|
Need help using a product?
|
|
|
|
User manual PHILIPS HQ7815
Diplodocs help download the user guide PHILIPS HQ7815 Electric Shaver.
This product, although classified under the brand PHILIPS, may have been manufactured by GEMINI INDUSTRIES, NORELCO, RADIOLA after mergers, acquisitions, or a change in name.
Manual abstract: user guide PHILIPS HQ7815
Detailed instructions for use are in the User's Guide. ENGLISH 4 BAHASA MELAYU 15 INDONESIA 26 TI"NG VIT 37 ÀÒÉÒä·Â 47 56 67 76
HQ7815
4
ENGLISH
Important
Read these instructions for use carefully before using the appliance and save them for future reference. Only use the powerplug supplied. The powerplug transforms 100-240 volts to a safe low voltage of less than 24 volts. The powerplug contains a transformer. Do not cut off the powerplug to replace it with another plug, as this will cause a hazardous situation. Do not use a damaged mains cord. If the powerplug is damaged, always have it replaced by one of the original type in order to avoid a hazard. Make sure the powerplug does not get wet. Charge, store and use the appliance at a temperature between 5cC and 35cC. Do not recharge the shaver in a closed pouch. The appliance complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. Always unplug the shaver before cleaning it under the tap.
C C
ENGLISH
5
Charging
Make sure the appliance is switched off before you start charging it. When you charge the shaver for the first time or after a long period of disuse, let it charge continuously for 12 hours. Charging normally takes approx. 8 hours. You can also shave without charging by connecting the shaver to the mains. Do not leave the appliance connected to the mains for more than 24 hours.
Charge indications Charging
you empty C As soon asgreenstart charging theon. shaver, the pilot light goes
Charging the appliance
Charge the appliance when the motor stops or starts running slower. Do not recharge the shaver in a closed pouch.
C
1 2
Put the appliance plug in the shaver. Put the powerplug in the wall socket.
6
ENGLISH
3 Remove the powerplug from the wall socket and pull the appliance plug out of the shaver when the batteries have been fully charged.
Cordless shaving time
A fully charged shaver has a cordless shaving time of up to 45 minutes.
Using the appliance Shaving
1 Switch the shaver on by pressing the on/off button once.
C
Move the shaving heads quickly over your skin, making both straight and circular movements. Shaving on a dry face gives the best results. Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. 3 Switch the shaver off by pressing the on/off button once. Put the protection cap on the shaver every time you have used it, to prevent damage.
2
C
4
ENGLISH
7
Trimming
For grooming sideburns and moustache.
C
Open the trimmer by pushing the slide upwards. The trimmer can be activated while the motor is running.
1
Cleaning and maintenance
Regular cleaning guarantees better shaving performance. The easiest and most hygienic way to clean the appliance is to rinse the shaving unit and the hair chamber with hot water every time you have used the shaver. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. the C For extra thorough cleaning,typePhilips Action Clean (shaving head cleaner, HQ100) is
B
available.Ask your Philips dealer for information. The Philips Action Clean may not be available in all countries. Contact the Customer Care Centre in your country about the availability of this accessory.
You can also clean the shaver in the following way:
8
ENGLISH
Every day: shaving unit and hair chamber
1
2
Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Press the release button (1) and open the shaving unit (2). Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time.
1
C C
2 3
Close the shaving unit and shake off excess water. Never dry the shaving unit with a towel or tissue as this may damage the shaving heads.
4
C
Open the shaving unit again and leave it open to let the appliance dry completely. You can also clean the hair chamber without water by using the brush supplied.
5
Every six months: shaving heads
2 1
C
1
Open the shaving unit, turn the wheel anticlockwise (1) and remove the retaining frame (2).
ENGLISH
9
C
Clean the cutters and guards with the brush supplied. Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. 3 Put the shaving heads back into the shaving unit. Put the retaining frame back into the shaving unit, press the wheel (1) and turn it clockwise (2) (also see chapter 'Replacement'). Close the shaving unit.
2
4
Trimmer
Clean the trimmer every time you have used it. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Clean the trimmer with the brush supplied. Lubricate the trimmer teeth with a drop of sewing machine oil every six months.
C C
2 3
10
ENGLISH
Storage
C Put the protection cap on the shaver to prevent damage.
Replacement
The appliance can be stored in the pouch supplied (HQ7815 only).
Replace the shaving heads every two years for optimal shaving results. Replace damaged or worn shaving heads with HQ6 Philips Quadra shaving heads only. 1
2
Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Press the release button (1) and open the shaving unit (2). Turn the wheel anticlockwise (1) and remove the retaining frame (2).
1
C
2 1
2 3
C C
Remove the shaving heads and place new ones in the shaving unit in such a way that the parts with the small holes point towards the centre of the shaving unit. Make sure that the projections of the shaving heads fit exactly into the recesses.
4
ENGLISH
11
1
C
5
Put the retaining frame back into the shaving unit, press the wheel (1) and turn it clockwise (2). Close the shaving unit.
2
6
Accessories
The following accessories are available: - HQ8000 powerplug. - HQ6 Philips Quadra shaving heads. - HQ100 Philips Action Clean (shaving head cleaner). - HQ101 Philips Action Clean refill (shaving head cleaning liquid). - HQ110 Philips shaving head cleaner (shaving head cleaning spray).
Environment
throw the away with the C Do not household appliancethe end of its life, normal waste at but hand it in at an official collection point for recycling. By doing this you will help to preserve the environment.
Disposal of the batteries
The built-in rechargeable battery contains substances that may pollute the environment. Always remove the battery before discarding the appliance or handing it in at an official collection point. Dispose of the battery at an official
12
ENGLISH
collection point for batteries. If you have trouble removing the battery, you can also take the appliance to a Philips service centre, which will remove the battery for you and will dispose of it in an environmentally safe way. Only remove the batteries if they are completely empty. 1 Remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Let the shaver run until it stops, open the trimmer, undo the screws and open the shaver.
C
2
3 Remove the batteries. Do not connect the shaver to the mains again after the batteries have been removed.
Guarantee & service
If you need information or if you have a problem, please visit the Philips Web site at www.philips.com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV.
ENGLISH
13
Troubleshooting
1 Reduced shaving performance Cause 1: the shaving heads are dirty. B The shaver has not been rinsed long enough or the water used was not hot enough.
B
Clean the shaver thoroughly before you continue shaving (see chapter 'Cleaning and maintenance'). B Cause 2: long hairs are obstructing the shaving heads. Clean the cutters and guards with the brush supplied. See chapter 'Cleaning and maintenance', section 'Every six months: shaving heads'. B Cause 3: the shaving heads are damaged or worn. Replace the shaving heads. See chapter 'Replacement'. 2
B
The shaver does not work when the on/off button is pressed Cause 1: the batteries are empty.
B
Recharge the batteries. See chapter 'Charging'. Cause 2: the shaver is not connected to the mains. Put the powerplug in the wall socket.
B
3 The shaving unit has come off the shaver Cause: the shaving unit has not been placed correctly.
14
ENGLISH
unit becomes detached from the C If the shaving whether the hinge spring is still shaver, check properly attached, i.e. has not come loose and does not show any cracks or damage. If the hinge spring is still properly attached, the shaving unit can be easily put back on the shaver again. However, if the hinge spring has come loose, is cracked or damaged, please contact your Philips dealer or the nearest Philips service centre to avoid damage to your shaver.
BAHASA MELAYU
15
Penting
Baca arahan penggunaan ini dengan teliti sebelum menggunakan perkakas dan simpan untuk rujukan di masa depan. Hanya gunakan plag kuasa yang dibekalkan. Plag kuasa mengubah 100-240 volt kepada voltan rendah dan selamat tidak melebihi 24 volt. Plag kuasa mengandungi sebuah transformer. Jangan potong plag kuasa untuk menggantikannya dengan plag yang lain kerana ini akan menimbulkan situasi berbahaya. Jangan gunakan kord yang rosak. Jika plag kuasa rosak, sentiasa gantikan dengan jenis tulen bagi mengelakkan bahaya. Pastikan plag kuasa tidak kena basah. Cas, simpan dan gunakan perkakas pada suhu antara 5cC dan 35cC. Jangan mengecas semula pencukur di dalam pau tertutup. Perkakas mematuhi peraturan keselamatan antarabangsa IEC yang diluluskan dan boleh dibersihkan dengan selamat di bawah pili air. Berhati-hati dengan air panas. Sentiasa periksa agar air tidak begitu panas, untuk mengelakkan tangan anda daripada kelecuran. Sentiasa cabut plag daripada pencukur sebelum membersihkannya di bawah pili air.
C C
16
BAHASA MELAYU
Mengecas
Pastikan perkakas dimatikan sebelum dicas. Apabila anda mengecas pencukur bagi kali pertama setelah lama tidak digunakan, biarkan ia dicas berterusan selama 4 jam. Pengecasan biasanya mengambil masa selama lebih kurang 1 jam. Anda juga dapat bercukur tanpa mengecas dengan menyambungkan pencukur kepada sesalur kuasa utama. Jangan biarkan perkakas dipasang pada sesalur kuasa selama lebih daripada 24 jam.
Arahan cas Mengecas
anda pencukur C Sebaik sahaja lampumula mengecas akan yang kosong, panduan hijau menyala.
Mengecas perkakas
Cas perkakas apabila motor berhenti atau menjadi semakin lambat. Jangan mengecas semula pencukur di dalam pau tertutup.
C
1
Pasangkan plag perkakas pada alat pencukur.
BAHASA MELAYU
2 3 Pasangkan plag kuasa ke soket dinding.
17
Cabutkan plag kuasa dari soket dinding dan tarik keluar plag perkakas dari pencukur apabila bateri sudah dicas sepenuhnya.
Masa pencukuran tanpa kord
Pencukur yang dicas penuh mempunyai masa pencukuran tanpa kord sehingga kira-kira 45 minit.
Menggunakan perkakas Pencukuran
1 Hidupkan alat pencukur dengan menekan butang hidup/mati sekali.
C
Gerakkan kepala pencukur denagn gerakan lurus dan membulat di atas permukaan kulit dengan pantas. Hasil pencukuran yang terbaik akan terhasil jika muka anda kering. Kulit anda mungkin memerlukan 2 atau 3 minggu untuk membiasakan diri dengan sistem Philips. 3 Matikan pencukur dengan menekan butang hidup/mati sekali. Pasang semula penutup pelindung pada pencukur setelah setiap penggunaan untuk mengelakkan kerosakan.
2
C
4
18
BAHASA MELAYU
Perapian
Untuk merapikan jambang dan kumis kemas. 1 C PerapiBuka perapi dengan menolak selak ke atas. dapat dihidupkan semasa motor berjalan.
Pembersihan dan penyenggaraan
Membersih alat pencukur dengan kerapkali menjamin prestasi pencukuran terbaik. Cara paling senang dan bersih untuk mencuci perkakas adalah dengan membilas dengan air panas unit mencukur dan ruang menyimpan rambut setiap kali setelah anda menggunakan alat pencukur tersebut. Berhati-hati dengan air panas. Sentiasa periksa agar air tidak begitu panas, untuk mengelakkan tangan anda daripada kelecuran.
C Untuk pembersihan yang lebih menyeluruh, pembersih Tindakan Bersih Philips (pembersih
B
kepala pencukur, jenis HQ100) tersedia. Bertanya kepada dengan penjual Philips anda untuk dapatkan maklumat. Pembersih Tindakan Bersih Philips mungkin tidak terdapat di semua negara. Hubungi Pusat Khidmat Pelanggan di negeri anda untuk mengetahui tentang ketersediaan aksesori ini.
Anda juga boleh membersihkan pencukur dengan cara yang berikut:
BAHASA MELAYU
19
Setiap hari: unit pencukur dan ruang rambut
1
2
Matikan alat pencukur, cabut plag kuasa dari soket dinding dan cabut plag perkakas dari pencukur. ...
|