ENGLISH 4 DEUTSCH 15 FRANÇAIS 27 NEDERLANDS 39 ESPAÑOL 51 ITALIANO 63 PORTUGUÊS 75 TÜRKÇE 87 á«Hô©dG 106 HQ7850 4 ENGLISH Important Read these instructions for use carefully before using the appliance and save them for future reference. Only use the powerplug supplied. The powerplug transforms 100-240 volts to a safe low voltage of less than 24 volts. The powerplug contains a transformer. Do not cut off the powerplug to replace it with another plug, as this will cause a hazardous situation. Do not use a damaged powerplug. If the powerplug is damaged, always have it replaced by one of the original type in order to avoid a hazard. Make sure the powerplug does not get wet. Charge, store and use the appliance at a temperature between 5cC and 35cC. Do not recharge the shaver in a closed pouch. The appliance complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. Always unplug the shaver before cleaning it under the tap. C C ENGLISH 5 Charging Make sure the appliance is switched off before you start charging it. When you charge the shaver for the first time or after a long period of disuse, let it charge continuously for 4 hours. Charging normally takes approx. 1 hour. You can also shave without charging by connecting the shaver to the mains. Do not leave the appliance connected to the mains for more than 24 hours. Charge indications Charging you empty C As soon asgreenstart charging theon. shaver, the pilot light goes Batteries fully charged batteries have C When thepilot light startsbeen fully charged, the green blinking. 6 ENGLISH Batteries running low batteries are C When thegoes on.Whenrunning low, the red pilot light you switch the shaver off, the red pilot light blinks for 4 seconds. Charging the appliance Charge the appliance when the red pilot light blinks. Do not recharge the shaver in a closed pouch. C 1 2 3 Put the appliance plug in the shaver. Put the powerplug in the wall socket. Remove the powerplug from the wall socket and pull the appliance plug out of the shaver when the batteries have been fully charged. Cordless shaving time A fully charged shaver has a cordless shaving time of up to 70 minutes. ENGLISH 7 Using the appliance Shaving 1 Switch the shaver on by pressing the on/off button once. C Move the shaving heads quickly over your skin, making both straight and circular movements. Shaving on a dry face gives the best results. Your skin may need 2 or 3 weeks to get accustomed to the Philips system. 3 Switch the shaver off by pressing the on/off button once. Put the protection cap on the shaver every time you have used it, to prevent damage. 2 C 4 Trimming For grooming sideburns and moustache. C Open the trimmer by pushing the slide upwards. The trimmer can be activated while the motor is running. 1 Cleaning and maintenance Regular cleaning guarantees better shaving performance. 8 ENGLISH The easiest and most hygienic way to clean the appliance is to rinse the shaving unit and the hair chamber with hot water every time you have used the shaver. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. the C For extra thorough cleaning,typePhilips Action Clean (shaving head cleaner, HQ100) is B available.Ask your Philips dealer for information. The Philips Action Clean may not be available in all countries. Contact the Customer Care Centre in your country about the availability of this accessory. You can also clean the shaver in the following way: Every day: shaving unit and hair chamber 1 2 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Press the release button (1) and open the shaving unit (2). Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time. 1 C C 2 3 ENGLISH 4 9 Close the shaving unit and shake off excess water. Never dry the shaving unit with a towel or tissue as this may damage the shaving heads. C Open the shaving unit again and leave it open to let the appliance dry completely. You can also clean the hair chamber without water by using the brush supplied. 5 Every six months: shaving heads 2 1 C 1 Open the shaving unit, turn the wheel anticlockwise (1) and remove the retaining frame (2). C Clean the cutters and guards with the brush supplied. Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. 3 Put the shaving heads back into the shaving unit. Put the retaining frame back into the shaving unit, press the wheel (1) and turn it clockwise (2) (also see chapter 'Replacement'). Close the shaving unit. 2 4 10 ENGLISH Trimmer Clean the trimmer every time you have used it. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Clean the trimmer with the brush supplied. Lubricate the trimmer teeth with a drop of sewing machine oil every six months. C C 2 3 Storage C Put the protection cap on the shaver to prevent damage. Replacement The appliance can be stored in the pouch supplied. Replace the shaving heads every two years for optimal shaving results. Replace damaged or worn shaving heads with HQ6 Philips Quadra shaving heads only. ENGLISH 1 2 11 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Press the release button (1) and open the shaving unit (2). Turn the wheel anticlockwise (1) and remove the retaining frame (2). 1 C 2 1 2 3 C C Remove the shaving heads and place new ones in the shaving unit in such a way that the parts with the small holes point towards the centre of the shaving unit. Make sure that the projections of the shaving heads fit exactly into the recesses. 5 Put the retaining frame back into the shaving unit, press the wheel (1) and turn it clockwise (2). Close the shaving unit. 4 1 C 2 6 Accessories The following accessories are available: - HQ8000 powerplug. - HQ6 Philips Quadra shaving heads. - HQ100 Philips Action Clean (shaving head cleaner). 12 ENGLISH - HQ101 Philips Action Clean refill (shaving head cleaning liquid). - HQ110 Philips shaving head cleaner (shaving head cleaning spray). Environment throw the away with the C Do not household appliancethe end of its life, normal waste at but hand it in at an official collection point for recycling. By doing this you will help to preserve the environment. Disposal of the batteries The built-in rechargeable battery contains substances that may pollute the environment. Always remove the battery before discarding the appliance or handing it in at an official collection point. Dispose of the battery at an official collection point for batteries. If you have trouble removing the battery, you can also take the appliance to a Philips service centre, which will remove the battery for you and will dispose of it in an environmentally safe way. Only remove the batteries if they are completely empty. 1 Remove the powerplug from the wall socket and pull the appliance plug out of the shaver. ENGLISH 13 C 2 Let the shaver run until it stops, open the trimmer, undo the screws and open the shaver. 3 Remove the batteries. Do not connect the shaver to the mains again after the batteries have been removed. Guarantee & service If you need information or if you have a problem, please visit the Philips Web site at www.philips.com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. Troubleshooting 1 Reduced shaving performance Cause 1: the shaving heads are dirty. B The shaver has not been rinsed long enough or the water used was not hot enough. B Clean the shaver thoroughly before you continue shaving (see chapter 'Cleaning and maintenance'). B Cause 2: long hairs are obstructing the shaving heads. 14 ENGLISH Clean the cutters and guards with the brush supplied. See chapter 'Cleaning and maintenance', section 'Every six months: shaving heads'. B Cause 3: the shaving heads are damaged or worn. Replace the shaving heads. See chapter 'Replacement'. 2 B The shaver does not work when the on/off button is pressed Cause 1: the batteries are empty. B Recharge the batteries. See chapter 'Charging'. Cause 2: the shaver is not connected to the mains. Put the powerplug in the wall socket. B 3 The shaving unit has come off the shaver Cause: the shaving unit has not been placed correctly. unit becomes detached from the C If the shaving whether the hinge spring is still shaver, check properly attached, i.e. has not come loose and does not show any cracks or damage. If the hinge spring is still properly attached, the shaving unit can be easily put back on the shaver again. However, if the hinge spring has come loose, is cracked or damaged, please contact your Philips dealer or the nearest Philips service centre to avoid damage to your shaver. DEUTSCH 15 Wichtig Lesen Sie diese Bedienungsanleitung vor dem ersten Gebrauch des Geräts gründlich durch und bewahren Sie sie zur späteren Einsichtnahme auf. Verwenden Sie mit diesem Gerät ausschließlich das mitgelieferte Netzteil. Das Netzteil wandelt Netzspannungen von 100 bis 240 Volt in eine sichere Betriebsspannung von unter 24 Volt um. Das Netzteil enthält einen Transformator. Ersetzen Sie das Netzteil keinesfalls durch einen anderen Stecker, da dies den Benutzer gefährdet. Benutzen Sie keinesfalls ein beschädigtes Netzteil. Ist das Netzteil defekt, darf es nur durch ein Original-Ersatznetzteil ausgetauscht werden, um Gefährdungen zu vermeiden. Achten Sie darauf, dass das Netzteil nicht nass wird. Laden und benutzen Sie das Gerät bei Temperaturen zwischen 5cC und 35cC. Bewahren Sie es auch in diesem Temperaturbereich auf. Nehmen Sie den Rasierer zum Laden aus der Tasche. Das Gerät entspricht den internationalen IEC Sicherheitsvorschriften und kann ohne Bedenken unter fließendem Wasser gereinigt werden. Gehen Sie vorsichtig mit heißem Wasser um. Achten Sie darauf, dass das Wasser nicht zu heiß ist und Sie sich nicht die Hände verbrühen. C C 16 DEUTSCH Ziehen Sie stets das Netzteil aus der Steckdose, bevor Sie den Rasierer unter fließendem Wasser reinigen. Aufladen Das Gerät muss ausgeschaltet sein, wenn Sie mit dem Laden beginnen. Beim erstmaligen Laden, und wenn der Rasierer längere Zeit nicht benutzt wurde, beträgt die Ladedauer 4 Stunden. Normalerweise sind die Akkus nach ungefähr 1 Stunde voll aufgeladen. Sie können sich auch bei leeren Akkus rasieren, indem Sie den Rasierer an das Stromnetz anschließen. Lassen Sie das Gerät nicht länger als 24 Stunden ununterbrochen am Netz. Ladeanzeigen Aufladen mit dem Aufladen der Akkus C Sobald Sieleuchtet die grüne Kontrolllampe. beginnen, DEUTSCH 17 Akkus voll aufgeladen die Akkus voll C Wenn Kontrolllampe.geladen sind, blinkt die grüne Die Energie geht zur Neige Kontrolllampe leuchtet, C Die rotezur Neige geht. Sobald Siewenn die Energie den Rasierer ausschalten, blinkt die rote Kontrolllampe 4 Sekunden lang. Laden des Geräts Laden Sie das Gerät, wenn die rote Kontrolllampe blinkt. Laden Sie den Rasierer nicht in einer geschlossenen Tasche auf. C 1 2 3 Stecken Sie den Gerätestecker in den Rasierer. Stecken Sie das Netzteil in die Steckdose. Ziehen Sie das Netzteil aus der Steckdose und den Gerätestecker vom Rasierer, sobald die Akkus voll geladen sind. 18 DEUTSCH Kabellose Rasierzeit Mit voll aufgeladenen Akkus können Sie sich ca. 70 Minuten rasieren. Benutzung des Geräts Rasieren 1 Schalten Sie das Gerät ein, indem Sie den Ein-/Ausschalter drücken. C Führen Sie die Scherköpfe mit geraden und kreisenden Bewegungen zügig über die Haut. Die beste Rasur erzielen Sie bei trockener Haut. Es kann 2 bis 3 Wochen dauern, bis sich Ihre Haut an das Philips Schersystem gewöhnt hat. 3 Schalten Sie das Gerät aus, indem Sie den Ein-/Ausschalter drücken. Setzen Sie die Schutzkappe nach jedem Gebrauch auf den Rasierer, um Beschädigungen zu vermeiden. 2 C 4 Der Langhaarschneider Zum Trimmen von Koteletten und Schnurrbart. C Schieben Sie den Schiebeschalter aufwärts, um den Langhaarschneider zu öffnen. Der Langhaarschneider lässt sich bei laufendem Motor aktivieren. 1 DEUTSCH 19 Reinigung und Wartung Regelmäßige Reinigung sorgt für bessere Rasur und verlängert die Nutzungsdauer des Geräts. Am einfachsten und hygienischsten reinigen Sie den Rasierer, indem Sie Scherein ...