3 ENGLISH 4 BAHASA MELAYU 15 BAHASA INDONESIA 26 TI"NG VIT 37 ÀÒÉÒä·Â 47 56 67 76 HQ7825 4 ENGLISH Important Read these instructions for use carefully before using the appliance and save them for future reference. Only use the powerplug supplied to charge the appliance. The powerplug transforms 100-240 volts to a safe low voltage of less than 24 volts. Only use the powerplug that comes with the appliance to guarantee safe transformation. The powerplug contains a transformer. Do not cut off the powerplug to replace it with another plug, as this will cause a hazardous situation. If the powerplug is damaged, always have it replaced by one of the original type in order to avoid a hazard. Make sure the powerplug does not get wet. Charge, store and use the appliance at a temperature between 5cC and 35cC. Do not recharge the shaver in a closed pouch. The appliance complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. Always unplug the shaver before cleaning it under the tap. C C ENGLISH 5 Charging When you charge the shaver for the first time or after a long period of disuse, leave it to charge continuously for 4 hours. Charging normally takes approx. 1 hour. Do not leave the appliance connected to the mains for more than 24 hours. You can also shave without charging by connecting the shaver to the mains. Charge indications Charging you empty C As soon asgreenstart charging theon. shaver, the pilot light goes Batteries fully charged batteries have C When thepilot light startsbeen fully charged, the green blinking. 6 ENGLISH Charging the appliance Do not recharge the shaver in a closed pouch. C 1 2 3 Put the appliance plug in the shaver. Put the powerplug in the wall socket. Remove the powerplug from the wall socket and pull the appliance plug out of the shaver when the batteries have been fully charged. Cordless shaving time A fully charged shaver has a cordless shaving time of up to 45 minutes. Using the appliance Shaving 1 Switch the shaver on by pressing the on/off button once. C Move the shaving heads quickly over your skin, making both straight and circular movements. Shaving on a dry face gives the best results. Your skin may need 2 or 3 weeks to get accustomed to the Philishave system. 3 Switch the shaver off by pressing the on/off button once. 2 ENGLISH 7 C 4 Put the protection cap on the shaver every time you have used it, to prevent damage. Trimming For grooming sideburns and moustache. C Open the trimmer by pushing the slide upwards. The trimmer can be activated while the motor is running. 1 Cleaning and maintenance Regular cleaning guarantees better shaving performance. The easiest and most hygienic way to clean the appliance is to rinse the shaving unit and the hair chamber with hot water every time you have used the shaver. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. C For easy and optimal cleaning, the Philishave Action Clean (shaving-head cleaner, type HQ100) is available.Ask your Philishave dealer for information. 8 ENGLISH B The Philishave Action Clean may not be available in all countries. Contact the Customer Care Centre in your country about the availability of this accessory. You can also clean the shaver in the following way: Every day: shaving unit and hair chamber When you clean the appliance, it is not necessary to take the shaving heads (cutters and guards) apart. If you want to take them apart, be sure not to mix up the cutters and guards, since grinding of the cutters in the guards only guarantees optimal performance for each matching set. If you accidentally mix up the sets, it could take several weeks before optimal shaving performance is restored. 1 2 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Press the release button (1) and open the shaving unit (2). Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time. Close the shaving unit and shake off excess water. 1 C C 2 3 4 ENGLISH Never dry the shaving unit with a towel or tissue as this may damage the shaving heads. 9 C Open the shaving unit again and leave it open to let the appliance dry completely. You can also clean the hair chamber without water by using the brush supplied. 5 Trimmer Clean the trimmer every time you have used it. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Clean the trimmer with the brush supplied. Lubricate the trimmer teeth with a drop of sewing machine oil every six months. C C 2 3 Storage C Put the protection cap on the shaver to prevent damage. The appliance can be stored in the pouch supplied. 10 ENGLISH Replacement Replace the shaving heads every two years for optimal shaving results. Replace damaged or worn shaving heads with Philishave HQ6 Quadra shaving heads only. 1 2 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Press the release button (1) to open the shaving unit (2). Turn the wheel anti-clockwise (1) and remove the retaining frame (2). 1 C 2 1 2 3 C C Remove the shaving heads and place the new ones in the shaving unit in such a way that the parts with the small holes point towards the centre of the shaving unit. Make sure that the projections of the shaving heads fit exactly into the recesses. 5 Put the retaining frame back into the shaving unit, press the wheel (1) and turn it clockwise (2). 4 1 C 2 ENGLISH 11 Accessories The following accessories are available: - HQ6 Quadra Philishave shaving heads. - HQ8000 powerplug. - HQ100 Philishave Action Clean (shaving head cleaner). - HQ101 Philishave Action Clean refill (shaving head cleaning liquid). - HQ110 Philishave shaving head cleaner (shaving head cleaning spray). Guarantee & service If you need information or if you have a problem, please visit the Philips Web site at www.philips.com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. Environment The built-in rechargeable batteries contain substances that may pollute the environment. Disposal of batteries Remove the batteries when you discard the appliance. Do not throw the batteries away with the normal household waste, but hand them in at an official collection point.You can also take the 12 ENGLISH appliance to a Philips service centre, which will remove the batteries for you and will dispose of them in an environmentally safe way. Only remove the batteries if they are completely empty. 1 Remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Let the shaver run until it stops, open the trimmer, undo the screws and open the shaver. Remove the batteries. C 2 3 Do not connect the shaver to the mains again after the batteries have been removed. Troubleshooting 1 B B Reduced shaving performance Cause 1: the shaving heads are dirty. The shaver has not been rinsed long enough or the water used was not hot enough. Clean the shaver thoroughly before you continue shaving (see chapter 'Cleaning'). B Cause 2: long hairs are obstructing the shaving heads. ENGLISH 13 2 1 the wheel C Open the shaving unit, turnthe retaininganticlockwise (1) and remove frame (2). the and guards. C Cleancleancuttersthan one cutter and guard at Do not more a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. Remove the hairs with the brush supplied. Put the shaving heads back into the shaving unit, put the retaining frame back into the shaving unit, press the wheel and turn it clockwise. B Cause 3: shaving heads are damaged or worn. Remove the retaining frame. Remove the old shaving heads from the shaving unit and replace them with new ones Damaged or worn shaving heads (cutters and guards) must only be replaced with the original Philishave HQ6 Quadra shaving heads. Put the retaining frame back into the shaving unit, press the wheel and turn it clockwise. 2 The shaver does not work when the ON/OFF button is pressed 14 ENGLISH B Cause: the batteries are empty. Recharge the batteries. See chapter 'Charging'. 3 Shaving unit has come off shaver unit becomes detached from the C If the shaving whether the hinge spring is still shaver, check properly attached, i.e. has not come loose and does not show any cracks or damage. If the hinge spring is still properly attached, the shaving unit can be easily put back on the shaver again. However, if the hinge spring has come loose, is cracked or damaged, please contact your Philips dealer or the nearest Philips service centre to avoid damage to your shaver. BAHASA MELAYU 15 Penting Baca arahan penggunaan ini dengan teliti sebelum menggunakan peralatan dan simpan untuk rujukan di masa depan. Hanya gunakan plag kuasa yang disediakan untuk mengecas peralatan. Plag kuasa mengubah 100-240 volt kepada voltan rendah dan selamat tidak melebihi 24 volt. Hanya guna plag kuasa yang datang dengan peralatan untuk menjaminkan pengubahan kuasa yang selamat. Plag kuasa mengandungi sebuah transformer. Jangan potong plag kuasa untuk menggantikannya dengan plag yang lain kerana ini akan menimbulkan situasi berbahaya. Jika plag kuasa rosak, gantikan dengan penggati jenis tulen untuk mengelakkan daripada kemudaratan. Pastikan plag kuasa tidak kena basah. Cas, simpan dan gunakan peralatan pada suhu di antara 5cC dan 35cC. Jangan mengecas semula pencukur di dalam pau tertutup. Peralatan ini mematuhi peraturan keselamatan antarabangsa IEC yang diluluskan dan selamat dibersihkan dengan air paip. Berhati-hati dengan air panas. Sentiasa periksa agar air tidak begitu panas, untuk mengelakkan tangan anda daripada kelecuran. Sentiasa cabut plag daripada pencukur sebelum membersihkannya di bawah pili air. C C 16 BAHASA MELAYU Mengecas Jika mengecas alat pencukur buat pertama kali atau setelah telah lama tidak digunakan, biarkan ia dicas selama 4 jam secara berterusan. Mengecas alat pencukur biasanya mengambil masa lebih kurang 1 jam. Jangan biarkan peralatan dipasang pada punca kuasa utama lebih daripada 24 jam. Anda juga dapat bercukur tanpa mengecas, dengan menyambung pencukur kepada punca kuasa utama. Arahan cas Mengecas anda pencukur C Sebaik sahaja lampumula mengecas akan yang kosong, panduan hijau menyala. Bateri dicas penuh sudah tercas C Apabila bateri akan berkelip.sepenuhnya, lampu panduan hijau BAHASA MELAYU 17 Mengecas peralatan Jangan mengecas apabila alat pencukur berada di dalam uncang tertutup. C 1 2 3 Pasangkan plag peralatan pada alat pencukur. Pasangkan plag kuasa ke soket dinding. Cabutkan plag kuasa dari soket dinding dan tarik keluar plag peralatan dari pencukur apabila bateri sudah tercas dengan sepenuhnya. Masa pencukuran tanpa kord Pencukur yang dicas penuh ada masa pencukuran tanpa kord sehingga kira-kira 45 minit. Menggunakan peralatan Pencukuran 1 Hidupkan alat pencukur dengan menekan butang hidup/mati sekali. C Gerakkan kepala pencukur dengan gerakan lurus dan membulat di atas permukaan kulit dengan pantas. Hasil pencukuran yang terbaik akan terhasil jika muka anda kering. 2 18 BAHASA MELAYU Kulit anda mungkin memerlukan 2 atau 3 minggu untuk membiasakan diri dengan sistem Philishave. 3 Matikan pencukur dengan menekan butang hidup/mati sekali. Pasang semula penutup pelindung pada pencukur selepas setiap penggunaan untuk mengelakkan kerosakan. C 4 Perapian Untuk jambang dan kumis kemas. 1 C PerapiBuka perapi dengan menekan selak ke atas. dapat dihidupkan semasa motor berjalan. Pembersihan dan penyenggaraan Membersih alat pencukur dengan kerapkali menjamin prestasi pencukuran terbaik. Cara yang senang dan bersih untuk mencuci peralatan adalah membilas unit mencukur dan ruangan menyimpan rambut dengan air panas setiap kali setelah anda menggunakan alat pencukur tersebut. Berhati-hati dengan air panas. Sentiasa periksa agar air tidak begitu panas, untuk mengelakkan tangan anda daripada kelecuran. C Philishave Action Clean (bahan pembersih kepala-kepala pencukur, jenis HQ100) BAHASA MELAYU 19 B terdapat untuk pembersihan yang mudah dan optimum. Untuk mendapatkan maklumat tentang ini, sila hubungi peniaga Philishave. Philishave Action Clean mungkin tidak terdapat di semua negeri. Hubungi Pusat Khidmat Pelanggan di negeri anda untuk mengetahui sama aksesori ini boleh didapati. Anda juga dapat membersihkan pencukur dengan ca ...