97 858 4. Reasonable evidence (in the form of a sales docket) must be supplied to indicate that the product was purchased no more than 12 months prior to the date of your claim. 5. In the event of a failure, Philips shall be under no liability for any injury, or any loss or damage caused to property or products other than the product under guarantee. English ACCESSORIES 1 x AC mains lead 1 x Remote Control (for AZ1505 model only) TOP AND FRONT PANEL (See 1) 1 VOLUME 3 , 4 - to adjust volume level. 2 DBB (Dynamic Bass Boost) - activates a more vivid bass response. 3 POWER slider - selects TAPE/ RADIO / CD function and also the power off switch (TAPE/ OFF). 4 BAND - selects waveband. 5 0-9: - digit panel CD: - track selection and direct playback; RADIO: - selecting a preset station. 6 PROGRAM CD: - programs tracks and reviews the program; Tuner: - programs preset radio stations. 7 SEARCH , § CD: - searches backward and forward within a track; - skips to the beginning of a current track/ previous/ later track. RADIO: - (down, up) tunes to radio stations. 8 MODE - selects different play modes: e.g. REPEAT or SHUFFLE (random) order. 9 2; - starts or pauses CD playback. 0 9 - to stop playback; - erases a CD program. ! Display - shows the status of the set. @ LIFT TO OPEN - lift here to open CD-tape door. # REMOTE SENSOR - (for AZ1505 model only) infrared sensor for remote control. $ CASSETTE RECORDER keys: RECORD 0 - to start recording. PLAY 2 - to start playback. SEARCH 5 / 6 - fast rewinds/ winds tape. STOP 9 - stops tape. PAUSE ; - pauses playback or recording. CONTROL/POWER SUPPLY BACK PANEL % Telescopic aerial - improves FM reception. ^ p - 3.5 mm stereo headphone socket. Note: The speakers will be muted when headphones are connected to the set. & AC MAINS - inlet for mains lead. * Battery compartment - for 6 batteries, type R14, UM2 or C-cells. ( Voltage selector (some versions only) - adjust to match the local voltage 110/220V before plugging in the set. REMOTE CONTROL (for AZ1505 model only) 1 2 3 4 5 6 7 8 9 VOLUME 3 , 4 - adjusts volume level. SHUFFLE - plays all CD tracks in random order. 2; - starts or pauses CD playback. SEARCH 5 , 6 - searches backwards/ forwards within a track. PRESET + ,- (up, down) - selects a preset radio station. TUNING , § (down, up) - tunes to tuner stations. 9 - to stop playback; - erases a CD program. ¡ , TM - skips to the beginning of a current track previous/ subsequent track. REPEAT - repeats a track /program/ entire CD. POWER SUPPLY IMPORTANT! · Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. · Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set. · When inserting new batteries, do not try to mix old batteries with the new ones. · Batteries contain chemical substances, so they should be disposed of properly. Using AC Power 1. Check if the AC power supply, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service centre. 2. If your set is equipped with a voltage selector, adjust the selector so that it matches with the local mains. 3. Connect the mains lead to the wall socket. 4. To disconnect the mains supply, unplug the set from the wall socket. The type plate is located on the bottom of the set. BASIC FUNCTIONS Switching on and off and selecting function 1. To switch on, adjust the POWER slider to select: CD, RADIO or TAPE function, and operate the respective function controls. 2. To switch off, adjust the POWER slider to select TAPE/OFF and make sure all the cassette keys are released. Note : The DBB setting, tuner presets and the volume will be retained in the set's memory. Adjusting volume and sound (See 2) 1. Press the VOLUME 3 or 4 controls to adjust the volume. 2. Press DBB once or more to select dynamic bass boost on or off. DIGITAL TUNER DIGITAL TUNER Tuning to radio stations 1. Adjust the POWER slider to RADIO. TM tu is displayed briefly and then the radio station frequency, waveband and, if programmed, a preset number are shown. (See 3) 2. Press BAND once or more to select your waveband. 3. Press and hold SEARCH or § until the frequency in the display starts running. TM The radio automatically tunes to a station of sufficient reception. Display shows Srch during automatic tuning. 4. Repeat step 3 if necessary until you find the desired station. To tune to a weak station, press or § briefly and repeatedly until you have found optimal reception. To improve radio reception: · For FM, extend, incline and turn the telescopic aerial. Reduce its length if the signal is too strong. · For MW (AM), the set uses a built-in aerial. Direct this aerial by turning the whole set. Programming radio stations You can store up to a total of 40 radio stations in the memory, manually or automatically (Autostore). Manual programming 1. Tune to your desired station (see Tuning to radio stations). 2. Press PROGRAM to activate programming. TM Display: Pr -- and PROG flashes. 3. Use the digit panel on the set to key in a number, 1-40, to select a preset station. E.g. press 1,1 if you want to store your station as preset 11. (See 4) · Remote control (AZ1505 models only): Press PRESET + / once or more to select a preset station. 4. Press PROGRAM to confirm. 5. Repeat steps 1-4 to store other stations. Note : You can erase a preset station by storing another frequency in its place. CAUTION Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. POWER SUPPLY Whenever convenient, use the AC power supply to conserve battery life. Make sure you remove the power plug from the set and wall outlet before inserting batteries. Batteries (not included) · Insert 6 batteries, type R-14, UM-2 or C-cells, (preferably alkaline) with the correct polarity. (See 7) · Remote control (AZ1505 model only) Insert 2 batteries, type AAA, R03 or UM4 (preferably alkaline). (See 9) - DIGITAL TUNER Autostore Autostore automatically starts programming radio stations from preset 1. Available stations are programmed in order of waveband reception strength: FM, followed by MW (AM). Any previous presets e.g. manually programmed will be erased. · Press PROGRAM for 4 seconds or more to activate autostore programming. TM The display shows AUtO, PROG blinks, followed by the radio station details when stored. After all stations are stored, the first preset station will then automatically play. To listen to a preset station · Direct Easy Access: use the digit panel on the set to key in a number, 1-40, to select a preset station. · Remote control (AZ1505 models only): optionally, press PRESET + ,- to select your preset station. Changing tuning grid (some versions only) In North and South America the frequency step between adjacent channels in the MW (AM) and FM band are 10 KHz and 100 KHz respectively. In the rest of the world this step is 9 KHz and 50 KHz. Usually the frequency step has been preset in the factory for your area. 1. Check that the set is completely switched off. 2. To select 9KHz : Simultaneously, press BAND and SEARCH on the set. 3. Switch the set on to RADIO and then release the controls. · To select 10KHz : Repeat steps 1-3 but in step 2, simultaneously, press BAND and SEARCH § on the set. TM When you tune to radio stations, the display shows tuning in either steps of 9 or 10 KHz. TM All preset stations will be affected and you may need to reprogramme stations. CD PLAYER CD PLAYER Playing a CD This CD player plays Audio Discs including CDRecordables and CD-Rewritables. 1. Adjust the POWER slider to CD. 2. Insert a CD with the printed side facing up and close the door. TM noCd if no CD inserted/ CD dirty, incorrectly inserted or damaged. TM nFCd if you have inserted a non-finalized CDR(W). 3. Press 2; to start playback. TM dAtA if your CD contains non-audio i.e. data files. 4. To pause playback press 2;. Press 2; again to resume play. TM D ...